Development of a Simulation Model for Solid Objects Suspended in a Fluctuating Fluid

We introduce a new scheme for the future application of Real-coded Lattice Gas (RLG) to the numerical simulation of suspended solid objects in a fluctuating fluid environment. The reproduction of Brownian motion for a single solid object is verified through the Gaussian distribution of its displacements. The effectiveness of the solid–solid interaction model is also confirmed in an N-body simulation.     

Fibre raman amplifier properties for applications to long-distance optical communications

This paper reviews recent theoretical and experimental studies on optical amplification by stimulated Raman scattering (Raman amplification) in single-mode optical fibres, and discusses its possible applications to long-distance optical communications. The fibre Raman amplifier can be used as an in-line optical amplifier in both repeaterless and non-regenerative all-optical repeater configurations. In the former application, signal transmission of over 400 km has been predicted theoretically, although high-power pump sources are considered to be required. In the latter configuration, in which optical fibre losses are compensated for by Raman gains, it has been shown that extremely long-distance transmission over more than 1000 km is feasible in terms of signal-to-noise ratio, where the distance achievable is mainly limited by the accumulation of Raman noise. Recent experimental demonstrations including bit-error rate measurements on the Raman amplified signal, and laser-diode pumped amplification, etc., are also reviewed. The results confirm the effectiveness of fibre Raman amplifiers in future long-haul systems.     

Direct observation of chemical oscillation at a water/nitrobenzene interface with a sodium-alkyl-sulfate system.

The oscillation of the interfacial tension and electrical potential at a water/nitrobenzene interface was observed with homologous anionic surfactant molecules, sodium-alkyl-sulfates. Concerning small molecules with a short hydrophobic carbon chain, the oscillation period and amplitude decreased with a decrease of the length of the alkyl chain. On the other hand, when surfactant molecules with a long hydrophobic carbon chain were used, no remarkable periodic oscillation occurred after the first oscillation. In all systems, an interfacial flow by Marangoni convection was observed when the oscillation took place. By monitoring the movement of carbon powder scattered on the liquid/liquid interface with a CCD camera, we could observe that the liquid/liquid interface expanded outward from the area on which the surfactant molecules adsorbed when the oscillation occurred. When the small molecule was used, the speed of expansion of the interface (flow speed) was small and shrinkage followed by expansion of the interface repeatedly occurred. However, when the large molecule was used, the flow speed was large and expansion occurred only one time. These results show that hydrodynamic factors and surface activities are important in chemical oscillation systems.     

Novel UV‐induced photografting process for preparing poly(tetrafluoroethylene)‐based proton‐conducting membranes

A novel process comprising the UV‐induced photografting of styrene into poly(tetrafluoroethylene) (PTFE) films and subsequent sulfonation has been developed for preparing proton‐conducting membranes. Although under UV irradiation the initial radicals were mainly generated on the surface of the PTFE films by the action of photosensitizers such as xanthone and benzoyl peroxide, the graft chains were readily propagated into the PTFE films. The sulfonation of the grafted films was performed in a chlorosulfonic acid solution. Fourier transform infrared and scanning electron microscopy were used to characterize the grafted and sulfonated membranes. With a view to use in fuel cells, the proton conductivity, water uptake, and mechanical properties of the prepared membranes were measured. Even through the degree of grafting was lower than 10%, the proton conductivity in the thickness direction of the newly prepared membranes could reach a value similar to that of a Nafion membrane. In comparison with γ‐ray radiation grafting, UV‐induced photografting is very simple and safe and is less damaging to the membranes because significant degradation of the PTFE main chains can be avoided. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 2624–2637, 2007     

Validation of a method for predicting the precision, limit of detection and range of quantitation in competitive ELISA.

The mathematical model for predicting the precision, limit of detection (LOD) and range of quantitation (ROQ) in a competitive enzyme-linked immunosorbent assay (ELISA) proposed by Hayashi et al. (Anal. Chem., 2004, 76, 1295) was validated. The model describes the relative standard deviation (RSD) of concentration estimates by the RSDs of pipetting volumes of analyte, enzyme-conjugated antigen, antibody and substrate solutions, and the standard deviation (SD) of inherent absorbances between the wells in an ELISA plate. For 6 kinds of direct competitive ELISA kits, the LOD and ROQ predicted by the model agreed well with those obtained by experiments with real samples. It was also confirmed that the model is applicable to the prediction of uncertainty that depends on the pipetting error of the viscous antiserum solution. The model was demonstrated to be useful for estimating the LOD and ROQ of competitive ELISA.     

Design of a widely tunable laser with a chirped ladder filter

We theoretically investigated a digitally tunable laser with a chirped ladder filter and a ring resonator to obtain a wide wavelength tuning range covering the whole C- or L- band. The clear relation between the tuning range and laser structure, especially the ladder filter, is described analytically. The introduction of a chirped structure into a ladder filter is effective in achieving both wide tunability and a stable lasing mode. A numerical simulation based on multimode rate equations shows that a tuning range of over 40 nm and a mode suppression ratio over 40 dB can be achieved by introducing a chirped ladder filter.