Synthesis and Application of Low Molecular Weight PEI-Based Copolymers for siRNA Delivery with Smart Polymer Blends

Polyethylenimine (PEI) is a commonly used cationic polymer for small-interfering RNA (siRNA) delivery due to its high transfection efficiency at low commercial cost. However, high molecular weight PEI is cytotoxic and thus, its practical application is limited. In this study, different formulations of low molecular weight PEI (LMW-PEI) based copolymers polyethylenimine-g-polycaprolactone (PEI–PCL) (800 Da–40 kDa) and PEI–PCL–PEI (5–5–5 kDa) blended with or without polyethylene glycol-b-polycaprolactone (PEG–PCL) (5 kDa-4 kDa) are investigated to prepare nanoparticles via nanoprecipitation using a solvent displacement method with sizes ≈100 nm. PEG–PCL can stabilize the nanoparticles, improve their biocompatibility, and extend their circulation time in vivo. The nanoparticles composed of PEI–PCL–PEI and PEG–PCL show higher siRNA encapsulation efficiency than PEI–PCL/PEG–PCL based nanoparticles at low N/P ratios, higher cellular uptake, and a gene silencing efficiency of ≈40% as a result of the higher molecular weight PEI blocks. These results suggest that the PEI–PCL–PEI/PEG–PCL nanoparticle system could be a promising vehicle for siRNA delivery at minimal synthetic effort.     

Stereoselective methadone disposition after administration of racemic methadone to anesthetized Shetland ponies assessed by capillary electrophoresis

The enantioselectivity of the pharmacokinetics of methadone was investigated in anesthetized Shetland ponies after a single intravenous (0.5 mg/kg methadone hydrochloride; n = 6) or constant rate infusion (0.25 mg/kg bolus followed by 0.25 mg/kg/h methadone hydrochloride; n = 3) administration of racemic methadone. Plasma concentrations of l -methadone and d -methadone and their major metabolites, l - and d -2-ethylidene-1,5-dimethyl-3,3-diphenylpyrrolidine (EDDP), respectively, were analyzed by CE with highly sulfated γ-cyclodextrin as chiral selector and electrokinetic analyte injection from liquid/liquid extracts prepared at alkaline pH. In both trials, the d -methadone concentrations were lower than those of l -methadone and the d -EDDP levels were lower than those of L-EDDP. For the case of a single intravenous bolus injection, the plasma concentration versus time profile of methadone enantiomers was analyzed with a two-compartment pharmacokinetic model. l -methadone showed a slower elimination rate constant, a lower body clearance, and a smaller steady-state volume of distribution than d -methadone. d -methadone and d -EDDP were eliminated faster than their respective l -enantiomers. This is the first study that outlines that the disposition of racemic methadone administered to anesthetized equines is enantioselective.     

Sensory Perception of Non-Deuterated and Deuterated Organic Compounds

The chemical background of olfactory perception has been subject of intensive research, but no available model can fully explain the sense of smell. There are also inconsistent results on the role of the isotopology of molecules. In experiments with human subjects it was found that the isotope effect is weak with acetone and D₆-acetone. In contrast, clear differences were observed in the perception of octanoic acid and D₁₅-octanoic acid. Furthermore, a trained sniffer dog was initially able to distinguish between these isotopologues of octanoic acid. In chromatographic measurements, the respective deuterated molecule showed weaker interaction with a non-polar liquid phase. Quantum chemical calculations give evidence that deuterated octanoic acid binds more strongly to a model receptor than non-deuterated. In contrast, the binding of the non-deuterated molecule is stronger with acetone. The isotope effect is calculated in the framework of statistical mechanics. It results from a complicated interplay between various thermostatistical contributions to the non-covalent free binding energies and it turns out to be very molecule-specific. The vibrational terms including non-classical zero-point energies play about the same role as rotational/translational contributions and are larger than bond length effects for the differential isotope perception of odor for which general rules cannot be derived.     

甘油氧化的光谱电化学傅里叶变换衰减全反射谱红外光谱薄膜流动池中硼酸镍层厚度的优化

在碱性甘油电氧化反应中,利用电化学傅里叶变换衰减全反射谱红外光谱法,研究了薄膜流动池中滴注硼酸镍催化剂负载量对玻碳电极性能的影响.连续操作的径向流动池包括一个位于内反射元件上方50μm的钻孔电极,可实现红外光谱分析.这是在确定条件下对电催化剂进行简便和可重复筛选的一个适合的方法,同时还提供了对复杂反应(如甘油氧化)产物选择性的检测.通过对泵送电解液进行更耗时的定量高效液相色谱分析,结果表明,衰减全反射红外光谱法可快速鉴定产物.在层流条件下,水中使用0.1 M甘油和1 M KOH,流速为5μL min-1时,甘油转化率较高.转化率和选择性取决于催化剂的负载量,负载量又决定了催化剂层的厚度和粗糙度.由于在更粗糙的膜中停留时间更长有利于再吸附和C-C键断裂,因此当负载量最高达210μg cm-2时,甘油转化率为73％且甲酸选择性接近80％.当最低负载量为13μg cm-2时,甘油转化率达到63％,甲酸选择性降至60％,相应地,C2物种(如乙醇酸盐)选择性较高,为8％.因此,只有催化剂负载量较低时才能形成几微米厚度范围内的薄膜,此时才适合进行优质催化剂的筛选.     

Triostin A Derived Cyclopeptide as Architectural Template for the Alignment of Four Recognition Units

The DNA bisintercalator triostin A is structurally based on a disulfide-bridged depsipeptide scaffold that provides preorganization of two quinoxaline units in 10.5 Å distance. Triostin A analogues are synthesized with nucleobase recognition units replacing the quinoxalines and containing two additional recognition units in between. Thus, four nucleobase recognition units are organized on a rigid template, well suited for DNA double strand interactions. The new tetra-nucleobase binders are synthesized as aza-TANDEM derivatives lacking the N-methylation of triostin A and based on a cyclopeptide backbone. Synthesis of two tetra-nucleobase aza-TANDEM derivatives is established, DNA interaction analyzed by microscale thermophoresis, cytotoxic activity studied and a nucleobase sequence dependent self-aggregation investigated by mass spectrometry.     

An Arylazopyrazole‐Based N‐Heterocyclic Carbene as a Photoswitch on Gold Surfaces: Light‐Switchable Wettability,Work Function,and Conductance

A novel photoresponsive and fully conjugated N‐heterocyclic carbene (NHC) has been synthesized that combines the excellent photophysical properties of arylazopyrazoles (AAPs) with an NHC that acts as a robust surface anchor (AAP‐BIMe). The formation of self‐assembled monolayers (SAMs) on gold was proven by ToF‐SIMS and XPS, and the organic film displayed a very high stability at elevated temperatures. This stability was also reflected in a high desorption energy, which was determined by temperature‐programmed SIMS measurements. E‐/Z‐AAP‐BIMe@Au photoisomerization resulted in reversible alterations of the surface energy (i.e. wettability), the surface potential (i.e. work function), and the conductance (i.e. resistance). The effects could be explained by the difference in the dipole moment of the isomers. Furthermore, sequential application of a dummy ligand by microcontact printing and subsequent backfilling with AAP‐BIMe allowed its patterning on gold. To the best of our knowledge, this is the first example of a photoswitchable NHC on a gold surface. These properties of AAP‐BIMe@Au illustrate its suitability as a molecular switch for electronic devices.