新型混合脂质体的制备及其与药物的分子识别研究

设计、合成了含核酸碱基的双亲化合物N6-十四酰基-9-辛基腺嘌呤三甲基溴化铵;用目标化合物和卵磷脂制备混合脂质体受体。分别研究了受体与巴比妥酸、核黄素药物在混合脂质体亲脂区通过互补氢键进行的分子识别。紫外可见光谱研究表明,底物巴比妥酸在258nm的吸收峰,核黄素在222nm,264nm的吸收峰随时间的延长而逐渐降低,这种减色作用归因于脂质体内的巴比妥酸和核黄素在亲脂区分别与双亲化合物上的腺嘌呤形成了氢键。     

Overproduction of riboflavin by anArthrobacter sp. mutant resistant to 5-fluorouracil

Effects of pH and dissolved oxygen concentration on batchwise riboflavin production by a 5-fluorouracil (5-FU)-resistant mutant ofArthrobacter sp. were investigated. The reaction was carried out in a jar fermentor. The optimal pH of culture medium was around 7.3. Dissolved oxygen concentration was almost constant during fermentation at 600 rpm of agitation rate. Production of riboflavin reached a maximum of 160 mg/L after 70 h fermentation under the agitation rate of 600 rpm, aeration rate of 1.0 L/min, and pH 7.0.     

Photophysical studies of some dyes in aqueous solution of triton X-100

The spectral (both absorption and fluorescence) and photoelectrochemical studies of a few selective dyes, namely, anionic erythrosin B, neutral riboflavin and cationic safranin O have been carried out in aqueous solution of triton X-100, a neutral surfactant. The results show that the ionic dyes, erythrosin B and safranin O form 1:1 electron donor-acceptor (EDA) or charge-transfer (CT) complexes with triton X-100 both in the ground and excited states, whereas neutral dye riboflavin in its excited state forms 1:1 complex with triton X-100. In these complexes, the dyes act as electron acceptors whereas triton X-100 acts as an electron donor. The fluorescence spectra of erythrosin B and safranin O in presence of triton X-100 show enhancement of fluorescence intensity with red and blue shifts respectively while riboflavin shows normal quenching of fluorescence. A good correlation has been found among photovoltage generation of the systems consisting of these dyes and triton X-100, spectral shift due to complex formation and thermodynamic properties of these complexes.     

测定核黄素的化学发光新方法

研究了核黄素的化学发光性质，建立了一种测定核黄素的化学发光新方法，并应用于实际样品中核黄素的测定，与文献相比，本方法无需避光，而且分析体系和样品处理简单；干扰小，牛血清白蛋白、抗坏血酸、天冬氨酸等８种生物有机物质和 Ｃｕ（Ⅱ）、Ｚｎ（Ⅱ）、Ｆｅ（Ⅲ）等１５种常见金属离子的允许量较大；核黄素溶液浓度在０． １０～５０ ｍｇ／Ｌ范围内，与化学发光强度成正比，方法线性范围宽；测定１．０ｍｇ／Ｌ核黄素溶液１２次，求得相对标准偏差为２．９％，方法精密度高；方法的检测限为０．０７５ ｍｇ／Ｌ，灵敏度高。     

A multicommuted fluorescence-based sensing system for simultaneous determination of Vitamins B2 and B6

A multicommuted flow-through optosensor based on the direct fluorescence measurements of Vitamins B₂ and B₆ using a non-polar sorbent (C₁₈ silica gel) as solid sensing zone (to accomplish the separation and subsequent preconcentration/detection of the target analytes) have been developed. The proposed flow system was controlled by Java-written home-made software and designed using three-way solenoid valves for independent automated manipulation of sample and carrier solutions. The native fluorescence signal was simultaneously monitored at two pairs of excitation/emission wavelengths (450/519 and 294/395 for B₂ and B₆, respectively). The separation of the analytes was performed in the detection flow cell, using the differences in the sorption/elution process on the solid support between the two vitamins, due to their different polarity. Using an optimised sampling time, the analytical signal showed linearity in the range 0.01-0.4 and 0.15-3 μg ml⁻¹ with detection limits of 0.003 and 0.045 μg ml⁻¹ for B₂ and B₆, respectively, obtaining R.S.D. (%) values better than 2% for both analytes. The proposed methodology was applied to different pharmaceutical preparations, obtaining remarkably good results with recoveries ranging from 96 to 107.5%.     

Binary Metal Oxide Adsorbed Graphene Modified Glassy Carbon Electrode for Detection of Riboflavin

Tungsten oxide (W) decorated titanium oxide (T) adsorbed onto a graphene (Gr) and modified the glassy carbon electrode for the electrochemical quantification of riboflavin (RF) in edible food and pharmaceuticals. For comparison, nanocomposites are formed using graphene oxide (GO), reduced graphene oxide (rGO) and pure graphite (G) sheets to study the electrochemical activities towards riboflavin. The ternary WTGr modified GCE shows the highest electrocatalytic activity due to synergetic interactions between the metal oxide and graphene. The electrochemical observations are supported by the SEM, HRTEM, XRD, UV-Vis, Zeta potential (ζ) and size data. The sensor shows a wide linear range 20 nM–2.5 μM with a detection limit 25.24 nM and sensitivity (4.249×10⁻⁸ A/nM). The fabricated sensor is validated in real samples.     

Neue Methode zur Bestimmung von Riboflavin im Harn

Ohne Zusammenfassung

---

New method for the determination of riboflavine in urine

     

Fluoreszenzfarbstoffe in der Natur

In this paper we describe some fluorescent plant and mushroom dyes. This part of natural product chemistry was of little interest for most natural scientists until today. Most of these substances are published in scientific papers, but there are only rare hints for eventually fluorescence‐phenomenones. Equipped with an UV‐lamp, test tubes and some common solvents, natural products can easily be tested to show fluorescence. In the context of this publication the authors discovered a new Hypericin sensibilized Peroxyoxalate‐Chemoluminescence (strong orangered emission).     

Simultaneous analysis of riboflavin and aromatic amino acids in beer using fluorescence and multivariate calibration methods

The study demonstrates an application of the front-face fluorescence spectroscopy combined with multivariate regression methods to the analysis of fluorescent beer components. Partial least-squares regressions (PLS1, PLS2, and N-way PLS) were utilized to develop calibration models between synchronous fluorescence spectra and excitation-emission matrices of beers, on one hand, and analytical concentrations of riboflavin and aromatic amino acids, on the other hand. The best results were obtained in the analysis of excitation-emission matrices using the N-way PLS2 method. The respective correlation coefficients, and the values of the root mean-square error of cross-validation (RMSECV), expressed as percentages of the respective mean analytic concentrations, were: 0.963 and 14% for riboflavin, 0.974 and 4% for tryptophan, 0.980 and 4% for tyrosine, and 0.982 and 19% for phenylalanine.     

Determination of riboflavin by enhancing the chemiluminescence intensity of peroxomonosulfate-cobalt(II) system

A weak chemiluminescent (CL) emission was observed in the decomposition of peroxomonosulfate (HSO5-), which would be accelerated in the presence of trace amounts of cobalt (II). The mechanism was due to the production of singlet oxygen (1O2). Interestedly, riboflavin can enhance the CL and the CL intensity was strongly dependent on riboflavin concentration. Based on this phenomenon, a flow injection analysis (FIA) CL method was established for the determination of riboflavin. Additionally, the possible CL mechanism is proposed based on the kinetic curve of the CL reaction, CL spectra, UV-vis spectra and fluorescent spectra. The CL intensity was correlated linearly with concentration of riboflavin over the range of 1.0x10(-4) to 1.0x10(-8) g mL-1; the detection limit was 9.0x10(-9) g mL-1(S/N=3); the relative standard deviation was 1.4% for 9x10(-7) g mL-1 riboflavin (n=11). Furthermore, this method was applied to the determination of riboflavin in real tablets and injections successfully.