层次分析中广义最小偏差法的性质

广义最小偏差法（GLDM）是层次分析中一种重要的排序方法．本文讨论了广义最小偏差法的性质和灵敏度分析问题．     

低速二维流动的粒子仿真研究

本文运用信息保存法对低速二维的流动现象进行模拟，考察了低速条件下的有限平板绕流以及微槽道气体流动问题。研究表明：在对低速流动的模拟过程中，运用IP法在能够获得较好的结果的同时，具有比DSMC方法更高的计算效率。     

A new property of Bernstein-Kantorovi? operators

In the present paper, we prove that the Bernstein-Kantorovič operators have the ability of preserving translation property in both C and L^p norms. Supported (in part) by the NSFC(10471130,10371024) of PRC and the Natural Science Foundation (Y604003) of Zhejiang Province.     

Imaging of wood tissue by ToF-SIMS: Critical evaluation and development of sample preparation techniques

Tissue of Norway spruce wood was investigated by time-of-flight secondary-ion mass spectrometry (ToF-SIMS) and field-emission scanning electron microscopy (FE-SEM). Different sample preparation techniques (including sectioning and drying) traditionally used for SEM analysis were compared and critically evaluated. A high contamination of wood surfaces by polytetrafluoroethylene (PTFE) introduced onto the sample during sectioning was detected by ToF-SIMS. A new protocol was developed and images of wood sections dried in different ways were compared. Main location of Mg, Na, K and Ca, but no lignin in membranes of bordered pits in spruce section surfaces was detected by ToF-SIMS imaging if critical point drying (CPD) or acetone extraction followed by drying under nitrogen flow (AEND) was applied. No specific locations of wood components as well as low signals from metal ions (Mg and Na) were observed on the wood surfaces of freeze-dried (FD) or air-dried (AD) sections. It was found that extractive substances, presenting on surfaces of FD and AD wood section, were evenly distributed on the surfaces and interfered with ToF-SIMS analysis. Our results indicated that ToF-SIMS imaging was critically sensitive to the sample preparation technique and a strict protocol for characterization of metals, lignin and polysaccharides in wood was suggested.     

Studies on the Structure and Properties of Cordierite Synthesized by Talc-Magnesite

Homogeneous cordierite has been synthesized at low cost by talc-magnesite and coal gangue as the main raw materials. The mechanism of synthesizing cordierite under such a com- posing system of raw materials, and the effect of temperature on the crystal cell parameters and microstructure and thermal expansion coefficient of cordierite crystal have been studied via testing methods of XRD, SEM, etc. The result shows that the homogeneous cordierite can be synthesized by the systematic composing materials of “talc-magnesite—coal gangue—talc” with heat pre- servation at 1350 ℃ for 1 h; as the keeping time is prolonged, Al3+ and Mg2+ in cordierite crystal are replaced by a few impurity ions such as Fe3+, Fe2+, etc., and the crystal cell parameters of cordierite present an increase trend; as the high-temperature heat preservation is prolonged, the content of glassy phase in the sample is increased, its density is improved, and its thermal expansion coeffi- cient presents an increase trend.     

Drying and pyrolysis of wood particles: experiments and simulation

The objective of this study is to develop a flexible and stable numerical method to predict the thermal decomposition of large wood particles due to drying and pyrolysis. At a later stage, this model is applied to each particle of a packed bed and thus, forms the entire packed bed process as a sum of individual particle processes. Therefore, this approach can deal with particles of different sizes, shapes and properties. A general formulation of the conservation equations allows the geometry of a fuel particle to be treated as a plate, cylinder or sphere. The various processes such as heat-up, drying and pyrolysis are described by a set of one-dimensional and transient conservation equations for mass and energy. This allows for simultaneous processes e.g. reactions in time and covers the entire range between transport-limited (shrinking core) and kinetically limited (reacting core) reaction regimes. The particles interact with a gas phase by heat and mass transfer taking into account the Stefan correction due to the gas outflow during conversion. Experiments carried out span a temperature range between T=300 and 900 °C for particle sizes varying between 8 and 17 mm. A comparison between measurements and predictions of drying models yielded satisfactory agreement only for the constant evaporation temperature model and thus, indicating, that the drying process is transport limited by heat transfer for large wood particles. Likewise, predicted results of pyrolysis for the above-mentioned range of temperatures and sizes agreed satisfactorily with measurements.     

Quaternized wood as sorbent for hexavalent chromium

The potential of quaternized wood (QW) chips in removing hexavalent chromium from synthetic solution and chrome waste under both batch and continuous-flow conditions was investigated. Sorption was found to be dependent on pH, metal concentration, and temperature. QW chips provide higher sorption capacity and wider pH range compared with untreated wood chips. The equilibrium data could be fitted into the Langmuir isotherm model, and maximum sorption capacities were calculated to be 27.03 and 25.77 mg/g in synthetic chromate solution and chrome waste, respectively. The presence of sulfate in high concentration appeared to suppress the uptake of chromium by QW chips. Column studies showed that bed depth influenced the breakthrough time greatly whereas flow rate of influent had little effect on its sorption on the column.     

Characterization of the supermolecular structure of cellulose in wood pulp fibres

The hierarchic organization of cellulose fibrils (microfibrils) was investigated in holocellulose, sulphite pulp and kraft pulp using TEM, XRD, ED and FTIR. There were remarkable differences in both the fibril structure and fibril aggregation between the samples. TEM observations revealed more intimately associated fibrils in the kraft pulp compared to the sulphite pulp and the holocellulose, results in agreement with previous CP/MAS ¹³C-NMR data [Hult E.-L. et al. (2002) Holzforschung 56: 231–234]. Furthermore, the cellulose crystallinity was higher in the kraft pulp sample. With respect to the cellulose I and I allomorphs, these samples were controversial when different analytical techniques were applied. Due to the small fibril size and the low degree of order of cellulose in these samples, the concept of crystalline triclinic and monoclinic components as determined by diffraction analysis may not be adequate. Instead the fibril can be regarded to have different degrees of lateral order (including paracrystalline ordering) that can be reoriented to I type conformation and packing upon pulping.     

EPR detection of foods preserved with ionizing radiation

The applicability of the epr technique for the detection of dried vegetables, mushrooms, some spices, flavour additives and some condiments preserved with ionizing radiation is discussed. The epr signals recorded after exposure to gamma rays and to beams of 10 MeV electrons from linac are stable, intense and specific enough as compared with those observed with nonirradiated samples and could be used for the detection of irradiation. However, stability of radiation induced epr signals produced in these foods depends on storage condition.

No differences in shapes (spectral parameters) and intensities of the epr spectra recorded with samples exposed to the same doses of gamma rays (⁶⁰Co) and 10 MeV electrons were observed     

Coupling of thermal desorption in modified closeable sampling columns with wide-bore capillary gas chromatography and mass spectrometric detection

In contrast to usability of Curie-point pyrolysis at 700°C directly attached to gas chromatography-mass spectrometry (GC-MS) for determination of organic wood preservatives in waste wood samples the investigation method reported here consists of thermal desorption at temperatures about 260°C in connection with GC-MS for peak identification or GC with flame ionization detection for quantitative analyses. So-called “modified closeable sampling columns” are used as batch-reactor in thermal desorption experiments. Desorbed vapours can be introduced on capillary columns without sample discrimination and without a disturbing lost of resolution. In this manner a lot of individual polycyclic aromatic hydrocarbons were determinated in waste wood samples, especially in railway sleepers.