SPRR-300研究堆随堆辐照石墨的中子辐照效应北大核心CSCD

随SPRR-300研究堆约30 a的长时间运行,位于活性区附近的石墨箱体经历了长期的中子辐照。在长期服役的石墨箱体上取样,研究了其热学、力学以及微观结构变化,并与商用IG110,NG-CT-10石墨进行了对比。研究结果表明,经长时间低剂量率的中子辐照后,SPRR-300堆内随堆辐照石墨的晶格中出现了明显的辐照损伤缺陷,这些缺陷主要为位错环、层错、孔洞和微裂纹等,并出现了一定程度的非晶化。这些辐照损伤缺陷直接或间接地引起了石墨热学、力学性能的变化,主要表现为热膨胀系数、热扩散系数、抗压强度和抗弯强度的下降以及弯曲弹性模量的上升。     

极端条件下6Li2O的热力学性能与电子结构

 采用密度泛函理论与准谐振德拜模型研究了面心立方相的⁶Li₂O在极端条件下的热力学性质与电子结构。结果表明: ⁶Li₂O的热膨胀系数在任何温度下都随压强增加明显降低,但仅当压强较低(低于40 GPa)时,温度对6Li2O的热膨胀系数的影响才明显;O原子半径随压强增大而迅速降低,而随温度的变化并不明显;在低压条件下(低于40 GPa),带隙随温度的升高缓慢降低;而在高压条件下(高于40 GPa),温度对带隙宽度的影响几乎可以忽略;无论在什么温度条件下,带隙宽度均随压强的增大而迅速增加。     

First-principles investigation on the structural and elastic properties of cubic-Fe,TiAl under high pressures

The structural, elastic, and thermodynamic properties of cubic-Fe2TiA1 under high temperatures and pressures are investigated by performing ab initio calculation and using the quasi-harmonic Debye model. Some ground state properties such as lattice constant, bulk modulus, pressure derivative of the bulk modulus, and elastic constants are in good agreement with the available experimental results and theoretical data. The thermodynamic properties of Fe2TiA1 such as thermal expansion coefficient, Debye temperature, and heat capacity in ranges of 0 K-1200 K and 0 GPa-250 GPa are also obtained. The calculation results indicate that the heat capacities at different pressures all increase with temperature increasing and are close to the Dulong-Petit limit at higher temperatures, Debye temperature decreases with temperature increasing, and increases with pressure rising. The cubic-FezTiA1 is stable mechanically under 250 GPa. Moreover, under lower pressure, thermal expansion coefficient rises rapidly with temperature increasing, and the increasing rate becomes slow at higher pressure.     

密度泛函理论研究高温高压下UO2弹性与热力学性能

采用第一性原理与准谐德拜模型研究UO2在高温高压条件下的弹性与热力学性能。UO2在高温高压下仍属离子型晶体,并且弹性性能计算表明,四角方向剪切常数在高温与高压下均保持稳定。高温下弹性常数C44没有明显变化,而高压下C44迅速增大。体积模量、剪切模量与杨氏模量均随压强增加而增大;高温条件下,体积模量、剪切模量与杨氏模量也未出现明显的降低,表明UO2在高温度高压下均可保持良好的力学性能。不同压强下,UO2定容热容均随温度迅速增大,并在1000 K 附近趋近于杜隆-佩蒂特极限。德拜温度则随温度降低,随压强升高。在低于室温条件下,热膨胀系数随温度急剧增加;温度继续增加,系数的增加趋势则逐渐变缓。计算结果还表明,UO2的热膨胀系数在相同条件下,远小于其他核材料。     

First-principles investigation on the structural and elastic properties of cubic-Fe_2 TiAl under high pressures

The structural, elastic, and thermodynamic properties of cubic-Fe 2 TiAl under high temperatures and pressures are investigated by performing ab initio calculation and using the quasi-harmonic Debye model. Some ground state properties such as lattice constant, bulk modulus, pressure derivative of the bulk modulus, and elastic constants are in good agreement with the available experimental results and theoretical data. The thermodynamic properties of Fe 2 TiAl such as thermal expansion coefficient, Debye temperature, and heat capacity in ranges of 0 K-1200 K and 0 GPa-250 GPa are also obtained. The calculation results indicate that the heat capacities at different pressures all increase with temperature increasing and are close to the Dulong-Petit limit at higher temperatures, Debye temperature decreases with temperature increasing, and increases with pressure rising. The cubic-Fe 2 TiAl is stable mechanically under 250 GPa. Moreover, under lower pressure, thermal expansion coefficient rises rapidly with temperature increasing, and the increasing rate becomes slow at higher pressure.     

He原子掺杂铝材料的第一性原理研究

采用基于第一性原理的平面波超软赝势方法,结合广义梯度近似(GGA),计算了铝及铝晶胞间隙位置掺入He原子后体系的几何结构、电子结构、总体能量和电荷布居值.计算结果表明:随着氦在金属铝中逐渐形成,铝晶胞体系会发生晶格畸变,但总的趋势是He在铝体系的八面体位置的晶格畸变小于其在四面体位置的晶格畸变.He在铝晶胞八面体和四面体间隙的杂质形成能分别为1.3367 eV和2.4411 eV.由此可知,He在铝晶胞中最稳定位置是八面体间隙位置.同时,文中还从原子尺度层面分析了He原子在铝晶胞中的占位及其键合性质,讨论 关键词： 铝材料 第一性原理 形成能     

ZrV2结构、弹性和热力学性质的第一性原理计算

采用基于密度泛函理论的第一性原理平面波赝势方法研究ZrV₂的晶体结构和弹性,利用准谐Debye模型计算在不同温度(T=0~1200 K)和不同压强(P=0~20 GPa)下ZrV₂的热力学性质,包括弹性模量与压强,热熔与温度,以及热膨胀系数与温度和压力的关系.结果表明:计算的ZrV₂晶格常数与实验值符合较好,晶体材料的弹性常数随着压力增加而增加;在一定温度下,相对体积、热熔随着压强的增加而减小,德拜温度、弹性模量随着压强的增加而增加,且高压下温度对ZrV₂热膨胀系数的影响小于压强的影响.