Enzymatic bleaching of organosolv sugarcane bagasse pulps with recombinant xylanase of the fungus Humicola grisea and with commercial cartazyme HS xylanase

Organosolv (ethanol/water and acetosolv) pulps were treated with Humicola grisea var. thermoidea and compared with Cartazyme HS xylanase-treated pulp. The ethanol/water pulps treated with H. grisea had the same viscosity as unbleached pulps (8 cP). Ethanol/water pulps treated with Cartazyme had higher viscosity than H. grisea-treated pulps (12 cP). Acetosolv pulps treated with H. grisea and Cartazyme presented a reduction in viscosity; however, the pulps treated with H. grisea had a lower reduction in viscosity than Cartazyme-treated pulps. Ethanol/water pulps treated with H. grisea had a 23% reduction in kappa number in 4 and 8 h of treatment, compared with the unbleached pulps. Cartazyme-treated pulps had a kappa number similar to that of the control pulps for 4 h of treatment. Extending the treatment time to 12 h resulted in a reduction of 33%. The acetosolv pulp treated with H. grisea had a kappa number reduced to 23% in 4 h. Cartazyme treatment resulted in a reduction of 55 and 44% in kappa number for 4 and 8 h of treatment, respectively, when compared with control pulp. Extending the treatment time to 12 h decreased the kappa number 72%. Fourier transform infrared spectra and principal component analysis showed differences among unbleached, H. grisea-treated, and Cartazyme-treated pulps.     

Evaluation of indoor exposition to benzene, toluene, ethylbenzene, xylene, and styrene by passive sampling with a solid-phase microextraction device

A solid-phase microextraction (SPME) sampling method is developed to evaluate indoor exposure to benzene, toluene, ethylbenzene, xylene, and styrene with gas chromatography and flame ionization detection for quantitative analysis. An SPME holder with a 100-pm polydimethylsiloxane (PDMS) and 65-pm PDMS-divinylbenzene fiber coating is tested in different air relative humidity conditions. The method gives good resolution, shows a linear response, is repeatable, and presents high sensitivity. This method is compared with National Institute of Occupational Safety and Health (NIOSH) active sampling.     

Kinetics and mechanistic aspects of the Heck reaction promoted by a CN-palladacycle

In the Heck reaction between aryl halides and n-butyl acrylate, the palladacycle {Pd[kappa(1)-C, kappa(1)-N-C=(C(6)H(5))C(Cl)CH(2)NMe(2)](mu-Cl)}(2), 1, is merely a reservoir of the catalytically active Pd(0) species [1](Pd colloids or highly active forms of low ligated Pd(0) species) that undergoes oxidative addition of the aryl halide on the surface with subsequent detachment, generating homogeneous Pd(II) species. The main catalytic cycle is initiated by oxidative addition of iodobenzene to [1], followed by the reversible coordination of the olefin to the oxidative addition product. All the unimolecular subsequent steps are indistinguishable kinetically and can be combined in a single step. This kinetic model predicts that a slight excess of alkene relative to iodobenzene leads to a rapid rise in the Pd(0) concentration while when using a slight excess of iodobenzene, relative to alkene, the oxidative addition product is the resting state of the catalytic cycle. Competitive experiments of various bromoarenes and iodoarenes with n-butyl acrylate catalyzed by 1 and CS, CP, and NCN palladacycles gave the same rho value (2.4-2.5 for Ar-Br and 1.7-1.8 for Ar-I) for all palladacycles employed, indicating that they generate the same species in the oxidative addition step. The excellent fit of the slope with the sigma(0) Hammett parameter and the entropy of activation of -43 +/- 8 J mol(-1) K(-1) are consistent with an associative process involving the development of only a partial charge in the transition state for the oxidative step of iodobenzene.     

Identifying defective sets using queries of small size

We examine the following version of a classic combinatorial search problem introduced by Rényi: Given a finite set $X$ of $n$ elements we want to identify an unknown subset $Y$ of $X$, which is known to have exactly $d$ elements, by means of testing, for as few as possible subsets $A$ of $X$, whether $A$ intersects $Y$ or not. We are primarily concerned with the non-adaptive model, where the family of test sets is specified in advance, in the case where each test set is of size at most some given natural number $k$. Our main results are nearly tight bounds on the minimum number of tests necessary when $d$ and $k$ are fixed and $n$ is large enough.     

A Global Newton Method for the Nonsmooth Vector Fields on Riemannian Manifolds

Journal of Optimization Theory and Applications - This paper proposes and analyzes a globalized version of the Newton method for finding a singularity of the nonsmooth vector fields. Basically, the...     

Evaluation of gamma irradiation effect on physico-chemical properties of a mixed beverage based in soy milk and grape juice

The effects of the main operation variables on the electrochemical oxidation of simulated tributyl phosphate (TBP) waste by a boron-doped diamond anode are individually studied. The optimum operating conditions are obtained as follows: 4 g L^?1 initial TBP concentration, 180 min degradation time, 40 mA cm^?2 current density, 0.5 mol L^?1 Na₂SO₄ as the supporting electrolyte, and unadjusted pH of the aqueous phase. Under such conditions, a chemical oxygen demand (COD) removal ratio of 82.3% is achieved, and the energy consumption is 26.16 kWh m^?3. A degradation mechanism of TBP is tentatively proposed.     

Thermal and morphological characterization of highly porous nanocomposites for possible application in potassium controlled release

The use of fertilizer and water availability are essential factors limiting the agricultural production. The controlled release technology is very promising because it allows the maintenance of fertilizer concentrations within an ideal range avoiding inefficiency and toxicity problems, minimizing the environmental impacts and improving their efficiency. In this context, the nanostructured hydrogels appear as a possible carrier vehicle for these controlled release systems due to their inherent properties, such as biodegradability, low toxicity, and cost, rapid absorption and desorption controlled capacity of water and solutes. In this work, we performed the synthesis of nanostructured hydrogels based on poly(methacrylic acid) (PMAA)/Cloisite-Na⁺ via free radical polymerization. SEM images indicated a similarity in the basic structure of all nanocomposites. The porous diameter of the hydrogels increased with increasing of nanoclay content. EDS analysis showed the ions belonging to nanoclay present in the nanocomposites, confirming the formation of true nanocomposites. TG–DTG and DSC techniques confirmed an improvement in the thermal stability of nanocomposites caused by the addition of nanoclay. For instance, the degradation initial temperature of the hydrogel was increased from 198.5 to 203.5 °C, and inversely, the degradation rate of the 2° thermal event was decreased from 0.694 to 0.472% min °C^?1, when the nanoclay was increased from 0 to 20 mass/%. Moreover, the controlled release investigation showed an improvement in the release time and quantity of the fertilizer released with nanoclay content. This result is very required for this specific application.     

k-Point semidefinite programming bounds for equiangular lines

Mathematical Programming - We propose a hierarchy of k-point bounds extending the Delsarte–Goethals–Seidel linear programming 2-point bound and the Bachoc–Vallentin semidefinite...     

Catalytic enantioselective arylation of aldehydes: boronic acids as a suitable source of transferable aryl groups

The catalytic enantioselective arylation of several aldehydes using boronic acids as the source of transferable aryl groups is described; the reaction is found to proceed in excellent yields and high enantioselectivities (up to 97% ee) in the presence of a chiral amino alcohol.     

119Sn-Mössbauer spectroscopic studies on organoheterobimetallic half sandwich ruthenium–tin containing derivatives

A series of heterobimetallic complexes containing Ru–Sn bonds, of general formula [RuCp(L)₂SnX₂Y] [L = PPh₃, 1/2 dppe = 1,2-bis(diphenylphosphino)ethane; X, Y = F, Cl and Br], was prepared and studied by elemental analysis, ¹¹⁹Sn-Mössbauer spectroscopy, i.r. and ¹H-, ¹³C-, ¹⁹F-, ³¹P- and ¹¹⁹Sn-n.m.r. spectroscopy. ¹¹⁹Sn-Mössbauer studies allowed determination of the coordination number of the Sn^II center as well as the group electronegativity of the organometallic fragment [RuCp(L)₂]⁺. These results, supported by multinuclear n.m.r. data suggested that the electronic charge distribution between the Ru^II and Sn^II centers are strongly dependant upon the nature of L and the electronegativity of X and Y.