Photosensitive organic-inorganic hybrid structures based on porous silicon

Abstract

In this study, the photovoltaic organic-inorganic structures were created by deposition of poly(3,4-ethylenedioxythiophene) film doped by poly(styrenesulfonate) and reduced graphene oxide on the porous silicon/silicon substrate. Formation of the hybrid structure was confirmed by means of atomic-force microscopy and Fourier transform infrared spectroscopy. The current-voltage characteristics of the obtained structures were studied. It was found the increase of electrical conductivity and photo-induced signal in organic-inorganic structures. Temporal parameters and spectral characteristics of photoresponse in the 400–1100?nm wavelength range were investigated. The widening of spectral photosensitivity in a short-wavelength range due to light absorption in various layers of the multijunction structure in comparison with single crystal silicon was revealed.     

Functionalized Silver-Ion-Mediated α-dC/β-dC Hybrid Base Pairs with Exceptional Stability: α-d-5-Iodo-2′-Deoxycytidine and Its Octadiynyl Derivative in Metal DNA

Silver-mediated α-dC–Ag⁺–β-dC hybrid base pairs decorated with 5-iodo- or 5-octadiynyl residues are well accommodated in duplex DNA. A strong T_m increase and favorable thermodynamic data for duplex DNA were observed after addition of silver ions. The phenomenon is particularly obvious when both nucleobases of the base pairs are functionalized. Neither the position of the base pair, nor the type of 5-substituent had a negative influence. On the contrary, functionalization of conventional silver-mediated β-dC–Ag⁺–β-dC homo base pairs showed a negative impact induced by the bulky substituents. To this end, cytosine modified 12-mer oligodeoxynucleotides were prepared by solid-phase synthesis employing new α-anomeric 2′-deoxycytidine phosphoramidites. A multigram scale synthesis was developed for 5-iodo-α-d -2′-deoxycytidine ( 1 ) employing the direct glycosylation of cytosine with Hoffer's α-d -halogenose followed by separation of anomeric DMT nucleosides. Regarding base-pair stability and functionalization silver-mediated α/β-dC hybrid base pairs were found to be superior to β/β-dC homo pairs. According to their extraordinary properties, they might find applications in DNA diagnostics, material science, or nanotechnology.     

Enhancing the Water Stability of Al‐MIL‐101‐NH2 via Postsynthetic Modification

The resistance of metal–organic frameworks towards water is a very critical issue concerning their practical use. Recently, it was shown for microporous MOFs that the water stability could be increased by introducing hydrophobic pendant groups. Here, we demonstrate a remarkable stabilisation of the mesoporous MOF Al‐MIL‐101‐NH₂ by postsynthetic modification with phenyl isocyanate. In this process 86 % of the amino groups were converted into phenylurea units. As a consequence, the long‐term stability of Al‐MIL‐101‐URPh in liquid water could be extended beyond a week. In water saturated atmospheres Al‐MIL‐101‐URPh decomposed at least 12‐times slower than the unfunctionalised analogue. To study the underlying processes both materials were characterised by Ar, N₂ and H₂O sorption measurements, powder X‐ray diffraction, thermogravimetric and chemical analysis as well as solid‐state NMR and IR spectroscopy. Postsynthetic modification decreased the BET equivalent surface area from 3363 to 1555 m² g^?1 for Al‐MIL‐101‐URPh and reduced the mean diameters of the mesopores by 0.6 nm without degrading the structure significantly and reducing thermal stability. In spite of similar water uptake capacities, the relative humidity‐dependent uptake of Al‐MIL‐101‐URPh is slowed and occurs at higher relative humidity values. In combination with ¹H‐²⁷Al D ‐HMQC NMR spectroscopy experiments this favours a shielding mechanism of the Al clusters by the pendant phenyl groups and rules out pore blocking.     

Organic–Inorganic Hybrid Gold Halide Perovskites: Structural Diversity through Cation Size

Crystal structures of a series of organic–inorganic hybrid gold iodide perovskites, formulated as A₂[Au^II₂][Au^IIII₄] [A=methylammonium (MA) ( 1 ) and formamidinium (FA) ( 2 )], A′₂[I₃]_1−x[Au^II₂]_x[Au^IIII₄] [A′=imidazolium (IMD) ( 3 ), guanidinium (GUA) ( 4 ), dimethylammonium (DMA) ( 5 ), pyridinium (PY) ( 6 ), and piperizinium (PIP) ( 7 )], systematically changed depending on the cation size. In addition, triiodide (I₃⁻) ions were partly incorporated into the AuI₂⁻ sites of 3 – 7 , whereas they were not incorporated into those of 1 and 2 . Such a difference comes from the size of the organic cation. Optical absorption spectra showed characteristic intervalence charge-transfer bands from Au^I to Au^III species, and the optical band gap increased as the size of the cation became larger.     

属间远缘杂交水稻耐旱性生理特性的比较研究

采用在ＹＯＳＨＩＤＡ水稻专用培养营养液中添加一定量的ＰＥＧ ６０００的方法，比较研究了模拟干旱胁迫条件下属间远缘杂交新型水稻品种“远诱１号”（Ｙ）及其水稻亲本“圭６３０”（Ｇ）、高梁亲本“桃长红”（Ｔ）以及生产推广杂交组合“汕优６３”（Ｓ）等试验材料某些生态生理特性的差异。研究结果表明，在－１．０ＭＰａ的高渗胁迫下，Ｙ、Ｇ、Ｔ的萌发系数均有不同程度的下降，正常培养条件下的萌发系数ＧＣ分别为３６．９     

混合判断矩阵排序方法研究

本文介绍了混合判断矩阵及完全一致性混合判断矩阵的概念，提出了混合判断矩阵排序的一种最小偏差法，并给出了其收敛性迭代算法，最后通过算例说明了方法的可行性。     

The Analysis and Improving of the Microwave Exciter in the Lower Hybrid Wave System

When we carry out lower hybrid wave heating and current driving plasma experiment at tokamak, we need mega-watt order of microwave power. The microwave signal at frequency of 2450 MHz is generated by a microwave exciter. According to the experiment＇s demands, the microwave exciter must provide output power of 1.5～ 2. 5 W with stabilized frequency and amplitude tobe used as the klystron input. Being amplified by the klystron, the microwave signal is transmitted through the transmitting system to the antenna and is emitted into the HL-2A tokamak. So we can see that the microwave exciter＇s function is very important to the lower hybrid wave heating and current driving plasma experiment.     

Decreasing the Displacements of a Composite Saddle-Shaped Cable Roof

The structural possibilities of decreasing the compliance of a composite saddle-shaped cable roof having a compliant support contour are investigated. The use of a supporting contour consisting of cables joined together with tie-bars is considered as a structural method enabling one to decrease the compliance of the roof. Each cable of the support has its own initial flexure. The method is most efficient from the viewpoint of material consumption per unit of covered area relative to the increasing rigidity and prestress level of the cable net.The efficiency of the method was evaluated by a numerical experiment, which was carried out for a composite saddle-shaped cable roof 50 × 50 m in the plan. The roof was formed by two orthogonal cable groups joined with a compliant supporting contour. A hybrid composite cable based on a carbon-fiber-reinforced plastic, a glass-fiber-reinforced plastic, and steel was considered as a material for the cable net in combination with steel. The material consumption and the maximum vertical displacement of the cable net in relation to the initial geometrical characteristics of the supporting contour were obtained. A possibility of decreasing the maximum vertical displacements of the roof by 8% was established.     

Zero Dissipative, Explicit Numerov-Type Methods for Second Order IVPs with Oscillating Solutions

New explicit, zero dissipative, hybrid Numerov type methods are presented in this paper. We derive these methods using an alternative which avoids the use of costly high accuracy interpolatory nodes. We only need the Taylor expansion at some internal points then. The method is of sixth algebraic order at a cost of seven stages per step while their phase lag order is fourteen. The zero dissipation condition is satisfied, so the methods possess an non empty interval of periodicity. Numerical results over some well known problems in physics and mechanics indicate the superiority of the new method.     

Quantum Teleportation via Hybrid Entangled States

In this paper, we study quantum teleportation of atomic states via a hybrid entangled state (HES) involving an atom and a cavity field. And we investigate how to implement controlled phase (CP) gates between atomic internal Finally, a brief discussion about the feasibility of this scheme in experiment is presented.