全文获取类型
收费全文 | 30篇 |
免费 | 48篇 |
国内免费 | 17篇 |
专业分类
化学 | 14篇 |
晶体学 | 3篇 |
力学 | 1篇 |
数学 | 3篇 |
物理学 | 74篇 |
出版年
2022年 | 1篇 |
2020年 | 1篇 |
2019年 | 2篇 |
2018年 | 2篇 |
2015年 | 1篇 |
2014年 | 5篇 |
2013年 | 3篇 |
2012年 | 2篇 |
2011年 | 2篇 |
2010年 | 3篇 |
2009年 | 5篇 |
2008年 | 7篇 |
2007年 | 4篇 |
2006年 | 12篇 |
2005年 | 9篇 |
2004年 | 6篇 |
2003年 | 9篇 |
2002年 | 2篇 |
2001年 | 1篇 |
2000年 | 1篇 |
1999年 | 1篇 |
1998年 | 1篇 |
1997年 | 1篇 |
1996年 | 2篇 |
1989年 | 3篇 |
1985年 | 1篇 |
1984年 | 1篇 |
1983年 | 2篇 |
1981年 | 1篇 |
1980年 | 1篇 |
1979年 | 3篇 |
排序方式: 共有95条查询结果,搜索用时 140 毫秒
1.
制备了Tm3+,Yb3+共掺氟氧化物微晶玻璃, 在980 nm二极管激光器泵浦下研究了其上转换发光。发现将前驱玻璃进行热处理后,源于Tm3+的1G4能级到基态3H6跃迁所产生的蓝色上转换荧光在463 nm和476 nm出现明显劈裂。在此基础上分析了该劈裂蓝色上转换荧光在303~623 K范围内的温度特性。结果表明:Tm3+,Yb3+共掺氟氧化物微晶玻璃蓝色上转换荧光可应用于光学测温,其测温最大灵敏度为4.2×10-4 K-1,相应温度为352 K。 相似文献
2.
采用高温固相法制备了Tm3+,Yb3共掺CaWO4多晶材料. 980 nm二极管激光器激发下,在可见区获得了1G4→3H6,1G4→3H4,3H2,3H3→3H6 跃迁产生的上转换荧光. 讨论了Yb3+ 离子浓度的变化对Tm3+ 的上转换发光强度的影响,同时根据荧光强度比的方法研究了689 和705 nm 红色上转换荧光在313–773 K 范围内的温度特性. 结果表明:基于Tm3+,Yb3+ 共掺CaWO4 多晶材料的红色上转换荧光可以实现温度监测,其测温的最大灵敏度值为5.7×10-4 K-1,相应的测量温度为458 K.
关键词:
上转换发光
3+')" href="#">Tm3+
钨酸钙
荧光温度传感 相似文献
3.
典型的三聚氰胺致幼儿肾结石红外光谱分析 总被引:2,自引:0,他引:2
从云南省第一人民医院得到经过医学证实的典型三聚氰胺肾结石,将2 mg肾结石与200 mg KBr一同放入玛瑙研钵中研碎,进行压片。用Perkin-Elemer公司生产的spectrum 100光谱仪得到了该结石的红外光谱。吸收峰在4 000~2 000 cm-1之间有3 487,3 325,3 162,2 788 cm-1,在1 700~1 000 cm-1之间有1 694,1 555,1 383,1 340,1 189,1 122 cm-1,在1 000~400 cm-1之间有993,782,748,709,624,585,565,476 cm-1。结石的红外光谱经过与文献报道的饲喂含氰尿酸、三聚氰胺宠物饲料后猫的肾结石的红外光谱图及普通人肾结石的红外光谱图对比,相差很大,说明该患儿结石与宠物结石及普通人肾结石的成分相同的可能性不大;分别与三聚氰胺与尿酸的红外光谱图对比,各有50%的相似性;将三聚氰胺、尿酸按1∶1混合后,红外光谱出现的峰在4 000~2 000 cm-1之间有3 469,3 419,3 333,3 132,3 026,2 827cm-1,在1 700~1 000 cm-1之间有1 696,1 656,1 555,1 489,1 439,1 350,1 311,1 198,1 124,1 028cm-1,在1 000~400 cm-1之间有993,878,814,784,745,708,619,577,475 cm-1,将其与结石的红外光谱对比,发现两张图谱有83.3%的相似性,由此得出典型三聚氰胺尿结石的主要成分为三聚氰胺和尿酸。 相似文献
4.
We report a diode-pumped self-Q-switched 1064-nm Cr,Nd:YAG of 16-18 ns. The maximum average output power up to 7 W, 3370, is obtained in a simple and compact linear cavity by using transmittance of 1570. The laser operates at TEM00 mode with a laser with pulse duration in the range corresponding to a slope efficiency of a plane-concave output coupler with a pump power of 14.2 W. 相似文献
5.
用电子束蒸发的方法制备可变光学带隙薄膜硅材料, 给出了研究结果. 介绍了一种做透过率曲线切线确定薄膜光学带隙的简易方法, 给出了制备工艺和条件, 以及各种材料的隙态分布图. 实验发现, 材料的光学带隙宽度不但与量子尺度效应有关, 而且与缺陷形成的势垒高度和宽度以及有序短程(原子串)长度有关; 给出了常规硅材料的光学带隙与原子串长度的关系. 计算表明, 随着原子串长度的加大, 势阱中的电子液面升高, 载流子受缺陷势垒的散射减弱; 在原子串长度较低的情况下, 电子液面不总是随着原子串长度升高, 而是有较大的涨落, 形成锯齿状波动.计算还发现, 在势垒宽度与原子串长度之比不变的情况下, 电子液面还与势垒高度有关.
关键词:
薄膜硅
可变光学带隙
隙态分布
电子液面涨落 相似文献
6.
十八烷基二甲基氯化铵水溶液动态表面张力及吸附动力学研究 总被引:10,自引:0,他引:10
使用最大气泡法测定了十八烷基二甲基氯化铵(C_(18)DAC)水溶液的动态表 面张力,考察了浓度、温度等对其DST的影响,详细表征了DST随时间的变化过程, 计算了动态表面张力的各种参数(n,t_i,t~*,t_m,R_(1/2))。结合Word- Tordai方程计算了表观扩散系数(D_a)和吸附势垒(E_a),对其吸附动力学模式 进行了研究,探讨了DST参数的物理意义。结果表明,t~*值越小,吸附势垒E_a越 大,宏观扩散系数D_a越小,表面活性剂分子越不易吸附在溶液表面;C_(18)DAC低 浓度时吸附属于扩散控制模式,高浓度时属于混合控制模式;高浓度时,在吸附初 期(t → 0)为扩散控制模式,吸附后期(t → ∞)为混合控制模式。 相似文献
7.
Ultrafast time-resolved optical transmissions in purified and as-grown single-walled carbon nanotube films are measured at a temperature of 200K. The signal of the purified sample shows a crossover from photobleaching to photoabsorption. The former and the latter are interpreted as the state filling and the red shift of the π-plasmon, respectively. The signal of the as-grown sample can be perfectly fitted by a single-exponential with a time constant of 232fs. The disappearance of the negative component in the as-grown sample is attributed to the charge transfer between the semiconducting nanotubes and the impurities. 相似文献
8.
使用波长为808和658nm的半导体激光器和染料激光器作为激发源,测量了Er3+:YVO4晶体的波长在553和410nm附近的上转换荧光.对激发过程的分析表明,贡献于上转换荧光的主要激发机制为激发态吸收.在不同浓度下对上转换荧光的寿命测量结果显示,随Er3+浓度的提高,553nm绿光的荧光寿命随浓度的增加而减小,但410nm的荧光寿命随Er3+浓度无明显变化.结合绿光强度随掺杂浓度增加而减小的结果,认为在所测浓度范围内
关键词: 相似文献
9.
10.
We report the properties of a compact diode-pumped continuous-wave Nd:GdV04 laser with a linear cavity and different Nd-doped laser crystals. In a 0.2at.% Nd-doped Nd:GdVO4 laser, 1.54 W output laser power is achieved at 912nm wavelength with a slope efficiency of 24.8% at an absorbed pump power of 9.4W. With 0.3at.% Nd-doping concentration, we can obtain the either single-wavelength emission at 1064nm or 912nm or the dual-wavelength emission at 1064nm and 912nm by controlling the incident pump power. From an incident pump power of 11.6 W, the 1064nm emission between ^4Fa/2 and ^4I11/2 is suppressed completely by the 912nm emission between ^4Fa/2 and ^4I9/2. We obtain 670 mW output of the 912nm single-wavelength laser emission with a slope efficiency of 5.5% by taking an incident pump power of 18.4 W. Using a Nd:GdV04 laser with 0.4at.% Nd-doping concentration, we obtain either the single-wavelength emission at 1064nm or the dual-wavelength emission at both 1064nm and 912nm by increasing the incident pump power. We observe a strong competition process in the dualavelength laser. 相似文献