Reversible color changes in lamella hybrids of poly(diacetylenecarboxylates) incorporated in layered double hydroxide nanosheets

The present study is an investigation of a reversible thermal color change induced in lamella hybrids of poly(diacetylenecarboxylates) incorporated in layered double hydroxide (LDH) nanosheets. These poly-[m,n]/LDH hybrids prepared by the photo- or gamma-ray-induced polymerization of diacetylenecarboxylates, i.e., CH(3)(CH(2))(m)()(-)(1)CC-CC(CH(2))(n)()(-)(1)CO(2)(-) (mono-[m,n]), and intercalated in LDH lamella sheets, were observed to develop colors ranging from yellow to blue. The change in color was found to depend greatly on the alkyl carbon numbers of the mono-[m,n] (m,n = 10,11; 5,11; 10,5; 16,1) values. Moreover, the conformational alignment of the mono-[m,n] within the LDH was observed to be a crucial factor in color development, which was greatly affected by the intercalation degrees and extent of poly(ene-yne) linkage elongation of the polymers. For the poly-[m,n]/LDH hybrids investigated, a reversible color change was found to occur repeatedly and remarkably for the poly-[10,11]/LDH hybrid. This color change occurred at temperatures between ca. 20 and 80 degrees C back and forth from purple red to bright orange, in stark contrast to the irreversible color change for poly-[10,11] without LDH. Moreover, DSC and Raman spectroscopic studies of the LDH hybrids showed that the thermochromic temperature corresponded to the phase transition temperature of 80 degrees C. XRD analysis also indicated that the poly-[m,n]/LDH hybrid could retain its lamella structure during such thermochromic color changes, enabling conformational recovery in the polymer chains by a cooling down of the hybrids to temperatures lower than the transition temperature, while the nonhybrid poly-[10,11] powders exhibited an irreversible color change at 60 degrees C, above which the polymer powder turned amorphous.     

Solvothermal synthesis of large surface area zirconia

The reaction of zirconium n-propoxide in glycol at 300°C yielded microcrystalline tetragonal zirconia (ZrO₂). The crystallite size of the product depended on the carbon number of the glycol and increased in the following order (carbon number of glycol): 2<6<4, which suggested that the heterolytic cleavage of O-C bond of gylcoxide formed by transesterification is the prime factor for the formation of the product. In toluene, zirconium isopropoxide also gave tetragonal zirconia at 300°C, and zirconium tert-butoxide decomposed at 200°C yielding amorphous zirconia, while zirconium n-propoxide was stable at 300°C. These results suggest that the reaction in toluene depends on the structure of the alkyl group of the alkoxides. Thus-obtained tetragonal zirconias maintained large surface areas (90–160 m²/g) even after calcination at 500°C.     

1,3-Rearrangement of ketene-N,O-acetals

Ketene N,O-acetals were prepared stereoselectively and submitted to a Lewis acid-mediated 1,3-rearrangement to afford C-alkylated products. The reactions proceeded in a stereoselective manner to construct a chiral quaternary carbon in high selectivity. The stereochemistry of the quaternary center was found to be opposite to that obtained by an anionic direct dienolate alkylation.     

Determination of cadmium in river water by sequential metal vapor elution analysis

Determination of cadmium in river water by sequential metal vapour elution analysis (column temperature; > 1500 K) with argon and hydrogen carrier gas and with atomic absorption spectrometric detection is described. The column is made of a molybdenum capillary tube (i.d. 1.22 mm) and the temperature is 1760 K. The cadmium vapor was separated from those of calcium, iron and sodium. The calibration graph was linear up to 15 μ/ml. Relative standard deviations of 0.8–4.3% were obtained in the range 1 to 15 μ/ml. Cadmium in spiked samples (river water) was determined. The results were in good agreement with the amount spiked.     

Kinetic and ESR studies on the radical polymerization of Di-n-butyl itaconate in benzene

The polymerization of di-n-butyl itaconate (DBI) intiated with AIBN was kinetically investigated in benezene. The polymerization rate (R_p) was expressed by: R_p = k[AIBN]^0.5[DBI]^1.7. The polymerization showed a considerably low overall activation energy of 15.3 kcal/mol. The initiator efficiency of AIBN in this system decreased with increasing DBI concentration, ranging from 0.34 to 0.55°C, which is ascribable to viscosity effect due to the monomer. From an ESR study, the polymerization system was found to involve two kinds of persistent radicals, namely, primary propagating ( III ) and propagating ( I ) radicals. The relative concentration of III to I increased with decreasing monomer concentration. Azo-nitrile initiators such as AVN and ACN similarly produced two persistent radicals, while MAIB, DBPO, and PBO yielded only propagating radical I as persistent. The MAIB-initiated polymerization of DBI was also performed in benzene. Similar kinetic features were observed, that is, a higher dependence of R_p on the DBI concentration and a low overall activation energy (14.4 kcal/mol). The following rate equation was obtained at 50°C:R_p = k[MAIB]^0.5[DBI]^1.6. The initiator efficiency of MAIB decreased with increasing DBI concentration, ranging from 0.32 to 0.53 at 50°C. The concentration of propagating radical I was determined by ESR at 50 and 61°C, from which k_p and k_t were estimated. The k_p value increased with increasing monomer concentration, while the k_t one decreased with the DBI concentration. These values are much lower compared with those of MMA.     

Isolation and structure determination of a new marine toxin,neosurugatoxin, from the Japanese Ivory Shell, Babylonia japonica.

A new toxin, named neosurugatoxin, was isolated from the toxic Japanese Ivory Shell and its structure was determined by X-ray crystallographic analysis.     

High‐TC Ferromagnetic Semiconductor‐Like Behavior and Unusual Electrical Properties in Compounds with a 2×2×2 Superstructure of the Half‐Heusler Phase

Heusler phases, including the full‐ and half‐Heusler families, represent an outstanding class of multifunctional materials on account of their great tunability in compositions, valence electron counts (VEC), and properties. Here we demonstrate a systematic design of a series of new compounds with a 2×2×2 superstructure of the half‐Heusler unit cell in X–Y–Z (X=Fe, Ru, Co, Rh, Ir; Y=Zn, Mn; Z=Sn, Sb) systems. Their structures were solved by using both powder and single‐crystal X‐ray diffraction, and also directly observed by using high‐angle annular dark‐field imaging in a scanning transmission electron microscope (HAADF‐STEM). The VEC values of these new compounds span a wide and continuous range comparable to those for the full‐ and half‐Heusler families, thereby implying tunability in compositions and physical properties in the superstructure. In fact, we observed abnormal electrical properties and a ferromagnetic semiconductor‐like behavior with a high and tunable Curie temperature in these superstructures.     

Synthesis of α‐Dawson‐Type Silicotungstate [α‐Si2W18O62]8− and Protonation and Deprotonation Inside the Aperture through Intramolecular Hydrogen Bonds

The design of structurally well‐defined anionic molecular metal–oxygen clusters, polyoxometalates (POMs), leads to inorganic receptors with unique and tunable properties. Herein, an α‐Dawson‐type silicotungstate, TBA₈[α‐Si₂W₁₈O₆₂] ? 3 H₂O ( II ) that possesses a ?8 charge was successfully synthesized by dimerization of a trivacant lacunary α‐Keggin‐type silicotungstate TBA₄H₆[α‐SiW₉O₃₄] ? 2 H₂O ( I ) in an organic solvent. POM II could be reversibly protonated (in the presence of acid) and deprotonated (in the presence of base) inside the aperture by means of intramolecular hydrogen bonds with retention of the POM structure. In contrast, the aperture of phosphorus‐centered POM TBA₆[α‐P₂W₁₈O₆₂]?H₂O ( III ) was not protonated inside the aperture. The density functional theory (DFT) calculations revealed that the basicities and charges of internal μ₃‐oxygen atoms were increased by changing the central heteroatoms from P⁵⁺ to Si⁴⁺, thereby supporting the protonation of II . Additionally, II showed much higher catalytic performance for the Knoevenagel condensation of ethyl cyanoacetate with benzaldehyde than I and III .