Experimental investigation on the thermophysical properties of beryllium oxide-based nanofluid and nano-enhanced phase change material

Journal of Thermal Analysis and Calorimetry - Low thermal conductivity is a primary issue in the development of efficient heat transfer fluids and materials required for the thermal management of...     

A novel synthesis route for brookite rich titanium dioxide photocatalyst involving organic intermediate

Journal of Sol-Gel Science and Technology - High temperature stable brookite rich titanium dioxide of average crystallite size 20&;nbsp;nm has been prepared by a novel aqueous sol–gel...     

A dried blood spot assay with HPLC–MS/MS for the determination of larotrectinib in mouse blood and its application to a pharmacokinetic study

Larotrectinib is a first-generation tropomyosin kinase inhibitor, approved for the treatment of solid tumors. In this paper, we present a validated dried blood spot (DBS) method for the quantitation of larotrectinib from mouse blood using HPLC–MS/MS, which was operated under multiple reaction monitoring mode. To the DBS disc cards, acidified methanol enriched with internal standard (IS; enasidenib) was added and extracted using tert-butyl methyl ether as an extraction solvent with sonication. Chromatographic separation of larotrectinib and the IS was achieved on an Atlantis dC₁₈ column using 10 mm ammonium formate–acetonitrile (30:70, v/v) delivered at a flow-rate of 0.80 ml/min. Under these optimized conditions, the retention times of larotrectinib and the IS were ~0.93 and 1.37 min, respectively. The total run time was 2.50 min. Larotrectinib and the IS were analyzed using positive ion scan mode and parent–daughter mass to charge ion (m/z) transitions of 429.1 → 342.1 and 474.1 → 267.1, respectively, were used for the quantitation. The calibration range was 1.06–5,080 ng/ml. No matrix effect or carryover was observed. Hematocrit did not influence DBS larotrectinib concentrations. All of the validation parameters met the acceptance criteria. The applicability of the validated method was shown in a mouse pharmacokinetic study.     

Stereoselective synthesis of 3,4-trans-disubstituted pyrrolidines and cyclopentanes via intramolecular radical cyclizations mediated by CAN

The stereoselective intramolecular cyclizations of bis(cinnamyl)tosylamides and dimethyl bis(cinnamyl)malonates mediated by cerium(IV) ammonium nitrate leading to the synthesis of 3,4-trans-disubstituted pyrrolidines and cyclopentanes are described.     

An efficient synthesis of isothiazolidines via sulfonium ylides formed by the reaction of thietanes and nitrene

An efficient synthesis of isothiazolidines in good yields is described.     

Synthesis and thermal behaviour of salicylaldimine-based liquid crystalline symmetrical dimers

A series of symmetrical dimers consisting of salicylaldimine moieties connected by flexible alkylene central spacer via ether linkages has been synthesized. In order to validate the empirical rule suggested by Date et al. to account for the smectic behaviour of such dimers, the chain length of the terminal alkoxy chain has been kept constant (C₈) while the number of methylene units in the central spacer was varied from C₃ to C₁₁. Another aim of the present investigation was to understand structure-property relationship in these dimers in which the salicylaldimine mesogenic segment has been used for the first time in dimers. The mesomorphic behaviour of these dimers was evaluated using optical microscopy and differential scanning calorimetry and the structure of some of the mesophases has been further investigated with the help of X-ray diffraction. Our studies reveal that the dimers consisting of 3 to 8 methylene units in the flexible spacer show only smectic (smectic C and smectic A) phases. For the dimers containing 4, 6 and 8 methylene units in the central spacer, a unique filament growth pattern has been observed in the smectic A phase while cooling from the isotropic phase. The dimers containing of C₉ to C₁₁ methylene groups exhibit the nematic phase in addition to smectic modifications. This observation indicates that when the terminal chains are shorter than the spacer, the tendency to form smectic phases is not fully extinguished but is perhaps reduced.     

Synthesis of oxazolidinedione derived bicalutamide analogs

The synthesis of chiral oxazolidinedione derived bicalutamide analogs has been discussed.     

CAN mediated cyclization of epoxypropyl cinnamyl ethers: a facile stereoselective synthesis of tetrahydropyran derivatives

Cerium(IV) ammonium nitrate in substoichiometric amounts, promotes the intramolecular cyclization of epoxypropyl cinnamyl ethers to the corresponding 3,4,5-trisubstituted tetrahydropyran derivatives in moderate to good yields.     

Effect of the pore surface modification of an inorganic substrate on the plasma‐grafting behavior of pore‐filling‐type organic/inorganic composite membranes

We have investigated the effect of the surface state and surface treatment of the pores of an inorganic substrate on the plasma‐grafting behavior of pore‐filling‐type organic/inorganic composite membranes. Shirasu porous glass (SPG) was used as the inorganic substrate, and methyl acrylate was used as the grafting monomer. The grafting rate increased as the density of silanol on the SPG substrate increased. This result suggests that radicals are generated mainly at the silanol groups on the pore surface by plasma irradiation. The SPG substrates were treated with silane coupling agents used to control the mass of organic material bonded to the pore surface. The thickness of the grafted layer became thinner as the mass of organic material bonded to the pore surface of SPG increased. This decrease in the thickness of the grafted layer could be explained by the decrease in the penetration depth of vacuum ultraviolet rays contained in plasma having a wavelength of less than 160 nm that generated radicals in the pores of the substrate. The thickness of the grafted layer inside the SPG substrates could be controlled through the control of the mass of organic material bonded to the pore surface of the SPG substrate. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 846–856, 2006     

Photon interaction studies using 241Am γ-rays

We have carried out some photon interaction measurements using 59.54 keV γ-rays from a ²⁴¹Am source. These include γ attenuation studies as well as photoelectric absorption studies in various samples. The attenuation studies have been made using leaf and wood samples, samples like sand, sugar etc., which contain particles of varying sizes as well as pellets and aqueous solutions of rare earth compounds. In the case of the leaf and wood samples, we have used the γ-ray attenuation technique for the determination of the water content in fresh and dried samples. The variation of the attenuation coefficient with particle size has been investigated for sand and sugar samples. The attenuation studies as well as the photoelectric studies in the case of rare earth elements have been carried out on samples containing such elements whose K-absorption edge energies lie below and close to the γ-energy used. Suitable compounds of the rare earth elements have been chosen as mixture absorbers in these investigations. A narrow beam good geometry set-up was used for the attenuation measurements. A well-shielded scattering geometry was used for the photoelectric measurements. The mixture rule was invoked to extract the values of the mass attenuation coefficients for the elements from those of the corresponding compounds. The results are consistent with theoretical values derived from the XCOM package.