排序方式: 共有13条查询结果,搜索用时 15 毫秒
1.
提出了一种基于微流控芯片的生物样品循环给样方法,利用聚二甲基硅氧烷(PDMS)软光刻工艺制作了包括环形蠕动微泵和电磁微阀的微流控芯片,通过与免疫探针芯片的集成,实现了对探针芯片的循环给样及在其上的免疫样品富集。采用不同浓度的羊抗兔IgG(FITC标记)样品与兔IgG探针免疫结合3 min,得到循环流动比静态吸附的荧光光强值更高,可使检出限降低。对于50 mg/L羊抗兔IgG样品,流速从130μL/min增至300μL/min时,免疫结合的速度明显加快,可使同一时刻的检出限降低;而样品浓度提高到200 mg/L时,增大流速对免疫反应的促进效果弱于低浓度时的变化。在样品浓度50 mg/L和循环流速300μL/min的条件下,循环给样方式仅需7μL样品溶液就得到了与持续进样约1.8 mL样品溶液基本一致的结果。 相似文献
2.
Characterization of a velocity-tunable 87Rb cold atomic source with a high-speed imaging technology 下载免费PDF全文
This paper has developed and characterized a method to produce a velocity-tunable 87 Rb cold atomic source for atomic interferometry application.Using a high speed fluorescence imaging technology,it reports that the dynamic process of the atomic source formation is observed and the source performances including the flux and the initial velocity are characterized.A tunable atomic source with the initial velocity of 1.4~2.6 m/s and the atomic source flux of 2 × 10 8 ~ 6 × 10 9 atoms/s has been obtained with the built experimental setup. 相似文献
3.
本文提出一种利用磁光阱冷却捕获技术制备低速、连续、单色性好原子束的方法及技术.采用3维磁光阱从背景Rb蒸汽中捕获Rb87原子进行冷却、捕获形成原子云团,利用在纵向方向上结构设计的小孔将冷原子云团推出形成冷原子束,并在原子束行进方向上采用2维光学黏胶对原子束进行准直,采用态制备激光对其进行态制备,全部制备到Rb87原子的基态能级|F=1>上,从而为原子惯性技术(原子干涉仪、原子重力仪、原子加速度计)、原子频标(原子钟)提供低速、连续、单色性好的原子束.文章对于制备技术的实验系统及实验结果进行了详细的阐述. 相似文献
4.
5.
微流体驱动与控制技术研究进展 总被引:31,自引:2,他引:29
随着微流体系统,尤其是生物芯片和缩微芯片实验室
(lab-on-a-chip)技术的发展,微米乃至纳米尺度构件中流体的驱动与
控制技术越来越引起人们的注意.由于微流体流动的影响因素众多,它
的驱动和控制技术,与宏观流体相比,更为复杂和多样化.本文首先结
合流体的驱动和控制技术,并着眼于微观与宏观的不同,对微流体的流
动特性进行了分析,然后对目前微流体驱动与控制技术的研究进展进行
了总结,对各种微流体的驱动和控制技术进行了对比,并对他们各自的
优缺点进行了分析和讨论. 相似文献
6.
探讨了聚合物对碳纳米管的不同表面修饰作用,总结了聚合物对碳纳米管的共价与非共价修饰方法,修饰后的碳纳米管在水溶液或不同极性有机溶剂、聚合物本体中的分散性得到了改善,更为碳纳米管的阵列化提供了前提.以碳纳米管的后排列为中心,主要综述了聚合物辅助下的碳纳米管垂直和水平方向上的定向排列方法,及近年来碳纳米管阵列化的研究进展,阐述了聚合物对碳纳米管的表面修饰及辅助碳纳米管实现阵列化的重要作用,提出了利用聚合物体系的自组织特性诱导碳纳米管自组装阵列化可以为实现单根碳纳米管的定向定位控制及纳米尺度功能器件的制备提供更多的可能. 相似文献
7.
Electrical characteristics and optoelectronic properties of metal--semiconductor--metal structure with zinc oxide nanowires across Au electrodes 下载免费PDF全文
This paper reports on a method of assembling semiconducting ZnO nanowires onto a pair of Au electrodes to construct a metal--semiconductor metal (MSM) structure by dieleetrophoresis and studying on its electrical characteristics by using current-voltage (Ⅰ - Ⅴ) measurements. An electronic model with two back to back Sehottky diodes in series with a semiconductor of nanowires was established to study the electrical transport of the MSM structures. By fitting the measured Ⅰ - Ⅴ characteristics using the proposed model, the parameters of the Schottky contacts and the resistance of nanowires could be acquired. The photoelectric properties of the MSM structures were also investigated by analysing the measurements of the electrical transports under various light intensities. The deduced results demonstrate that ZnO nanowires and their Schottky contacts with Au electrodes both contribute to photosensitivity and the MSM structures with ZnO nanowires are potentially applicable for photonic devices. 相似文献
8.
9.
一种基于介质上电润湿效应的免疫检测芯片研究 总被引:1,自引:0,他引:1
利用微机械加工技术,在ITO玻璃上设计制作了基于介质上电润湿效应的以离散液滴为对象的免疫检测芯片,对芯片的液滴驱动特性、免疫反应参数进行了测试,并对小鼠IgG和羊抗鼠IgG-HRP进行了初步的免疫测试.研究结果表明,在电压<100 V的时候,接触角测量值基本上和预测曲线吻合,在>100 V的情况下出现了接触角饱和现象,在芯片上实现了液滴操纵,120 V时得到最大平均速度为3.75 mm/s;该芯片可以实现免疫反应检测,所需样品体积为0.5 μL,检测时间约为20 min,对于羊抗鼠IgG-HRP实验系统的检测范围为0.1~20 mg/L. 相似文献
10.