Fibre raman amplifier properties for applications to long-distance optical communications

This paper reviews recent theoretical and experimental studies on optical amplification by stimulated Raman scattering (Raman amplification) in single-mode optical fibres, and discusses its possible applications to long-distance optical communications. The fibre Raman amplifier can be used as an in-line optical amplifier in both repeaterless and non-regenerative all-optical repeater configurations. In the former application, signal transmission of over 400 km has been predicted theoretically, although high-power pump sources are considered to be required. In the latter configuration, in which optical fibre losses are compensated for by Raman gains, it has been shown that extremely long-distance transmission over more than 1000 km is feasible in terms of signal-to-noise ratio, where the distance achievable is mainly limited by the accumulation of Raman noise. Recent experimental demonstrations including bit-error rate measurements on the Raman amplified signal, and laser-diode pumped amplification, etc., are also reviewed. The results confirm the effectiveness of fibre Raman amplifiers in future long-haul systems.     

Fabrication and transport properties of multiwall carbon nanotube crossroads

A multiwall carbon nanotube crossroads has been fabricated by a manipulation technique using a glass microcapillary, and the low temperature transport properties investigated. The two-terminal conductance of an individual tube shows Tomonaga–Luttinger liquid behavior G∝T^α at high temperature and dI/dV ∝V ^α at low temperature. However, no evidence of such a power-law behavior is obtained in the four-terminal conductance at the junction, where the conductance shows an almost metallic behavior ‘corrected’ by weak localization. Weak localization would essentially appear in electron states at the junctions of MWNTs.     

Design of a widely tunable laser with a chirped ladder filter

We theoretically investigated a digitally tunable laser with a chirped ladder filter and a ring resonator to obtain a wide wavelength tuning range covering the whole C- or L- band. The clear relation between the tuning range and laser structure, especially the ladder filter, is described analytically. The introduction of a chirped structure into a ladder filter is effective in achieving both wide tunability and a stable lasing mode. A numerical simulation based on multimode rate equations shows that a tuning range of over 40 nm and a mode suppression ratio over 40 dB can be achieved by introducing a chirped ladder filter.     

Local structure analysis of smoky and colorless topaz using single crystal Al NMR

The angular dependence of the ²⁷Al NMR spectrum was measured for single crystals of smoky and colorless topaz, Al₂SiO₄(F,OH)₂. Smoky topaz was obtained by irradiating high energy neutrons to colorless topaz. The quadrupole coupling constant e²Qq/h and the asymmetry parameter η were obtained from the analysis of the angular dependences of quadrupole splitting of the ²⁷Al NMR spectrum. The local structures around the aluminum atoms in smoky and colorless topaz were discussed from the magnitude and the direction of the electric field gradient. The directions of principal axes of the EFG tensor of ²⁷Al were close to the directions of Al-O and Al-F bonds. The difference in the bond lengths between Al(1)-F(1) and Al(1)-F(2) was found to affect the x and y components of the EFG tensor.     

Altered protein synthesis in rat kidney cells exposed to semiconductor materials

It is thought that the extensive industrial use of arsenic, gallium and indium, which have applications as the materials for III–V semiconductors, will increase human exposure to these compounds in the near future. We have undertaken the development of new biological indicators for assessing exposure to these elements. Element-specific alterations in protein synthesis patterns were expected to occur following exposure to arsenic compounds. We examined alterations in protein synthesis in primary cultures of rat kidney proximal tubule epithelial cells by sodium arsenite, gallium chloride and indium chloride, utilizing two-dimensional gel electrophoresis. After incubation with the chemicals for 20 h, newly synthesized proteins were labeled with [³⁵S]methionine. A protein with a molecular weight (M_r) of 30 000 was markedly induced on exposure to 10 μM arsenite or 300 μM gallium chloride, and synthesis of proteins with M_r values of 85 000, 71 000, 65 000, 51 000, 38 000 and 28 000 were also increased by exposure to arsenite and gallium chloride. No significant changes were observed upon exposure to indium. Some of these increased proteins could be heat-shock proteins.     

Purification and characterization of gamma-enolase from various mammals.

The gamma subunit of enolase (gamma-enolase) was purified from the brain tissues of cow, dog, goat, pig, rabbit, and rat. The purification was achieved in only three steps: ammonium sulfate-precipitation, DE 53 cellulose ion-exchange chromatography, and polyacrylamide gel electrophoresis (PAGE) in a preparative mode. The purification procedure was comparatively more simple than previously reported methods, and the yield of gamma-enolase was sufficient for subsequent structural and immunological analyses. In all mammals, the purified gamma-enolase migrated in sodium dodecyl sulfate-PAGE (SDS-PAGE) with a molecular mass of 46 kilodaltons (kDa), and the immunological cross-reactivity between those gamma-enolases was very strong. The structural homology of these gamma-enolases was examined by peptide mapping using cyanogen bromide cleavage and subsequent two-dimensional electrophoresis. The resulting peptide patterns were highly similar and in cow, dog, and goat, the patterns were almost identical. These results indicate that structural homology, that is, the species non-specificity of gamma-enolase, appears to be very high.     

Synthesis and properties of furo[4,3,2-de][1]benzopyran

A new heterocycle, furo[4,3,2-de][1]benzopyran ( 2 ), was synthesized. A key step in the sequence was the allylic bromination of 3,4-dihydrofuro[4,3,2-de][1]benzopyran ( 8 ) to give 3-bromo-3,4-dihydrofuro[4,3,2-de][1]-benzopyran ( 10 ) using N-bromosuccinimide under irradiation and high dilution conditions. Bromide 10 was dealt with 1,8-diazabicyclo[5.4.0]undec-7-ene to afford compound 2 . Several reactions of 2 were examined. Protonation of 2 in trifluoroacetic acid occurred at the 2-position to form a pyrylium ion 12 . Catalytic hydrogenation of 2 with palladium on charcoal proceeded smoothly to give 8 . Reduction of 2 by sodium and ethanol afforded 3-ethyl-4-hydroxybenzofuran ( 14 ). Electrophilic substitutions of 2 such as formylation, acetylation, and bromination, occurred easily at the 2-position. The above results show that compound 2 has both properties of benzofuran and 4-methylenepyran.     

Approximation of transient temperatures in complex geometries using fractional derivatives

It is shown that time-dependent temperatures in a transient, conductive system can be approximately modeled by a fractional-order differential equation, the order of which depends on the Biot number. This approximation is particularly suitable for complex shapes for which a first-principles approach is too difficult or computationally time-consuming. Analytical solutions of these equations can be written in terms of the Mittag-Leffler function. The approximation is especially useful if a suitable fractional-order controller is to be designed for the system.     

Phenomenon of labyrinth seal with low static pressure difference and large clearance

This paper discusses the straight-through type labyrinth seal. This labyrinth seal is used for axial flow fans, which h ave an outer ring at the blade tip to seal the clearance between the ring tip and the fan shroud, in order to prevent the reverse flow or leakage. These fans are used for the cooling of automobile radiators . In these cases, the labyrinth seal is used in an extremely low static pressure difference and a large clearance . A significant decrease of the leakage rate was reported even when the labyrinth seal rotated in comparatively low speed in this unique condition according to the authors’ former report. However, this phenomen on is differ ent from past research. Further more the cause of th is phenomenon has not been determined. Therefore, the internal flow was depicted with Computational Fluid Dynamics (CFD) in or der to clarify the ca use of this phenomenon. The results of CFD show that the leakage rate decreases significantly because the carry -over flow is intercepted in the expansion groove. This is the newly discovered phenomenon which occurs under the unique condition of an extremely low differential pressure. It has not been pointed out before as the reason why the rotation decreases the leakage rate.     

Electron g-factor in a gated InAs-inserted-channel In0.53Ga0.47As/In0.52Al0.48As heterostructure

We report on electron g-factor in an InAs-inserted In_0.53Ga_0.47As/In_0.52Al_0.48As heterostructure. The gate voltage dependence of g-factor is obtained from the coincidence method. The obtained g-factor values are surprisingly smaller than the g-factor value of bulk InAs, and it is close to the bare g-factor value of In_0.53Ga_0.47As. The large change in g-factor is observed by applying the gate voltage. The obtained gate voltage dependence is not simply explained by the energy dependence of g-factor.