Measured and Predicted Solubility Phase Diagrams of Quaternary Systems LiBr-NaBr-MgBr2-H2O and LiBr-KBr-MgBr2-H2O at 298.15 K

The stable phase equilibria of quaternary systems LiBr-NaBr-MgBr₂-H₂O and LiBr-KBr-MgBr₂-H₂O at 298.15 K were studied by both experimental measurement(isothermal solution saturation method) and theoretical prediction(Pitzer model). The solubilities of the saturated solution have been determined experimentally and two stable phase diagrams and relevant water diagrams of the two quaternary systems were obtained. Results show that quaternary system LiBr-NaBr-MgBr₂-H₂O is hydrate II type as NaBr and NaBr·2H₂O coexistence. Its phase diagram consists of only one invariant point, four univariant curves, and five crystallization fields. The quaternary system LiBr-KBr-MgBr₂-H₂O is a complex type as the double salt KBr·MgBr₂·6H₂O formed. In addition to this double salt, the three single salts LiBr·2H₂O, KBr and MgBr₂·6H₂O also crystallize. In this paper, the solubilities of phase equilibria in above quaternary systems were also calculated by the Pitzer's electrolyte solution model. All the needed parameters can be obtained from the literature or be fitted by experimental data. On the Basis of the experimental and calculated results, the phase diagram of the quaternary system was plotted for comparison. It shows that the calculation results are consistent with the experimental ones.     

Solubility parameter determination of cationic surfactants by inverse GC

Summary The solubility parameters of cationic surfactants were obtained using the inverse gas chromatographic technique. The surfactants didodecyl dimethyl ammonium bromide, dioctadecyl dimethyl ammonium bromide and dodecyl pyridinium chloride were used as stationary phase and retention data of different probe solutes were measured at different temperatures. The results were analysed by the combination of Flory-Huggins and Hildebrand theories, and the solubility parameters of the surfactants were obtained in a range of temperatures between 80–120°C.     

Synthesis,characterization and properties of methylaminocellulose

Homogeneously prepared tosylcelluloses (TC) with degrees of substitution (DS) of DS_Tos 0.1–1.8 were used as intermediates for the synthesis of methylaminocelluloses (MAC) by nucleophilic substitution with methylamine. TC with DS_Tos up to 1.1 were shown to be valuable intermediates for selective synthesis of MAC with DS_MA varying from 0.1 to approximately 1. No nucleophilic substitution was observed at higher DS_Tos. At the chosen reaction conditions (60 °C, 48 h) residual tosyl moieties remained unchanged and little hydrolysis took place. The samples obtained were characterized by means of elemental analysis, FTIR and ¹³C CP/MAS NMR spectroscopy. ¹³C CP/MAS NMR spectroscopy was found to be an efficient tool for quantification of DS_MA. Furthermore, the swelling behaviour in water was investigated and preliminary tests concerning the bilirubin adsorption capacity of MAC were carried out.     

Neutron emission under particular nonequilibrium conditions from Pd and Ti electrolytically charged with deuterium

Summary We report on neutron emission in palladium and titanium electrolitically charged with deuterium. The detection of neutrons is observed after thermal treatment of the electrode. In the hypothesis that neutrons came from cold fusion processes, we estimate a fusion rate as high as 1.3·10⁻²¹ fusions/deuteron pair/second.     

Phase diagram of Na2S2O3 + ethanol + water at ambient pressure and temperature

In the present communication, we report the studies concerning liquid–liquid–solid equilibria for the ternary system sodium thiosulphate (Na₂S₂O₃) + ethanol + water at ambient pressure and at room temperature (303 ± 2 K). The solubility data of Na₂S₂O₃ are reported for solutions in water, ethanol and solutions of varying concentrations of ethanol in water. The phase diagram for the said system is developed, described and compared with similar system K₂CO₃ + methanol + water. These results have been explained in terms of structural properties of aqueous ethanol solutions and further discussed in terms of the effect of ions to cause phase separation.     

Effect of pressure on the solubilities ofo-,m- andp-xylene in water

The solubilities of o-, m- and p-xylene in water were measured at 25.0°C up to 250, 385, and 50 MPa, respectively. The solubility increased with increasing pressure up to 120 MPa (50 MPa for p-xylene) and then decreased. The reaction volumes, V^o accompanying the dissolution at 0.1 MPa were estimated as –3.6±0.5, –3.4±0.5, and –4.1±0.5 cm³-mol^–1 for o-, m-, and p-xylene, respectively, from the pressure dependences of the solubilities. The limiting partial molar volumes, of p- and o-xylene in water under high pressure were estimated from V^o and the molar volume of the xylene. The partial molar volumes decreased with increasing pressure. The reaction volume for the formation of intra-molecular pairwise hydrophobic interaction between the methyl groups, as proposed by Ben-Naim, is discussed for the V^o of p- and o-xylene at 0.1 MPa.     

Solubility of α-amino acids in water under high pressure: glycine, -alanine, -valine, -leucine, and -isoleucine

The solubility of glycine, -alanine, -valine, -leucine, and -isoleucine in water was measured at 298.15 K and pressures up to 400 MPa. The standard deviation of the logarithm of the solubility is 0.001–0.003, equal to or better than the accuracy of atmospheric pressure measurement in the literature (0.001–0.05). A variety of solubility phenomena were observed. The solubility of glycine decreased with increasing pressure, whereas that of -alanine increased. The -valine and -isoleucine have a solubility maximum at around 100 MPa, and -leucine seems to exhibit a solid-phase phase transition at around 200 MPa. Pressure coefficient of the solubilities at 0.10 MPa is compared with that thermodynamically estimated in reference to aqueous density measurements of glycine and -alanine at 298.15 K and 0.10 MPa, supporting a reliability of our high-pressure measurements.     

Hydrogen substitution effect on the solubility of perhalogenated compounds in ionic liquid [bmim][PF6]

Solubility behaviors of binary mixtures of CFCl₃ (R-11), CFCl₂-CF₂Cl (R-113), CHCl₃ (R-20), CDCl₃ (R-20-d), CHCl₂–CF₃ (R-123) with room-temperature ionic liquid [bmim][PF₆] (1-butyl-3-methylimidazolium hexafluorophosphate) have been investigated using the volumetric and cloud-point methods, since all the systems show liquid–liquid equilibria (LLE). Large immiscibility (LLE) gaps of the perhalogenated compounds (R-11 and R-113) in the ionic liquid have been drastically reduced by the addition of only one hydrogen (or deuterium) in these compounds. The R-123 + [bmim][PF₆] binary system belongs to the Type-V fluid behavior. Noticeably large negative values (−2 to −8 cm³ mol⁻¹) of the excess molar volume in the ionic liquid-rich side solution have been observed for all the present systems. Experimental LLE data have been well correlated by the use of the NRTL (non-random two liquid) activity coefficient model.     

Solubility and Ionic Processes in the Cu X 2? MX ?H2O ( X ?=Cl?, Br?; M +=Li+, Na+, K+, NH4+, Cs+) Systems

Summary.  Solubility isotherms in the CuBr₂−MBr−H₂O (M ⁺ = Li⁺, Na⁺, Cs⁺) systems at 298.15 K were measured. The results together with other available literature data for copper chloride and bromide systems were treated by hydration analysis, and comparative discussion of ionic processes taking place in the respective saturated solutions was performed. Corresponding author. E-mail: jitka@prfdec.natur.cuni.cz Received August 6, 2002; accepted (revised) November 29, 2002 Published online April 3, 2003     

Direct measurement of gas solubility and diffusivity in poly(vinylidene fluoride) with a high-pressure microbalance

We present solubility and diffusion data for the gases methane and carbon dioxide in the polymer poly(vinylidene fluoride). The polymer was cut from extruded piping intended for use in offshore oil and gas applications. Measurements were carried out using a purpose-built high-pressure microbalance. These properties were determined in the temperature range 80-120 °C and in the pressure range 50-150 bar for methane and 20-40 bar for carbon dioxide. In general, good agreement was obtained for similar measurements reported in the literature. Solubility follows a Henry’s law (linear) dependence with pressure. Diffusion coefficients for each of the gases in the polymer were also measured using the balance. Activation energies for diffusion and heats of solution for the two gases in the polymer were also determined.