A new method for atmospheric nitrogen dioxide measurements using the combination of a stripping coil and fluorescence detection.

A new stripping coil for the collection of nitrogen dioxide (NO2) has been developed to increase its versatility and efficiency. Nitrogen dioxide measurements based on quantitative collection through a reaction coil into an alkaline solution has been examined. Nitrogen dioxide is collected in a 0.1 N NaOH solution. This collection system has an efficiency of nearly 100%. The absorbed nitrogen dioxide has been measured by fluorescence detection with sub-ppbv detection limits. The excitation wavelength at 360 nm and the produced emission wavelength at 405 nm were suitable for nitrite ion measurements.     

Investigation of the drying conditions for amidosulfuric acid.

The drying conditions for primary standards of volumetric analysis have a significant effect on the titration results due to changes in the purity, stability and homogeneity. Amidosulfuric acid, a strong acid used as a reference material for volumetric analysis in Japan, was dried in a vacuum desiccator or heated at different temperatures, and then measured by Karl-Fischer titration, thermogravimetry/mass spectroscopy (TG-MS), ion chromatography and coulometric titration. The optimum drying conditions were at 50 degrees C for 24 h with crushing.     

Synthesis of New Lithium Ionic Conductor Thio-LISICON—Lithium Silicon Sulfides System

The new lithium ionic conductors, thio-LISICON (LIthium SuperIonic CONductor), were found in the ternary Li₂S-SiS₂-Al₂S₃ and Li₂S-SiS₂-P₂S₅ systems. Their structures of new materials, Li_4+xSi_1−xAl_xS₄ and Li_4−xSi_1−xP_xS₄ were determined by X-ray Rietveld analysis, and the electric and electrochemical properties were studied by electronic conductivity, ac conductivity and cyclic voltammogram measurements. The structure of the host material, Li₄SiS₄ is related to the γ-Li₃PO₄-type structure, and when the Li⁺ interstitials or Li⁺ vacancies were created by the partial substitutions of Al³⁺ or P⁵⁺ for Si⁴⁺, large increases in conductivity occur. The solid solution member x=0.6 in Li_4−xSi_1−xP_xS₄ showed high conductivity of 6.4×10^-4 S cm⁻¹ at 27°C with negligible electronic conductivity. The new solid solution, Li_4−xSi_1−xP_xS₄, also has high electrochemical stability up to ∼5 V vs Li at room temperature. All-solid-state lithium cells were investigated using the Li_3.4Si_0.4P_0.6S₄ electrolyte, LiCoO₂ cathode and In anode.     

Basic evaluation of highly sensitive thyroid stimulating hormone immunoradiometric assay kits

Usefulness of three kinds of TSH kits by immunoradiometric assay (IRMA) was evaluated. They were able to measure low levels (less than 0.1 microIU/ml) in serum thyroid stimulating hormone (TSH) with incubation of short time (4 hours). In particular, RIABEAD II kit had a highly specific affinity for TSH and the normal range (+/- 2 S.D.) using it showed from 0.20 to 3.50 microIU/ml in 150 normal subjects. In patients with hyperthyroidism and in patients with hypothyroidism, the values of TSH were lower and higher than those of normal subjects, respectively. Another kits showed similar results. These results indicate that these TSH-IRMA kits are useful to evaluate serum TSH levels exactly.     

Automatic semi-microcolumn liquid chromatographic determination of catecholamines in rat plasma utilizing peroxyoxalate chemiluminescence reaction

A fully automated and highly sensitive method with a semi-microcolumn liquid chromatography system for the determination of rat plasma catecholamines (CAs) was developed. Automated on-line extraction of CAs in diluted plasma using a precolumn packed with strong acidic cation exchange resin was coupled with separation of CAs on a semi-microcolumn (250 x 1.5 mm id). fluorogenic derivatization with ethylenediamine and finally postcolumn peroxyoxalate chemiluminescence detection utilizing bis[2-(3,6,9-trioxadecanyloxycarbonyl)-4-nitrophenyl]oxalate (TDPO) and hydrogen peroxide. The detection limits were 0.91, 0.36 and 1.1 fmol for norepinephrine (noradrenaline), epinephrine (adrenaline) and dopamine, respectively, at a signal-to-noise ratio of 3. A good linearity of the calibration curve for each CA was observed in the range of 5.0 to 500 fmol for each CA using N-methyldopamine (N-MeDA) as an internal standard. The RSD for the proposed method (n = 5) were 3.7-9.5% for the intra-day assay and 6.6-10.0% for the inter-day assay. The volume of rat plasma required for the determination of CAs was 10 microliters.     

A comparison of supercritical carbon dioxide and organic solvents for the intercalation of 4-phenylazoaniline into a pillared clay mineral

The intercalation of 4-phenylazoaniline (PAA) in supercritical carbon dioxide (SC-CO(2)) into montmorillonite (TMA-Mnt) pillared with tetramethylammonium ions at 313 K and 15 MPa was investigated. The adsorption rate and equilibrium PAA uptake were compared with those in n-hexane, CCl(4) and benzene solutions at 313 K. The XRD and N(2) adsorption/desorption analyses showed that TMA-Mnt after adsorption of PAA in SC-CO(2) had the same pore structure as after adsorption of PAA in normal solvents. SC-CO(2) was found to be a good medium for PAA adsorption owing to its having a relatively high adsorption rate and the highest adsorptivity at the same PAA concentration. The properties of PAA adsorption on TMA-Mnt could be well elucidated by the difference in solubility parameters between liquid and solid phases.     

Rapid fermentation of beer using an immobilized yeast multistage bioreactor

The characteristics of yeast sulfite metabolism in a multistage bioreactor system for beer fermentation were investigated. No sulfite was produced in the continuous stirred-tank reactor (CSTR). However, large amounts were produced in the packed-bed reactor (PBR). Production of sulfite in the PBR seems to be inevitable when it is operated continuously. In order to control the sulfite level in the young beer, the yeast needs to be reactivated into the growth phase. One possible strategy to achieve this is to aerate and periodically remove yeast clogged in the reactor once every 6–7 months before the sulfite level exceeds a given concentration (e.g., 20 mg/L). It was confirmed that sulfite production is closely related to the growth condition of the yeast and is therefore important to consider in the control strategy for sulfite when using the immobilized yeast reactor for beer production.     

Structure-activity study of intact porcine motilin

Biologically important sites on intact porcine motilin (pMTL) were explored using its partial peptides. The partial peptides were synthesized using Fmoc (9-fluorenylmethyloxycarbonyl) solid phase methodology, and tested for the binding activity to motilin receptor and the smooth muscle contractile activity. The results were as follows: important residues for the contractile activity were found to be Phe1, Ile4, and Tyr7, and an open space existed beyond the N-terminus between motilin and its receptor. On the model of interaction between motilin and motilin receptor evolved from these results, the three points of interaction, due to Phe1, Ile4, and Tyr7, and the presence of an open space were expected. The motilin agonist and antagonist, designed on this model, will help the inquiry into motilin associated diseases.