DETERMINATION OF BUCKUNG MODE AND EXPLICIT EXPRESSION OF CRITICAL LOAD FOR SIMPLY SUPPORTED RECTANGULAR ORTHOTROPIC PLATES UNDER BIAXIAL COMPRESSION

C. Libove proved that at least one of the halfwave numbers m and n in x and y directions of the buckling mode will be 1 for simply supported rectangular orthotropic plates under biaxial compression. This paper will give the physical conditions of m=1 or n=1, and, at the same time, show the way of finding appropriate value of m when n=1 and that of n when m=1 and even lead to explicit expression for m andn. Thus, the buckling mode may be determined completely and the expression of critical load may be formlated explicitly.     

在远离光子晶体光纤零色散波长的正常色散区入射飞秒脉冲产生四波混频及孤子效应的实验研究

在远离光子晶体光纤零色散波长的正常色散区入射飞秒脉冲,实验产生了一对由四波混频引起的信号波带和闲频波带,及一对由脉冲内拉曼散射和非孤子辐射引起的孤子和色散波带,并观察到功率饱和现象.利用有限元法理论模拟了光纤的色散和非线性特性,用四波混频的相位匹配条件模拟了光纤在满足相位匹配条件下所产生的信号波带和闲频波带出现的可能位置,并与实验结果符合得很好.结果表明:即使在光子晶体光纤的正常色散区抽运激光脉冲亦可以产生四波混频和孤子效应;研究发现四波混频的产生是由四阶色散参量引起的;并进一步从理论上解释了孤子及色散波的产生原因.     

Designing of a polarization beam splitter for the wavelength of 1310 nm on dual-core photonic crystal fiber with high birefringence and double-zero dispersion

We have proposed a novel kind of photonic crystal fiber which contains two asymmetric cores. The bireti＇ingence and the dispersion are numerically analyzed based on finite element method when the size of the air holes and the pitch of two adjacent air holes are changed. It is shown that the proposed photonic crystal fiber has high birefringence up to the order of 10-2 and double-zero dispersion points are at the wavelengths of 1310 nm and 800 rim, simultaneously. At the same time, the normalized power and the extinction ratios of the proposed photonic crystal fiber have been simulated. It is demonstrated that, at the wavelength of 1310 rim, the x-polarized mode and the y-polarized mode are separated when the propagation distance is 2.481 ram.     

光强一定时饱和光电流随入射光频率的变化关系辨析

对光电效应实验中饱和光电流随入射光频率变化关系的几种谬误进行了辨析，给出了光强一定时饱和光电流随入射光频率变化的正确规律并作了解释。     

极小化完工时间和的有界批调度问题

考虑m台并行批加工同型机上n个带有释放时间的工件的调度问题,目标是极小化完工时间和.给出了一个多项时间近似方案.     

一种晶体光纤基模色散特性的矢量法分析

利用矢量有效折射率方法(矢量法)对光子晶体光纤基模的色散特性进行了数值模拟，并与双正交归一基矢量法以及标量有效折射率方法(标量法)的模拟结果进行了对比.发现所用矢量法的结果与双正交归一基矢量法的结果符合很好，而标量法在低空气填充率f或较高归一化波数A/λ时是一种较好的近似，在空气填充率f较高或归一化波数A/λ较低时，要得到精确的结果必须利用矢量法对光子晶体光纤的特性进行模拟.讨论了光子晶体光纤包层有效折射率与光纤结构的关系. 关键词： 光子晶体光纤 矢量法 有效折射率 色散     

四边简支正交异性板双向压屈模态的确定及其临界载荷的显式表达式

Libove曾经证明,四边简支的正交异性板在双向压力下的屈曲模态沿x方向和y方向的半波数m和n这两者中必有一者为1.本文将给出m=1或n=1的条件,并确定n=1时m的取值,及m=1时n的取值.从而完全确定了四边简支正交异性板在双向压力下的屈曲模态,并给出了临界载荷的显式表达式.     

Investigation on Guided-Mode Characteristics of Hollow-Core Photonic Crystal Fibre at Near-Infrared Wavelengths

Guided-mode characteristics of hollow-core photonic crystal fibre （HC-PCF） are experimentally and theoretically investigated. The transmission spectrum in the range from 755 to 845nm is observed and the loss is measured to be 0.12dB/m at 800nm by cut-back method. Based on the full-vector beam propagation method and the full-vector plane-wave method, the characteristics of mode field over propagation distance 1 m are simulated, and the results show that the propagation efficiency can be above 80%. Compared with the fundamental guided mode well confined in air core within shorter propagation distance, the second-order guided mode leaks into the cladding region and gradually attenuates due to larger refractive index difference. The primary loss factors in HC-PCF and the corresponding solutions are elementarily discussed.     

HPLC-ELSD法测定生物柴油中游离甘油含量

建立了高效液相色谱(HPLC)-蒸发光散射(ELSD)法测定生物柴油中游离甘油的方法。用水萃取生物柴油中的甘油,选用强酸型阳离子交换柱(Ultimate XB-SCX)分离甘油和杂质,流动相为乙腈-水(25:75,V:V),柱温35℃;ELSD漂移管温度30℃,载气压力360 kPa。结果表明:在7.12～307.31 mg/kg范围内,甘油峰面积和其浓度的对数具有良好的线性相关性,相关系数r为0.9929。甘油的回收率为96.3%～105.6%,RSD均小于2.0%(n=5)。最低检测限(LOD)和最低定量限(LOQ)分别为2.50 mg/kg、7.12 mg/kg。该研究为生物柴油中游离甘油的提取和检测提供了一种快速高效的方法。     

全波段正常色散光子晶体光纤中超连续谱的产生

设计了一种铅硅酸盐SF57 材料的光子晶体光纤, 利用有限元法数值模拟了该光纤的 色散特性. 研究结果显示在整个透明波段光纤具有正常色散. 利用自适应分布傅里叶法求解非线性薛定谔方程, 对中心波长为1550 nm, 初始脉宽为150 fs 的脉冲在该光纤中传输进行了模拟, 获得了关于入射脉冲中心波长对称的展宽范围超过了600 nm 的超平坦连续光谱, 并且光谱具有极其稳定和 相干的特性. 关键词： 光子晶体光纤 超连续谱产生 正常色散