对蓬安县三元水库大坝外坡裂缝产生的原因及整治工程的探讨

本文通过对蓬安县三元水库大坝外坡裂缝产生的原因分析，进而运用岩、土力学的理论与方法反算推论出了裂缝的产生不是深层坝体土滑动引起的，而是局部浅层坝体土在水的诱发作用下作蠕滑-拉裂变形所产生的。在明确了大坝裂缝产生的原因后，提出了一系列相应整治工程措施，以达到彻底根治裂缝和稳固大坝的目的。     

Ni基乙烷脱氢催化剂的性能及其改进

过渡金属Ni是地球上储量丰富的金属元素, 在加氢脱硫、重整制氢等催化领域应用非常广泛, 但是关于Ni基催化剂在烷烃脱氢方面的研究较少; 因此, 本工作采用不同的方法, 制备了三种结构的Ni基负载催化剂, 即尖晶石分解型、浸渍型和钙钛矿析出型, 并在700 ℃、C₂H₆-N₂气氛中和50 mL•min^-1气体流速下, 探索了它们的乙烷脱氢性能. 结果表明: 尖晶石分解型催化剂Ni_1-xCu_xCr₂O₄还原后在Cr₂O₃表面形成Ni-Cu合金颗粒, 能有效钝化Ni的C—C键断裂活性, 提高乙烯的选择性. Ni含量过高时, Ni不能有效地分散而形成大的金属团簇, 造成乙烷过度裂解, 乙烯选择性较低. 浸渍负载型催化剂Ni_xM_y/Al₂O₃ (M为Cu或Ag) 比表面积大, 表面活性位点分散, 但活性金属与载体结合力弱, 在高温下不稳定; Cu或Ag与Ni形成合金, 可有效提高乙烯选择性, Ag较Cu的效果更佳. 钙钛矿析出型催化剂LaCr_1-xNi_xO₃(LCNi-100x)在还原气氛中析出均匀细小的Ni颗粒, 其与基体结合力强, 抗积碳性能和稳定性较高; 含15% Ni的LCNi-15还原后(R-LCNi-15)表现出最好的催化性能, 乙烯产率最高(24%), 同时具有较好的抗积碳性能和稳定性以及氧化再生性.     

Bandt-Wang的一个定理的新证明

讨论格自仿Tile的边界结构,得到平面格自仿Tile的边界为简单闭曲线的一个充分条件;作为应用,给出Bandt-Wang的一个定理的新证明.     

一类广义Sierpinski海绵的填充测度

对于m≥2的任何整数m,本文定义了Rm中的一类广义Sierpinski海绵,同时给出了该类海绵的填充测度的计算公式.     

DETERMINATION OF THE PERIOD OF A TORSION PENDULUM BY THE FITTING METHOD IN REAL TIME

A phenomenological study on the fitting method in real time has been done, and the method was applied to process and analyze the extensive data of a long period torsion pendulum used to determine Newtonian gravitational constant G. The result shows that the fitting method in real time is effective to determine the period of a torsion pendulum with a relative precision of 10^-5 orders.     

Measurement of the Floor Tilt in Experimental Determination of the Gravitational Constant

A prototype of a device with an impact structure for measuring the floor tilt has been built in our laboratory. The mechanical construction and the capacitive transducer of the device are introduced. Experimental results indicate that the floor tilt is about 16#tad in our cavity laboratory, and the uncertainty AG/G caused by such tilt is less than 0.54 parts per million (ppm), so the floor tilt can be reasonably neglected in the experimental determination of the gravitational constant G with the total uncertainty of about l0ppm.     

OPTIMUM DURATION OF MEASUREMENT FOR REDUCING THERMAL NOISE LIMITATIONS IN TORSION PENDULUM EXPERIMENTS

Statistical estimates of thermal noise fluctuation of a linear harmonic oscillator used to detect weak forces are reexamined with special reference to gravitational experiments. Thermal noise limitation on the measurement of displacement of an oscillator is studied. It is found that the signal response of an oscillator reaches the maximum value while the thermal noise response reaches the minimum value at the same time during the transient state of the oscillator, and the precision of the experiments in the transient state could increase about two orders higher than that in the equilibrium state for typical experiments. It is also found that there is an optimum duration of measurement in which the uncertainty due to thermal noise in this period is the least.     

基于曲线拟合的亚像素边缘定位方法的研究

图像的边缘定位是图像测量的关键之一,随着测量精度要求的提高,已由早期的像素级边缘定位发展到了现在的亚像素级边缘定位。根据地球在地球敏感器CCD阵面中的成像特性,提出了一种基于曲线拟合的亚像素边缘定位方法以获取地球“灼热圆盘”的边缘。该方法利用曲线拟合获得的拟合斜率以及灰度值来提取图像的边缘。仿真结果表明,采用曲线拟合亚像素边缘定位法可使图像的边缘定位精度达到百分之几个像素,具有较高的精度。     

相对于准静止参照系的有源阻尼系统研究 *

利用扭杆弹簧构成一个垂直方向上的准静止参照系 ,并用它成功地主动阻尼了单级振子的垂直本征模式 .在保持系统的高频隔振性能的情况下 ,使单级振子的垂直共振峰幅值从 3×10 ^-8m/Hz^{1/ 2} 下降到 2×10 ^-9m/Hz^{1/ 2} .这一实验结果验证了相对于准静止参照系的有源阻尼方法是完全可行的.     

两个含有平行交替链的新型二氰胺配位高聚物: {Mn(dmpz)[N(CN)2]2}2和{Cu(dmpz)[N(CN)2]2}2

Two new dicyanamide coordination polymers, {Mn(dmpz)[N(CN)2]2}2 (1) and {Cu(dmpz)[N(CN)2]2}2 (2)(dmpz=3,5-dimethylpyrazole), were synthesized and characterized by single crystal X-ray diffraction analysis and IR spectroscopy. In 1 and 2 the metal ions have two different coordination modes, where one is coordinated to four dicyanamide anions and two monodentate dmpz molecules to form a slightly distorted octahedral geometry, while the other adopts octahedral geometry, surrounded by four nitrile N atoms and two amide N atoms of the dicyanamide anions. Both complexes contain two alternating chains that are parallel to each other.