Characterization of the barrier properties of composites of HDPE and purified cellulose fibers

The present work presents and discusses the interrelation between composition, morphology, thermal history, mechanical and barrier properties to oxygen and limonene of composites of HDPE/MA-PE/cellulose fibers of significant interest in, among others, food packaging applications. From the overall results, it was observed that increasing the loading of purified alpha-cellulose fibers in the polyethylene matrix beyond 10 wt.% led to a decrease in the permeability coefficient of d-limonene, effect which was found to be primarily related to a decrease in the overall solubility of this strongly plasticizing aroma component. On the other hand, the oxygen permeability was found to decrease to a significant extend with increasing fiber content beyond 5 wt.%, but this effect was more strongly ascribed to a significant decrease in the diffusion coefficient. Therefore, the fibers are thought to generate a more tortuous path for the non-interacting gas molecules to travel across the composites thickness, even when tested at high relative humidity conditions. Optimum fiber loading levels in terms of overall property balance were found to be around 20 wt.%.     

Optimized determination of calcium in grape juice,wines, and other alcoholic beverages by atomic absorption spectrometry

This paper describes a study of the different methods of sample preparation for the determination of calcium in grape juice, wines, and other alcoholic beverages by flame atomic absorption spectrometry; results are also reported for the practical application of these methods to the analysis of commercial samples produced in Spain. The methods tested included dealcoholization, dry mineralization, and wet mineralization with heating by using different acids and/or mixtures of acids. The sensitivity, detection limit, accuracy, precision, and selectiviy of each method were established. Such research is necessary because of the better analytical indexes obtained after acid digestion of the sample, as recommended by the European Union, which advocates the direct method. In addition, although high-temperature mineralization with an HNO3-HCIO4 mixture gave the best analytical results, mineralization with nitric acid at 80 degrees C for 15 min gave the most satisfactory results in all cases, including those for wines with high levels of sugar and beverages with high alcoholic content. The results for table wines subjected to the latter treatment had an accuracy of 98.70-99.90%, a relative standard deviation of 2.46%, a detection limit of 19.0 microg/L, and a determination limit of 31.7 microg/L. The method was found to be sufficiently sensitive and selective. It was applied to the determination of Ca in grape juice, different types of wines, and beverages with high alcoholic content, all of which are produced and widely consumed in Spain. The values obtained for Ca were 90.00 +/- 20.40 mg/L in the grape juices, 82.30 +/- 23.80 mg/L in the white wines, 85.00 +/- 30.25 mg/L in the sweet wines, 84.92 +/- 23.11 mg/L in the red wines, 85.75 +/- 27.65 mg/L in the rosé wines, 9.51 +/- 6.65 mg/L in the brandies, 11.53 +/- 6.55 mg/L in the gin, 7.3 +/- 6.32 mg/L in the pacharán, and 8.41 +/- 4.85 mg/L in the anisettes. The method is therefore useful for routine analysis in the quality control of these beverages.     

Trichilianones A-D,Novel Cyclopropane-Type Limonoids from Trichilia adolfi

The fractionation of an ethanol extract of the bark of Trichilia adolfi yielded four novel limonoids (trichilinones A-D, 1–4), with five fused rings and related to the hortiolide-type limonoids. Starting with an ε-lactone, which is α,β-unsaturated in trichilinones A and D (1 and 4), attached to a tetrahydrofuran ring that is connected to an unusual bicyclo [5.1.0] hexane system, joined with a cyclopentanone with a 3-furanyl substituent [(2-oxo)-furan-(5H)-3-yl in trichilinone D (4)], the four compounds isolated display a new 7/5/3/5/5 limonoid ring system. Their structures were established based on extensive analysis of NMR spectroscopic data. As the crude extract possessed anti-leishmanial properties, the compounds were assayed for cytotoxic and anti-parasitic activities in vitro in murine macrophages cells (Raw 264.7) and leishmania promastigotes (L. amazoniensis and L. braziliensis), respectively. The compounds showed moderate cytotoxicity (approximately 70 μg/mL), but are not responsible for the leishmanicidal effect of the extract.     

Hypotheses Testing for Error-in-Variables Models

In this paper, hypotheses testing based on a corrected score function are considered. Five different testing statistics are proposed and their asymptotic distributions are investigated. It is shown that the statistics are asymptotically distributed according to the chisquare distribution or can be written as a linear combination of chisquare random variables with one degree of freedom. A small scale numerical Monte Carlo study is presented in order to compare the empirical size and power of the proposed tests. A comparative calibration example is used to illustrate the results obtained.     

Lipoxygenase inhibitory activity of Cuspidaria pulchra and isolated compounds

This work evaluated the in vitro inhibitory activity of the crude ethanolic extract from the aerial parts of Cuspidaria pulchra (Cham.) L.G. Lohmann against 15-lipoxygenase (15-LOX). The bioassay-guided fractionation of the n-butanol fraction, which displayed the highest activity, led to the isolation of three compounds: caffeoylcalleryanin (1), verbascoside (2) and 6-hydroxyluteolin-7-O-β-glucoside (3). Assessment of the ability of the isolated compounds to inhibit 15-LOX revealed that compounds 1, 2 and 3 exerted strong 15-LOX inhibitory activity; IC₅₀ values were 1.59, 1.76 and 2.35 μM respectively. The XTT assay showed that none of the isolated compounds seemed to be significantly toxic.     

Photodecomposition of phenol in a flow reactor: Adsorption and kinetics

Summary In this study, a new air lift loop photoreactor was used for both continuous and non-continuous water photodetoxification. Also, the kinetics of phenol photodegradation were measured under flow conditions. Both the kinetics of phenol adsorption on TiO₂/SiO₂ and of the total photo-mineralization of phenol were measured in order to gain more knowledge on the photocatalytic oxidation of phenol on illuminated titania.Adsorption of phenol on TiO₂/SiO₂ proceeds even from diluted solutions. However, based on our data, it is impossible to state precisely the influence of the adsorption on the overall rate of phenol photodecomposition. The photoreaction yields stable intermediates which subsequently undergo total mineralization to CO₂ and H₂O. It is postulated that the intermediates consist mainly of polymeric compounds, difficult to determine by conventional analytical methods like GC, HPLC, or UV/Vis spectroscopy.

---

Photolyse von Phenol in einem Durchflußreaktor: Adsorption und Kinetik

Zusammenfassung Ein neuartiger Photoreaktor wurde auf seine Verwendbarkeit zur kontinuierlichen und nichtkontinuierlichen Wasseraufbereitung getestet. Die Kinetik des photolytischen Abbaus von Phenol wurde unter Durchflußbedingungen untersucht. Zum besseren Verständnis der photokatalysierten Oxidation von Phenol auf belichtetem Titanoxid wurde außerdem die Kinetik sowohl der Adsorption von Phenol an TiO₂/SiO₂ als auch seiner Gesamtphotomineralisierung erforscht.Adsorption von Phenol an TiO₂/SiO₂ erfolgt bereits aus verdünnten Lösungen. Nach unseren Ergebnissen ist es allerdings unmöglich, den Einfluß der Adsorption auf die Photolyse genau zu bestimmen. Die Photoreaktion ergibt stabile Zwischenprodukte, die sich im weiteren Verlauf zu CO₂ und H₂O umsetzen. Es wird postuliert, daß es sich bei den Zwischenprodukten hauptsächlich um Polymere handelt, die mit konventionellen analytischen Techniken wie GC, HPLC oder UV/Vis-Spektroskopie schwer nachzuweisen sind.

     

Construction of vector-valued modular integrals and vector-valued mock modular forms

It is known that, given a vector-valued modular form of negative weight, its Fourier coefficients can be calculated based on the principal part of the form. In this paper we start with an arbitrary principal part and complete the Fourier expansion using the calculation. We show that the so-obtained function is a vector-valued modular integral of negative weight on the full modular group. Next, we construct the supplementary function associated to a vector-valued modular cusp form of positive weight. The constructions are inspired by the construction of Eichler integrals by Knopp. We conclude with a comparison of these forms and their integrals to vector-valued weak harmonic Maass forms.     

Fluorescent tetraruthenated porphyrins embedded in monolithic SiO2 gels by the sol-gel process

In this work silica gels have been prepared by a sol-gel method using tetraethylorthosilicate as gel precursor. The tetraruthenated porphyrins H2(3-TRPyP), Co(3-TRPyP), and H2(4-TRPyP) were incorporated into the systems during gel formation without problems commonly found in the process, such as aggregation. Spectroscopic studies of the resulting silica gels revealed the presence of absorption bands in the range 200-400 nm associated with the transitions of the groups ruthenium-bipyridine, along with the Soret band at the same wavelengths observed in solution. The porphyrins were found to preserve fluorescence emission properties in the range 650-700 nm even after the aging period. Study of the thermal behavior and decomposition kinetics evidenced that the porphyrin H2(4-TRPyP) is the least stable of the group and that all compounds decompose according to first-order kinetics.     

Anisotropic Ionic Mobility of Lithium Salts in Lamellar Liquid Crystalline Polymer Networks

New mesogens presenting smectic A (SmA) phases and capable of hosting lithium salts are designed. The mesogens comprise a vinyl‐functionalized spacer to allow further reaction to the polymer backbone, an aromatic core and ethylene oxide chains, able to coordinate lithium ions. Copolymerizing these monomers with a suitable crosslinker yields the first lithium containing liquid crystalline elastomers (LCEs). The SmA structure where the ethylene oxide chains are microphase separated in layers is fixed by the crosslinking and permanent macroscopic orientation is obtained. Diffusion and conductivity measurements of the monomer sample show a large anisotropy of the ion mobility (100 for the cation and 400 for the anion). In the elastomer the anisotropy of the lithium mobility is comparable to that in the monomers.