Photonic crystal beam splitters

In this work, the beam splitter with two input ports and two output ports in two-dimensional photonic crystals is studied through the finite-difference time-domain method. The beam splitter consists of two orthogonally cross line defects. The diameter of the two diagonal air holes at the intersection of the two line defects was modified. The input light can be identically divided into the two output ports. The beam splitters can be applied in the photonic crystal Mach-Zehnder interferometers or photonic crystal optical switches.     

Imprint lithography of pyramidal photonic pillars using hydrazine etching

An inexpensive method to produce a pyramidal-type 2D photonic structures in the silicon substrate was proposed. The method is based on the combination of imprint lithography and wet Si1 0 0 etching in water solution of hydrazine, which etches 1 1 1 faces much more slowly than others. Thermally grown SiO₂ mask for the hydrazine etching was used, because single Al mask cannot be well bonded to the substrate and tends to peel during the etching. It was revealed that transmittance in the infrared spectrum region of the patterned silicon decreases by about five times compared with that of flat silicon substrate and this decrease is almost independent of the angle of the incident beam. In the infrared region, decrease of transmittance of the patterned samples is directly proportional to the wave number. The shape of formed pyramids has strong influence on the transmittance. Decrease of the transmittance is much more rapid and larger in the case of sharpless pillars.     

X波段盘圈加速结构热阴极微波电子枪的研究

介绍了采用盘圈(DAW)加速结构在11.43GHz下研制的热阴极微波电子枪注入器，分析了注入器中DAW加速结构支撑杆对于微波特性的影响以及加速结构中的模式重叠问题. 针对该结构的强腔间耦合以及次临近耦合不能忽略的特点，对其调谐方法进行了分析研究.给出了该长腔链热阴极微波电子枪注入器的物理设计及粒子动力学计算结果，电子能量为5—6MeV，脉冲流强为40mA，电子束发射度为3.4πmm.mrad. 该微波电子枪的加工焊接已经完成，文中给出了其冷测结果.     

Decay distribution of spontaneous emission from atoms in one-dimensional photonic crystal

Spontaneous emission behavior from atoms (or molecules) in one-dimensional photonic crystal with a defect is investigated. Taken all the TE and TM modes into account, the normalized spontaneous emission rate of the atom is calculated as a function of the position of the atom in the crystal. Results for both nonabsorbing dielectric structure and absorbing dielectric structure are presented. With the increase of the thickness of the defect in which the atoms are embedded, the oscillations of the spontaneous emission rate versus the position of the atom become dense and the lifetime distribution becomes narrow and sharp. The PC effect may lead to the coexistence of both accelerated and inhibited decay processes.     

空间电荷主导电子束的纵向聚焦设计

在空间电荷主导电子束研究中,纵向聚焦非常重要,在输运过程中由于强空间电荷力的影响,束团将很快变长并崩溃,马里兰大学的电子环设计用于方形束团和抛物线形束团的研究,环中需要用三个感应腔对束团进行纵向聚焦.文中首先介绍了方形束团和抛物线形束团的纵向束流动力学,推导了两种束团纵向聚焦所需要的5MHz重复率高压脉冲波形,并给出了实现纵向聚焦的感应腔设计及其特殊要求.     

Laser nanosources based on planar photonic crystals as new platforms for nanophotonic devices

Two-dimensional photonic crystal lasers have been fabricated on III–V semiconductor slabs. Tuning of the spontaneous emission in micro and nanocavities has been achieved by accurate control of the slab thickness. Different structures, some of them of new application to photonic crystal lasers, have been fabricated like the Suzuki-phase or the coupled-cavity ring-like resonators. Laser emission has been obtained by pulsed optical pumping. Optical characterization of the lasing modes have been performed showing one or more laser peaks centred around 1.55 μm. Far field characterization of the emission pattern has been realized showing different patterns depending on the geometrical shape of the structures. These kinds of devices may be used as efficient nanolaser sources for optical communications or optical sensors.     

Interference of circularly polarized light: contrast and application in fabrication of three-dimensional periodic microstructures

The contrast of interference pattern formed by two circularly polarized waves and by a linearly polarized wave and a circularly polarized one is discussed. The results are compared with that by two linear beams. It shows that the use of circular light in holographic fabrication of three-dimensional periodic microstructures may remove the necessity of beam ratio and polarization optimization needed in the interference of three linear noncoplanar beams and improve the uniform contrast of resultant pattern simultaneously.     

The 3-D FEL pulse propagation equation: An analytical treatment in the low-gain and small-signal regime

Summary In this paper we show that the transverse mode evolution of a FEL operating with short pulses can be treated, in the small-signal and low-gain regime, using a relatively simple mathematical technique leading to a potentially fast numerical algorithm. We also point out that analytical solutions can be obtained for the cases where the slippage length is small compared to the longitudinal bunch length.     

Ring resonators with N × M couplers

Multiple-zero multiple-pole optical filter transfer functions may be implemented more efficiently in an integrated optics architecture if higher order N × M optical couplers are utilized. For example, a coherent ring resonator made from two 3×3 couplers offers some advantages over the three mirror Fabry-Perot etalon, which is its analog. To this end we develop the formalism for obtaining the transfer functions and scattering matrices of ring resonators made from two N × M couplers. We then present a methodology for analyzing serial and parallel systems of N × M optical coupler ring resonators.     

Consequences of the ‘Pedersen papers’ on crown type chemistry at Würzburg and Bonn Universities: From heteroaromatic crowns and podands to large molecular and crystalline cavities including multisite receptors,cascade molecules,chromoionophores, siderophores,surfactant-type,and extreme ligands

We thank the editors of this issue for the opportunity to present the historic development of crown chemistry at the Universities of Wurzburg and Bonn in memory of C. J. Pedersen, the originator of the crown ethers. His legacy of science has tremendously stimulated research at both universities.This paper is dedicated to the memory of the late Dr C. J. Pedersen.