Vibrations of a continuous web on elastic supports

We consider an infinite, homogenous linearly elastic beam resting on a system of linearly elastic supports, as an idealized model for a paper web in the middle of a cylinder-based dryer section. We obtain closed-form analytical expressions for the eigenfrequencies and the eigenmodes. The frequencies increase as the support rigidity is increased. Each frequency is bounded from above by the solution with absolutely rigid supports, and from below by the solution in the limit of vanishing support rigidity. Thus in a real system, the natural frequencies will be lower than predicted by commonly used models with rigid supports.     

Synthesis and biomimetic mineralization of l‐proline substituted polyphosphazenes as bulk and nanofiber

This work presents the synthesis of polyphosphazenes bearing L ‐proline methyl ester (ProOMe) and 4‐hydroxy‐l ‐proline methyl ester (HypOMe), aiming for new bioactive polymers for bone repair. The polymers were characterized by ¹H and ³¹P NMR, FTIR, DSC, and TGA. Electrospun fibers were prepared using poly[bis(l ‐proline methyl ester)phosphazene] (PProP), and their potential for biomimetic mineralization, as well as the bulk material, were tested in simulated body fluid (1×SBF). Samples were analyzed between 24 h and 3 weeks of incubation using SEM/EDS and FTIR. After 24 h, spherical and flower‐like shapes of calcium phosphates (CaP) were crystallized on the bulk samples. The nanofibers presented spherical CaP crystals attached to them after 48 h of incubation. The Ca/P molar ratio of the crystals varied from 1.5 to 1.6. According to this study, PProP presents bioactivity in vitro, and its fibers offer sites for CaP nucleation like the collagen fibers in bone. © 2013 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2013 , 51, 1318–1327     

On applicability of PCA,voxel-wise variance normalization and dimensionality assumptions for sliding temporal window sICA in resting-state fMRI

Subject-level resting-state fMRI (RS-fMRI) spatial independent component analysis (sICA) may provide new ways to analyze the data when performed in the sliding time window. However, whether principal component analysis (PCA) and voxel-wise variance normalization (VN) are applicable pre-processing procedures in the sliding-window context, as they are for regular sICA, has not been addressed so far. Also model order selection requires further studies concerning sliding-window sICA. In this paper we have addressed these concerns. First, we compared PCA-retained subspaces concerning overlapping parts of consecutive temporal windows to answer whether in-window PCA and VN can confound comparisons between sICA analyses in consecutive windows. Second, we compared the PCA subspaces between windowed and full data to assess expected comparability between windowed and full-data sICA results. Third, temporal evolution of dimensionality estimates in RS-fMRI data sets was monitored to identify potential challenges in model order selection in a sliding-window sICA context. Our results illustrate that in-window VN can be safely used, in-window PCA is applicable with most window widths and that comparisons between windowed and full data should not be performed from a subspace similarity point of view. In addition, our studies on dimensionality estimates demonstrated that there are sustained, periodic and very case-specific changes in signal-to-noise ratio within RS-fMRI data sets. Consequently, dimensionality estimation is needed for well-founded model order determination in the sliding-window case. The observed periodic changes correspond to a frequency band of ≤ 0.1 Hz, which is commonly associated with brain activity in RS-fMRI and become on average most pronounced at window widths of 80 and 60 time points (144 and 108 s, respectively). Wider windows provided only slightly better comparability between consecutive windows, and 60 time point or shorter windows also provided the best comparability with full-data results. Further studies are needed to determine the cause for dimensionality variations.     

Estimates for Divergence Velocities of Axially Moving Orthotropic Thin Plates

Some models for axially moving orthotropic thin plates are investigated analytically via methods of complex analysis to derive estimates for critical plate velocities. The linearized Kirchhoff plate theory is used, and the energy forms of steady-state models are considered with homogeneous and inhomogeneous tension profiles in the cross direction of the plate. With the help of the energy forms, some limits for the divergence velocity of the plate are found analytically. In numerical examples, the derived lower limits for the divergence velocity are analyzed for plates with small flexural rigidity.     

Principles and calibration of collinear photofragmentation and atomic absorption spectroscopy

The kinetics of signal formation in collinear photofragmentation and atomic absorption spectroscopy (CPFAAS) are discussed, and theoretical equations describing the relation between the concentration of the target molecule and the detected atomic absorption in case of pure and impure samples are derived. The validity of the equation for pure samples is studied experimentally by comparing measured target molecule concentrations to concentrations determined using two other independent techniques. Our study shows that CPFAAS is capable of measuring target molecule concentrations from parts per billion (ppb) to hundreds of parts per million (ppm) in microsecond timescale. Moreover, the possibility to extend the dynamic range to cover eight orders of magnitude with a proper selection of fragmentation light source is discussed. The maximum deviation between the CPFAAS technique and a reference measurement technique is found to be less than 5 %. In this study, potassium chloride vapor and atomic potassium are used as a target molecule and a probed atom, respectively.     

Nanofibrillated cellulose/carboxymethyl cellulose composite with improved wet strength

In this paper, nanofibrillated cellulose/carboxymethyl cellulose (CMC) composite films were prepared using tape casting. The obtained transparent films showed shear induced partial alignment of fibrils along the casting direction, resulting in birefringence in cross polarized light. The carboxyl groups of CMC could be further utilized to create ionic crosslinking by treatment with glycidyl trimethyl ammonium chloride (GTMA). The GTMA treated composite films had improved mechanical properties both in wet and dry state. The chemical composition and morphologies of composites were analyzed with X-ray photoelectron spectroscopy, elemental analysis, scanning electron microscopy and wide-angle X-ray scattering.