Simultaneous determination of propacetamol and paracetamol by derivative spectrophotometry

The present paper describes a procedure that phenols in air were preconcentrated in a membrane cell and their content was determined by adsorptive polarography. First, the phenols in air samples were preconcentrated in a membrane cell using 2.0 M NaOH solution, then in a pH 1.3 buffer solution p-bromophenylamine forms a diazoate with NaNO(2), and into the mixture the collected phenols were added to form azo-compound in a pH 13 buffer solution. The azo-compound can be adsorbed at the mercury electrode and yields a sensitive oscillopolarographic wave. Over the range 2.0x10(-8)-2.0x10(-5) M, the peak currents are linearly proportional to the concentration of phenols. The detection limit is 5.0x10(-9) M.     

Determination of polycyclic aromatic hydrocarbons in honey by matrix solid-phase dispersion and gas chromatography/mass spectrometry

A multiresidue method was developed for the de termination of 16 polycyclic aromatic hydrocarbons (PAHs) in unifloral and multifloral honeys. The analytical procedure is based on the matrix solid-phase dispersion of honey on a mixture of Florisil and anhydrous sodium sulfate in small glass columns and extraction with hexane-ethyl acetate (90 + 10, v/v) with assisted sonication. The PAH residues are determined by gas chromatography with mass spectrometric detection using selected-ion monitoring. Average recoveries for all the PAHs studied were in the range of almost 80 to 101%, with relative standard deviations of 6 to 15%. The limits of detection ranged from 0.04 to 2.9 microg/kg. The simultaneous extraction and cleanup of samples makes this method simple and rapid, with low consumption of organic solvents     

Kinetic determination of selenium, based on inhibition of the Pd(II)-catalysed reaction between pyronine G and hypophosphite

A new kinetic method for determination of selenium is based on its inhibitory effect on the Pd(II)-catalysed reaction between Pyronine G and hypophosphite. Under the optimum experimental conditions (6 x 10(-5)M Pyronine G, 0.4M hypophosphite, 0.4 mug/ml Pd(II), pH 2.8, temperature 22.0 +/- 0.2 degrees ), Se can be determined in the concentration range 0.033-0.50 mug/ml. The method suffers from numerous interferences and is thus limited in application. It has been applied to the determination of selenium in spring waters and pharmaceutical preparations.     

Kinetic determination of tellurium based on its inhibitory effect on the palladium(II)-catalysed reaction between pyronine G and hypophosphite ion

A kinetic method for the determination of Te based on its inhibitory effect on the PdII-catalysed reaction between pyronine G and H2PO2- is described. The influence of experimental variables on the rate of the process and the potential interfering effect of a large number of ions has been studied. Under the selected experimental conditions: 6 x 10(-5) M pyronine G; 0.6 M H2PO2-; pH 2.6, adjusted with Britton-Robinson buffer; 0.80 microgram ml-1 of PdII; and a temperature of 22 +/- 0.2 degrees C, Te was determined in the concentration range 0.08-0.85 microgram ml-1. The method was applied to the determination of Te in waters and lead concentrates.     

Computational and experimental analysis of wound healing processes

Wound healing in epidermis is a complex physiological process in which new cells are created to repair the damaged tissue. The timing of cell division and growth mechanisms in wound healing are influenced by biological, mechanical and medical factors. In this work we aim to provide a numerical model based on the observations realised in in-vitro experiments for the understanding of wound healing. (© 2016 Wiley-VCH Verlag GmbH & Co. KGaA, Weinheim)     

Gas chromatography–triple-quadrupole mass spectrometry for analysis of selected polyhalogenated pollutants in plants. Comparison of extraction methods

Different extraction methods, followed by gas chromatography coupled to triple quadrupole mass spectrometry, were evaluated for simultaneous extraction of seven polychlorinated biphenyls (PCBs) and six polybrominated diphenyl ethers (PBDEs) from common weeds. Pressurized liquid extraction (PLE) with in-cell clean-up, ultrasound-assisted extraction (UAE) with in-column clean-up, and UAE with dispersive solid-phase extraction (dSPE) clean-up were evaluated and compared. In-cell clean-up with 4 g Florisil and 0.5 g graphitized carbon black (GCB) and two extraction cycles of 10 min with n-hexane–ethyl acetate 80:20 (v/v) at 60 °C were used for the PLE procedure. UAE with in-column clean-up was conducted under conditions similar to those reported for the PLE method whereas in UAE with dSPE clean-up purification of the extract was performed after extraction using primary and secondary amine sorbent (PSA) and GCB. Recovery from 82 to 104 % was obtained for all the compounds by PLE whereas, in general, lower extraction efficiency was obtained by UAE with in-column clean-up (especially for BDE-17 and BDE-183, for which recovery was 70 and 41 %, respectively) and by UAE with dSPE clean-up, for which the main drawback is that BDE-183 cannot be extracted. Finally, PLE was used for analysis of PCBs and PBDEs in different plants (Lolium rigidum, Lactuca serriola, Malva sylvestris, and Verbascum thapsus) collected from residential and/or rural areas of Madrid (Spain). Several of the analyzed compounds were detected at low levels in these plants, but only PCB-153 could be quantified.

Mechanics of cell-division: A new continuum model for growth inhomogeneities

The self-reproduction ability of mitotic cells results in an increase of the number of cells with the same characteristics in living bodies. While cells grow in volume and divide themselves, the living body consequently grows in mass and volume. Further, if the factors which regulate the growth process are inhomogeneously distributed, growth takes place at different rates and directions. In this work we aim to provide a new continuum model for growing tissues. More specifically, the model considers the reorientation of the cell-division plane in mitotic cells depending on the stress field of the growing body. (© 2015 Wiley-VCH Verlag GmbH & Co. KGaA, Weinheim)     

Long‐Term Photostability in Terephthalate Metal–Organic Frameworks

Prolonged (weeks) UV/Vis irradiation under Ar of UiO‐66(Zr), UiO66 Zr‐NO₂, MIL101 Fe, MIL125 Ti‐NH₂, MIL101 Cr and MIL101 Cr(Pt) shows that these MOFs undergo photodecarboxylation of benzenedicarboxylate (BDC) linker in a significant percentage depending on the structure and composition of the material. Routine characterization techniques such as XRD, UV/Vis spectroscopy and TGA fail to detect changes in the material, although porosity and surface area change upon irradiation of powders. In contrast to BCD‐containing MOFs, zeolitic imidazolate ZIF‐8 does not evolve CO₂ or any other gas upon irradiation.     

Structure–Function Relationships in Unsymmetrical Zinc Phthalocyanines for Dye‐Sensitized Solar Cells

Let it shine! The impact of the anchoring group on photovoltaic performance by a series of phthalocyanine sensitisers (see figure) has been demonstrated.

     

A new procedure for the construction of flow-through optodes. Application to determination of copper (II)

A new procedure for constructing an optical fibre reflectance, bulk optode membrane type, sensor is presented. The optode membrane consists of a plasticized poly (vinyl chloride) membrane in which the ionophore is dissolved, entrapped in a cellulose support. The new optode with the dye indicator 1-(2-pyridylazo)-2-naphthol (PAN) was incorporated in a new flow-through cell and the injection system was optimized to determine Cu (II) at 567 nm in the range 5 x 10(-5)-10(-3) M. The response was reproducible and the optode can be regenerated using 10(-2) M EDTA followed by water. The method was applied to the determination of copper in real samples.