Solid phase extraction for analysis of biogenic carbonates by electrothermal vaporization inductively coupled plasma mass spectrometry (ETV-ICP-MS): an investigation of rare earth element signatures in otolith microchemistry

Uptake of trace elements into fish otoliths is governed by several factors such as life histories and environment in addition to stock and species differences. In an attempt to elucidate the elemental signatures of rare earth elements (REEs) in otoliths, a solid phase extraction (SPE) protocol was used in combination with electrothermal vaporization (ETV) as a sample introduction procedure for the determinations by inductively coupled plasma quadrupole mass spectrometry (ICP-MS). Effects of various parameters, such as carrier gas flow rate, atomization temperature and chemical modification, were examined for optimization of the conditions by ETV-ICP-MS. Atomization was achieved at 2800 °C. Lower temperatures (i.e. 2600 °C) resulted in severe memory problems due to incomplete atomization. Palladium was used as a chemical modifier. It was found that an increase in Pd concentration up to 0.5 μg in the injection volume (70 μl) led up to four-fold enhancement in the integrated signals. This phenomenon is attributed to the carrier effect of Pd rather than the stabilization since no significant losses were observed for high temperature drying around 700 °C even in the absence of Pd. Preconcentration was performed on-line at pH 5 by using a mini-column of Toyopearl AF-Chelate 650M chelating resin, which also eliminated the calcium matrix of otolith solutions. After preconcentration of 6.4 ml of solution, the concentrate was collected in 0.65 ml of 0.5% (v/v) HNO₃ in autosampler cups, and then analyzed by ETV-ICP-MS. The method was validated with the analysis of a fish otolith certified reference material (CRM) of emperor snapper, and then applied to samples. Results obtained from otoliths of fish captured in the same habitat indicated that otolith rare earth element concentrations are more dependent on environmental conditions of the habitat than on species differences.     

三角帆蚌对水体Cr,Pb和Cd的净化与吸收

三角帆蚌（Hyriopsis cumingii Lea）对水体Cr,Pb,Cd污染有明显的净化能力，持续处理12d，能使水体Cr,Pb,Cd含量分别下降83％，77．6％和72％。蚌体的斧足、鳃、外磁膜、体表粘液、肝脏、肠道和生殖腺等组织对3种污染物的吸收和富集作用不尽相同，其中分别以体表粘液、鳃和肝脏最为显著。3种污染物进入蚌体的速度很快，其组织吸收量一般在第3天即可达到较高水平。进入蚌体的污染物，可在组织转移和重新分布。研究结果为生物治理Cr,Pb,Cd等重金属污染积累了资料。     

可剥离膜去除不锈钢表面铀污染的研究

退役的核设施中不锈钢制件表面附着的放射性污染物 ,必须经去污处理后才能回收利用。铀是核工业中最常见的污染放射性元素 ,而不锈钢是核设施中最常用的耐腐蚀金属材料 ,由于以ＵＯ2 +2 状态存在的铀 (Ⅵ ) ,在空气和自身的辐射作用下 ,将逐渐转变为不同的氧化物。采用酸性去污液对不锈钢表面铀污染进行浸泡和擦试去污的方法 ,可以有效的除去不锈钢表面铀污染[1] 。但因浸泡需大量的去污液 ,随之产生大量的带有放射性的废液 ,对这些废液还必须经进一步的浓缩———固化处理。擦试法虽产生固体废物 ,但去污操作麻烦 ,难以对大批量、形状复杂…     

Application of matrix solid-phase dispersion in the analysis of priority polycyclic aromatic hydrocarbons in fish samples

The performance of matrix solid-phase dispersion (MSPD) for the extraction of polycyclic aromatic hydrocarbons (PAHs) in fish tissue is described. The suitability of different solid supports was tested as well as the influence on the extraction efficiency of the natural fat content in samples. Under optimal conditions 0.6-0.8 g of tissue sample, are dispersed with 2 g of octadecylsiloxane (C18) and 0.5 g of anhydrous sodium sulphate and transferred to the top of a polyethylene solid-phase extraction cartridge which already contains 2 g of florisil and 1 g of C18. Cartridges were eluted with acetonitrile. The analysis of the extracts was carried out by high-performance liquid chromatography (HPLC) coupled with fluorescence detection. The proposed method provides detection limits between 0.04 and 0.32 ng/g for the different considered PAHs, below the maximum levels established by the some regulatory bodies for the six PAHs after recent oil spill episodes and European Union regulations. Recoveries over 80% were obtained for all compounds. Accuracy validation was carried out using the US National Institute of Standards and Technology (NIST) SRM 2977 reference material.     

Selenium and mercury bioaccessibility in fish samples: an in vitro digestion method

The assessment of hazard from selenium (Se) and mercury (Hg) contaminants in the food chain based on their potential bioaccessibility and on estimate of their actual content in fish is reported under an in vitro model. Atomic fluorescence spectroscopy (AFS) was applied for total selenium and mercury quantification. Selenium and mercury bioaccessibility varied depending on the type of fish analyzed. Se solubility in the gastrointestinal supernatants was higher in swordfish and sardine (76 and 83%, respectively) than in tuna (50%). A low Hg bioaccessibility (9-17%) was found for all the samples.Simulated human gastric and intestinal digestion led to the identification of selenomethionine (SeMet) and organic mercury in the three digested fish. Furthermore, these species were not modified during the digestion. Speciation of selenium compounds was done by liquid chromatography in conjunction with inductively coupled plasma mass spectrometry (LC-ICP-MS).Sardine had the most favorable Se:Hg, [Se:Hg]_{bioaccessible} and [SeMet:Hg]_{bioaccessible} molar ratios, making it preferable to tuna and swordfish.The effect of cooking was also evaluated.     

Comparison of slurry sampling and microwave-assisted digestion for calcium, magnesium, iron, copper and zinc determination in fish tissue samples by flame atomic absorption spectrometry

The development of a slurry sampling method for the determination of calcium, copper, iron, magnesium and zinc in fish tissue samples by flame atomic absorption spectrometry is described. In comparison with microwave-assisted digestion, the proposed method is simple, requires short time and eliminates total sample dissolution before analysis. Suspension medium was optimized for each analyte to obtain quantitative recoveries from fish tissue samples without matrix interferences. Nevertheless, iron recoveries higher than 46% were not found. Treatment of samples slurried in nitric acid by microwave irradiation for 15-30 s at 75-285 W permitted to achieve efficient recoveries for calcium, iron, magnesium and zinc. Further improvement in the matrix effects for iron determination was accomplished by the use of an additional step of short microwave-assisted suspension treatment. However, standard addition method was required for calcium and copper determination, being necessary hydrochloric acid as suspension medium for the last one. Although copper could not be determined in the certified reference material using microwave-assisted digestion, the accuracy of the slurry sampling method was verified for all the investigated analytes. Detection limits were 22.8 ± 8.0, 0.884 ± 0.092, 5.07 ± 0.76, 35.5 ± 0.7 and 1.17 ± 0.04 μg g⁻¹ for calcium, copper, iron, magnesium and zinc, respectively. The standard deviations obtained using slurry sampling method and microwave-assisted digestion were not significantly different, and the mean relative standard deviation of the over-all method (n = 3) of the slurry sampling method for different concentration levels was below 12%.     

Development and validation of an analytical methodology for the determination of p,p′-DDT, p,p′-DDE and p,p′-DDD in fish oil pills

An analytical methodology was proposed and validated to be applied to the determination of p,p′-DDT and its metabolites p,p′-DDE and p,p′-DDD in fish oil. The analytical procedure presented in this paper involves a single-step clean up process prior to the analysis. A solution of 1,2,3,4-tetrachloronaphtalene was used as internal standard.The analytical technique used was gas chromatography coupled to an electron capture detector. Details on the validation process are provided.The limits of detection ranged from 2.6 to 4.7 pg μL^− 1. The BCR 598 standard reference material (cod liver oil) was used to evaluate the performance of the methodology with satisfactory recoveries for all the compounds.The analytes were determined in three different fish oil pills sold in Spain as a supplementary vitamin support. The sum of p,p′-DDT and metabolites was from 13.2 to 51.3 ng g^− 1, the dominant compound being p,p′-DDE.     

Dual-column GC analysis of mediterranean fish for ten organochlorine pesticides and sixty two chlorobiphenyls

The simultaneous analysis of α-HCH, β-HCH, γ-HCH, HCB, p,p′-DDD, p,p′-DDT, p,p′-DDE, o,p′-DDT, mirex, dieldrin and 62 chlorobiphenyl congeners on two parallel capillary GC columns of different polarity is described for nine Mediterranean fish species. Ten commercially available columns with stationary phases completely characterized in respect of their PCB elution patterns were considered for dual-column GC-ECD analysis. The combination of a 60 m × 0.25 mm i.d. column coated with a 0.25 μm film of 50% diphenyl dimethylsiloxane and a series combination of a 25 m × 0.25 mm i.d. column coated with a 0.25 μm film of 5% diphenyl dimethylsiloxane with a 25 m × 0.22 mm i.d. column coated with a 0.10 μm film of 1, 10-dicarba-closo-dodecarborane dimethylpolysiloxane furnished the highest number of separated chlorobiphenyl congeners (104). The dual-column GC system performed with high stability and reproducibility over a broad concentration range (1–3000 ng/g lipid) of the organochlorine compounds in the investigated fish.     

Fast simultaneous determination of 23 veterinary drug residues in fish,poultry, and red meat by liquid chromatography/tandem mass spectrometry

The misuses of veterinary drugs can result in the accumulation of residues in food of animal origin that can make its way to the final consumer. Herein we describe a simple method for the accurate determination of beta-lactams, quinolones, sulphonamides, and tetracyclines in fish, poultry, and red meat. No extraction cartridges were used; instead, the extraction process consisted of the addition of an organic solvents, shaking, centrifugation, and dilution. An extensive validation process demonstrated an excellent linearity (R² ≥ 0.99) for 23-drug residues. The recovery of drugs in different matrices at two concentration levels (n = 6) was in the range of 82–119%. The method was proved to be repeatable and reproducible with intra/inter-day measurements (RSDs lower than 20%). The quantification limits of drug residues were in the range of 0.8 to 45.3 ug/kg, which is well below the maximum residue limits set by most regulatory authorities. This method was successfully applied to the routine analysis of 20 fish, poultry, and red meat samples (n = 60).     

Mediated amperometric biosensor for hypoxanthine based on a hydroxymethylferrocene-modified carbon paste electrode

An amperometric enzyme electrode for the determination of hypoxanthine in fish meat is described. The hypoxanthine sensor was prepared from xanthine oxidase immobilized by covalent binding to cellulose triacetate and a carbon paste electrode containing hydroxymethylferrocene. The xanthine oxidase membrane was retained behind a dialysis membrane at a carbon paste electrode. The sensor showed a current response to hypoxanthine due to the bioelectrocatalytic oxidation of hypoxanthine, in which hydroxymethyiferrocene served as an electron-transfer mediator. The limit of detection is 6 × 10^?7 M, the relative standard deviation is 2.8% (n=28) and the response is linear up to 7 × 10^?4 M. The sensor responded rapidly to a low hypoxanthine concentration (7 × 10^?4 M), the steady-state current response being achieved in less than 1 min, and was stable for more than 30 days at 5 ° C. Results for tuna samples showed good agreement with the value determined by the conventional method.