Comparative analysis of the main active components and hypoglycemic effects after the compatibility of Scutellariae Radix and Coptidis Rhizoma

In this study, a rapid and highly sensitive ultra high performance liquid chromatography with triple quadrupole mass spectrometry method with the mobile phase of acetonitrile and 0.1% aqueous formic acid was established and successfully applied to comparatively analyze main active components after their compatibility. Besides, the effects of Scutellariae Radix, Coptidis Rhizoma and combined extracts on type 2 diabetic rats induced by high‐fat diet along with low dose of streptozocin were investigated. Under the optimized chromatographic conditions, good separation of seven target components was achieved within 12 min. All calibration curves exhibited good linearity (R² ≥ 0.999). The relative standard deviation of precision, repeatability and stability varied from 0.69 to 2.23, 0.98 to 2.56, and 0.92 to 2.57%, respectively. The recovery ranged from 91.11 to 105.35%. The contents of seven active components were notably reduced after compatibility; however, the hypoglycemic effect of combined extracts was stronger than single drug by decreasing the activities of fructose‐1,6‐bisphosphatase, glucose 6‐phosphatase, phosphoenolpyruvate carboxykinase and increasing the activities of glucokinase, phosphofructokinase, pyruvate kinase. Accordingly, the established analytical method was accurate and sensitive enough for quantitative evaluation of seven investigated compounds. Moreover, the combined extract had definite effects on type 2 diabetes through multiple components against multiple targets.     

污泥基吸附剂对亚甲基蓝和环丙沙星的吸附性能研究

亚甲基蓝和环丙沙星是水体中2种污染物, 对生态环境有潜在危害. 本文以市政剩余活性污泥为原料, 氯化锌为活化剂热解制备污泥基吸附剂, 研究盐酸酸洗浓度、氯化锌浓度、热解温度、热解时间等对污泥基吸附剂吸附水中亚甲基蓝和环丙沙星性能的影响. 结果表明 (1)污泥基吸附剂对亚甲基蓝的吸附性能随盐酸酸洗浓度的增大而增加, 对环丙沙星的吸附性能则随盐酸酸洗浓度的增大呈先降后增趋势, 两者均在1.500mol·L-1盐酸浓度下取得最优值. (2)污泥基吸附剂对亚甲基蓝和环丙沙星的吸附性能随氯化锌浓度和热解温度的增加呈先升后降趋势, 在氯化锌浓度为4.0mol·L-1、热解温度为500℃时有最优值; 随着热解时间的延长, 污泥基吸附剂对亚甲基蓝和环丙沙星的吸附性能分别在500℃热解70min和80min时有最优值. (3)污泥基吸附剂的最佳制备条件为 氯化锌4.0mol·L-1活化2h、500℃热解70min和80min、1.500mol·L-1盐酸酸洗; 以此制得的污泥基吸附剂对亚甲基蓝和环丙沙星的去除率分别为97.7%和96.4%, 平衡吸附量分别为97.9mg·g-1和3.9mg·g-1, 且污泥基吸附剂对亚甲基蓝和环丙沙星的吸附过程均符合准二级动力学方程.     

Analysis of time series in the cumulative residual entropy plane based on oscillation roughness exponent

Nonlinear Dynamics - In this work, we propose the cumulative residual entropy (CRE) plane and CRE curve based on the weighted-multiscale cumulative residual Rényi/Tsallis permutation entropy...     

The High Energy X-ray telescope (HE) onboard the Insight-HXMT astronomy satellite

The Insight-Hard X-ray Modulation Telescope(Insight-HXMT) is a broadband X-ray and γ-ray(1-3000 ke V) astronomy satellite. One of its three main telescopes is the High Energy X-ray telescope(HE). The main detector plane of HE comprises 18 Na I(Tl)/Cs I(Na) phoswich detectors, where Na I(Tl) is used as the primary detector to measure ~ 20-250 ke V photons incident from the field of view(FOV) defined by collimators, and Cs I(Na) is used as the active shielding detector to Na I(Tl) by pulse shape discrimination. Additionally, Cs I(Na) is used as an omnidirectional γ-ray monitor. The HE collimators have a diverse FOV,i.e. 1.1°×5.7°(15 units), 5.7°×5.7°(2 units), and blocked(1 unit). Therefore, the combined FOV of HE is approximately5.7°×5.7°. Each HE detector has a diameter of 190 mm resulting in a total geometrical area of approximately 5100 cm2, and the energy resolution is ~15% at 60 ke V. For each recorded X-ray event by HE, the timing accuracy is less than 10 μs and the deadtime is less than 10 μs. HE is used for observing spectra and temporal variability of X-ray sources in the 20-250 ke V band either by pointing observations for known sources or scanning observations to unveil new sources. Additionally, HE is used for monitoring the γ-ray burst in 0.2-3 Me V band. This paper not only presents the design and performance of HE instruments but also reports results of the on-ground calibration experiments.     

Photoinduced dynamics of a cyanine dye: parallel pathways of non-radiative deactivation involving multiple excited-state twisted transients

Cyanine dyes are broadly used for fluorescence imaging and other photonic applications. 3,3′-Diethylthiacyanine (THIA) is a cyanine dye composed of two identical aromatic heterocyclic moieties linked with a single methine, –CH. The torsional degrees of freedom around the methine bonds provide routes for non-radiative decay, responsible for the inherently low fluorescence quantum yields. Using transient absorption spectroscopy, we determined that upon photoexcitation, the excited state relaxes along two parallel pathways producing three excited-state transients that undergo internal conversion to the ground state. The media viscosity impedes the molecular modes of ring rotation and preferentially affects one of the pathways of non-radiative decay, exerting a dominant effect on the emission properties of THIA. Concurrently, the polarity affects the energy of the transients involved in the decay pathways and further modulates the kinetics of non-radiative deactivation.     

Chemical equilibrium controlled synthesis of polyoxymethylene dimethyl ethers over sulfated titania

The chemical equilibrium and reaction kinetic behavior in the synthesis of polyoxymethylene dimethyl ethers(DMMn) were investigated over sulfated titania in order to reveal the decisive factor controlling the reaction. The results showed that the molar ratio of adjacent DMMn products in equilibrium solution had the same value, which depended absolutely on the reaction temperature. Meanwhile, the reactions had the same DMMn products distributions under varied reaction conditions. The equilibrium constants of the related step-wise reactions for DMMn formation were equal, which were calculated based on the bulk compositions of the reaction solution. And thus, the selectivity to DMMn was mainly controlled by the chemical equilibrium, i.e., thermodynamic control. In brief, the present results provide some guidance for future synthesis of DMMn.     

Surface modification of polyolefin separators for lithium ion batteries to reduce thermal shrinkage without thickness increase

Surface chemical modification of polyolefin separators for lithium ion batteries is attempted to reduce the thermal shrinkage, which is important for the battery energy density. In this study, we grafted organic/inorganic hybrid crosslinked networks on the separators, simply by grafting polymerization and condensation reaction. The considerable silicon-oxygen crosslinked heat-resistance networks are responsible for the reduced thermal shrinkage. The strong chemical bonds between networks and separators promise enough mechanical support even at high temperature. The shrinkage at 150 C for 30 min in the mechanical direction was 38.6% and 4.6% for the pristine and present graft-modified separators, respectively. Meanwhile, the grafting organic-inorganic hybrid crosslink networks mainly occupied part of void in the internal pores of the separators, so the thicknesses of the graft-modified separators were similar with the pristine one. The half cells prepared with the modified separators exhibited almost identical electrochemical properties to those with the commercial separators, thus proving that, in order to enhance the thermal stability of lithium ion battery, this kind of grafting-modified separators may be a better alternative to conventional silica nanoparticle layers-coated polyolefin separators.     

Cold,warm, and hot programming of shape memory polymers

In this article, programming is classified as hot, warm, and cold, based on the temperature zone within which the programming is conducted. The strain and stress locking and releasing mechanisms are discussed within the thermodynamics framework. A new formula is developed for quantifying the strain recovery ratio of cold-programmed SMPs. Stress fixity ratio and stress recovery ratio are also defined based on the understanding of stress locking and recovery mechanisms. State-of-the-art literature on warm and cold programming is reviewed. Well-controlled programming as well as free strain recovery test and constrained stress recovery test are conducted, in order to validate the memory mechanisms discussed in this study. It is found that, while programming temperature has an insignificant effect on the final free shape recovery, it has a significant effect on the stress recovery. The recovery stress programmed by cold programming may be lower, equal to, or higher than that by hot programming, due to the different stress locking mechanisms and other factors such as damage during the thermomechanical cycle. Cold, Warm, and Hot Programming of Shape Memory Polymers © 2016 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2016 , 54, 1319–1339