Resonance-enhanced multiphoton ionisation photoelectron spectroscopy of the ClO radical: the C 2 sigma- state

A (2 + 1) one-colour resonance-enhanced multiphoton ionisation study is carried out on the C 2 sigma- state of the ClO radical in the one-photon energy range 29,500-31,250 cm-1. The ClO radical is produced by one-photon photolysis of ClO2 employing 359.2 nm photons derived from a separate laser. In this way a significant concentration of vibrationally excited ClO in its spin-orbit split X 2 pi omega (omega = 3/2 or 1/2) electronic ground state is produced. In addition to mass-resolved excitation spectra, kinetic-energy resolved photoelectron spectra for the X 3 sigma-(v+)<--C 2 sigma-(v' = 3-5) transitions are measured. These transitions are not completely Frank-Condon diagonal, and indicate a decrease in bond length on removal of the Rydberg electron from the C 2 sigma- state. In addition to an unambiguous assignment of the C 2 sigma- state, valuable information is obtained on the degree of vibrational excitation with which the nascent ClO radical is formed in the photolysis of ClO2. Analysis of the photoelectron spectra is supported by Franck-Condon calculations based on potential energy curves either from experimental spectroscopic parameters, or obtained by theoretical ab initio methods.     

Photoelastic determination of stresses in multiple-pin connectors

The design, fabrication, and testing of photoelastic models of double-lap, multiple-pin connectors are discussed. Interest is in the stresses in the inner laps. These stresses are determined by constructing models with photoelastic inner laps and transparent-acrylic outer laps. The connectors have two pins, in tandem, parallel to the load direction. A photoelastic-isotropic point is shown to permit the evaluation of load sharing between the two pins. A numerical scheme, utilizing the isochromatic- and isoclinic-photoelastic data and a finite-difference representation of the planestress equilibrium equations, is used to compute the stresses around the two pins. Representative stress distributions and stress-concentration factors are shown.     

Phage display-derived inhibitor of the essential cell wall biosynthesis enzyme MurF

Background  

To develop antibacterial agents having novel modes of action against bacterial cell wall biosynthesis, we targeted the essential MurF enzyme of the antibiotic resistant pathogen Pseudomonas aeruginosa. MurF catalyzes the formation of a peptide bond between D-Alanyl-D-Alanine (D-Ala-D-Ala) and the cell wall precursor uridine 5'-diphosphoryl N-acetylmuramoyl-L-alanyl-D-glutamyl-meso-diaminopimelic acid (UDP-MurNAc-Ala-Glu-meso-A2pm) with the concomitant hydrolysis of ATP to ADP and inorganic phosphate, yielding UDP-N-acetylmuramyl-pentapeptide. As MurF acts on a dipeptide, we exploited a phage display approach to identify peptide ligands having high binding affinities for the enzyme.     

Fracture of thick laminated composites

The fracture of thick laminated graphite/epoxy composites has been the subject of an extensive research program. The program was divided into three major areas of investigation which included laminate thickness, laminate stacking sequence, and part-through surface flaws. The results from this program are reviewed with emphasis placed on their applicability to the design of thick laminated composite structures. Paper was presented at 1985 SEM Spring Conference on Experimental Mechanics held in Las Vegas on June 9–14, 1985.     

Zur Bestimmung des Schwefels in Eisen und Stahl

Ohne Zusammenfassung     

Schwefelbestimmung in Eisen, Stahl u. dergl

Ohne Zusammenfassung     

Localization of carboxyl groups at surface layer of carboxylated polymer emulsion particles by alkali treatment

For the purpose of localizing carboxyl groups from inside to particle surface, styrene — butyl acrylate — methacrylic acid (74.3/17.0/8.7, mol ratio) terpolymer emulsion was kept under pH 9 at different temperatures. The amount of carboxyl groups at the particle surface, As, was remarkably increased by the alkali-treatment above 35 °C. On the other hand, As value of the alkalitreated emulsion was decreased by keeping under ph 3 above 45 °C, although in the case of the original emulsion without the alkalitreatment, it was not changed by the acid-treatment. These results suggest that a part of polymer segments which have ionized carboxyl groups is dragged out at the surface by an increase in the affinity of the groups against water, and the dragged segments turn back into the inside again when the carboxyl groups are deionized.Part 97 of the series Studies on Suspension and Emulsion.