Sc、Ce掺杂CrSi2的电子结构与光学性质的第一性原理

采用基于密度泛函理论的第一性原理赝势平面波方法对Sc、Ce单掺和共掺后CrSi₂的几何结构、电子结构、复介电函数、吸收系数和光电导率进行了计算。结果表明:Sc、Ce掺杂CrSi₂的晶格常数增大,带隙变小。本征CrSi₂的带隙为0.386 eV,Sc、Ce单掺及共掺CrSi₂的禁带宽度分别减小至0.245 eV、0.232 eV、0.198 eV,费米能级均向低能区移动进入价带。由于Sc的3d态电子和Ce的4f态电子的影响,Sc、Ce掺杂的CrSi₂在导带下方出现了杂质能级。掺杂后的CrSi₂介电函数虚部第一介电峰峰值增加且向低能方向移动,说明Sc、Ce掺杂使得CrSi₂在低能区的光跃迁强度增强,Sc-Ce共掺时更明显。Sc、Ce掺杂的CrSi₂吸收边在低能方向发生红移,在能量大于21.6 eV特别是在位于31.3 eV的较高能量附近,本征CrSi₂几乎不吸收光子,Sc单掺和Sc-Ce共掺CrSi₂吸收光子的能力有所增强,并在E=31.3 eV附近形成了第二吸收峰。说明掺杂Sc、Ce改善了CrSi₂对红外和较高能区光子的吸收。在小于3.91 eV的低能区掺杂后的CrSi₂光电导率增加。在20.01 eV<E<34.21 eV时,本征CrSi₂光电导率为零,但Sc、Ce掺杂后的体系不为零,掺杂拓宽了CrSi₂的光响应范围。研究结果为CrSi₂基光电器件的应用与设计提供了理论依据。     

梯级溃坝洪水洪峰增强机制

我国在多条河流上修建了大量梯级水库, 梯级坝溃决诱发洪水大大超过单坝溃决洪水洪峰, 因此亟需加深对梯级坝溃决洪水洪峰增强机制的认识. 本文建立了梯级坝溃决洪水演进过程的一维浅水动力学模型, 发展了一套能捕捉激波、干湿边界和保平衡结构的数值求解方法, 通过大量算例, 系统研究了梯级坝溃决洪水演进过程的质量转化和能量转化机制. 研究结果表明, 梯级溃决中, 上游溃决诱发的洪水大大增大下游水库的质量和动量, 形成一个带动量的水塔, 同时在尾部残留一个动量较大的射流, 不断补充下游坝体溃决后水塔的质量和动量, 持续维持洪峰高度. 根据该射流-水塔机制, 建立了梯级坝溃决洪水演进过程对应的射流-水塔单坝溃决洪水过程等效模型, 该等效模型基本反映了梯级坝溃决诱发洪水的洪峰过程, 并成功预测了多个坝间距为百公里量级的梯级坝溃决洪水洪峰高程和流量, 可望为流域防洪和梯级坝设计提供理论依据.      

有耗介质层上多导体传输线的电磁耦合时域分析方法

目前,针对空间电磁场作用有耗介质层上传输线的电磁耦合,仍缺乏有效的数值分析方法.因此,本文提出一种高效的时域混合算法,很好地解决了有耗介质层上传输线电磁耦合建模难的问题.首先,对经典传输线方程进行改进,推导了适用于有耗介质层上多导体传输线电磁耦合分析的修正传输线方程.然后,结合时域有限差分方法和相应插值技术,求解修正传输线方程,获得多导线及其端接负载上的电压和电流响应,并实现空间电磁场辐射与多导线瞬态响应的同步计算.最后,通过相应计算实例的数值模拟,与CST软件的仿真结果进行对比,验证了时域混合算法的正确性和高效性.     

Surface of room temperature ionic liquid [bmim][PF6] studied by polarization- and experimental configuration-dependent sum frequency generation vibrational spectroscopy

Understanding and control of the surface properties such as molecular orientations are of great importance in numerous applications of ionic liquids. However, there remain discrepancies among the previous experimental and theoretical studies on the surface orientation and structures of room temperature ionic liquids(RTIL) systems. In this article, the orientation of 1-butyl-3-methylimidazolium([bmin]) cation at the air/liquid interface of a characteristic RTIL, 1-butyl-3-methylimidazolium hexafluorophosphate([bmim][PF6]), was investigated by the sum frequency generation vibrational spectroscopy(SFG-VS). Detailed polarization and experimental configuration analyses of the SFG-VS spectra showed the possibility of a small spectral splitting in the CH3 symmetric stretching region, which can be further attributed to the probable existence of multiple orientations for the interfacial [bmim] cations. In addition, the(N)–CH3 vibrations were absent, ruling out the prediction by several recent molecular dynamics simulations which state that portions of the [bmim] cations orient with a standing-up(N)–CH3 group at the ionic liquid surface. Hence, new realistic theoretical models have to be developed to reflect the complex nature of the ionic liquid surface.     

Observation and analysis of near-surface atmospheric aerosol optical properties in urban Beijing

Year-round measurements of the mass concentration and optical properties of fine aerosols(PM_2.5) from June 2009 to May 2010 at an urban site in Beijing were analyzed.The annual mean values of the PM_2.5 mass concentration,absorption coefficient（Ab）,scattering coefficient（Sc） and single scattering albedo（SSA）at 525 nm were 67±66μg/m³,64 ±62 Mm^-1,360 ±405 Mm^-1 and 0.82 ±0.09,respectively.The bulk mass absorption efficiency and scattering efficiency of the PM_2.5 at 525 nm were 0.78 m²/g and 5.55 m²/g,respectively.The Ab and Sc showed a similar diurnal variation with a maximum at night and a minimum in the afternoon,whereas SSA displayed an opposite diurnal pattern.Significant increases in the Ab and Sc were observed in pollution episodes caused by the accumulation of pollutants from both local and regional sources under unfavorable weather conditions.Aerosol loadings in dust events increased by several times in the spring,which had limited effects on the Ab and Sc due to the low absorption and scattering efficiency of dust particles.The frequency of haze days was the highest in autumn because of the high aerosol absorption and scattering under unfavorable weather conditions.The daily PM_2.5concentration should be controlled to a level lower than 64 μg/m³ to prevent the occurrence of haze days according to its exponentially decreased relationship with visibility.     

Characteristics of black carbon aerosol in Jiaxing,China during autumn 2013

We conducted measurements of black carbon（BC） aerosol in Jiaxing,China during autumn from September 26 to November 30,2013.We investigated temporal and diurnal variations of BC,and its correlations with meteorological parameters and other major pollutants.Results showed that hourly mass concentrations of BC ranged from 0.2 to 22.0 μg/m³,with an average of 5.1 μg/m³.The diurnai variation of BC exhibited a bimodal distribution,with peaks at 07:00 and 18:00.The morning peak was larger than the evening peak.The mass percentages of BC in PM_2.5 and PM₁₀ were 7.1%and 4.8%,respectively.The absorption coefficient of BC was calculated to be 44.4 Mm^-1,which accounted for 11.1%of the total aerosol extinction.BC was mainly emitted from local sources in southwestern Jiaxing where BC concentrations were generally greater than 11 μg/m³ during the measurement period.Correlation analysis indicated that the main sources of BC were motor vehicle exhaust,and domestic and industrial combustion.     

Ratiometric mode with dyads: a breakthrough in dynamic trapping and quantification for redox regulation in living cells

Redox-based post-translational modification of protein thiols has become an attractive strategy in cellular homeostasis and cell signaling.Due to the reductive end of the redox buffer network,the vicinal dithiol-containing proteins(VDPs)maintains an appropriate oxidation-reduction state of proteins through the reversible transformation from vicinal dithiols to disulfide,which is responsible for a variety of     

退火温度和溅射时间对磁控溅射法制备Mg2Si薄膜的影响

采用磁控溅射法和原位退火工艺在钠钙玻璃衬底上制备 Mg2Si 薄膜。首先在钠钙玻璃衬底上交替溅射沉积两层Si、Mg 薄膜，冷却至室温后原位退火4 h，制备出一系列 Mg2Si 薄膜样品。通过 X 射线衍射仪(XRD) 、 扫描电子显微镜(SEM)对所得薄膜样品的晶体结构和表面形貌进行表征， 讨论了退火温度和溅射Si/Mg/Si/Mg 时间对制备 Mg2Si 薄膜的影响。结果表明，采用磁控溅射法在钠钙玻璃衬底上交替溅射两层Si、Mg 薄膜， 通过原位退火方式成功制备出单一相的 Mg2Si 薄膜，溅射Si/Mg/Si/Mg 的时间为12.5/9/12.5/9 min，退火温度为550 ℃ 时，制备的 Mg2Si 薄膜结晶度最好，连续性和致密性最强。这对后续 Mg2Si 薄膜器件的设计与制备提供了重要的参考。 积两层Si、Mg 薄膜, 冷却至室温后原位退火4 h, 制备出一系列 Mg2Si 薄膜样品. 通过 X 射线衍射仪(XRD) 、 扫描 电子显微镜(SEM)对所得薄膜样品的晶体结构和表面形貌进行表征, 讨论了退火温度和溅射Si/Mg/Si/Mg 时间 对制备 Mg2Si 薄膜的影响. 结果表明, 采用磁控溅射法在钠钙玻璃衬底上交替溅射两层Si、Mg 薄膜, 通过原位退火 方式成功制备出单一相的 Mg2Si 薄膜, 溅射Si/Mg/Si/Mg 的时间为12.5/9/12.5/9 min, 退火温度为550 ℃ 时, 制 备的 Mg2Si 薄膜结晶度最好, 连续性和致密性最强. 这对后续 Mg2Si 薄膜器件的设计与制备提供了重要的参考.