Thermodynamic possibilities and constraints of pure hydrogen production by a chromium,nickel, and manganese-based chemical looping process at lower temperatures

The reduction of chromium, nickel, and manganese oxides by hydrogen, CO, CH₄, and model syngas (mixtures of CO + H₂ or H₂ + CO + CO₂) and oxidation by water vapor has been studied from the thermodynamic and chemical equilibrium point of view. Attention was concentrated not only on the convenient conditions for reduction of the relevant oxides to metals or lower oxides at temperatures in the range 400–1000 K, but also on the possible formation of soot, carbides, and carbonates as precursors for the carbon monoxide and carbon dioxide formation in the steam oxidation step. Reduction of very stable Cr₂O₃ to metallic Cr by hydrogen or CO at temperatures of 400–1000 K is thermodynamically excluded. Reduction of nickel oxide (NiO) and manganese oxide (Mn₃O₄) by hydrogen or CO at such temperatures is feasible. The oxidation of MnO and Ni by steam and simultaneous production of hydrogen at temperatures between 400 and 1000 K is a difficult step from the thermodynamics viewpoint. Assuming the Ni—NiO system, the formation of nickel aluminum spinel could be used to increase the equilibrium hydrogen yield, thus, enabling the hydrogen production via looping redox process. The equilibrium hydrogen yield under the conditions of steam oxidation of the Ni—NiO system is, however, substantially lower than that for the Fe—Fe₃O₄ system. The system comprising nickel ferrite seems to be unsuitable for cyclic redox processes. Under strongly reducing conditions, at high CO concentrations/partial pressures, formation of nickel carbide (Ni₃C) is thermodynamically favored. Pressurized conditions during the reduction step with CO/CO₂ containing gases enhance the formation of soot and carbon-containing compounds such as carbides and/or carbonates.     

Tm3+/Yb3+共掺铋碲酸盐玻璃中的高效蓝色上转换荧光

制备了高折射率Tm3+/Yb3+共掺杂铋碲酸盐玻璃,利用棱镜耦合法测量出玻璃在632.8和1550 nm波长处的折射率分别为2.0365和1.9795. 对玻璃的吸收、荧光和红外透过光谱展开了测试与分析,根据Judd-Ofelt理论对吸收光谱进行拟合,求得Tm3+的振子强度参数Ωt(t=2,4,6)分别为3.90×10-20, 2.03×10-20和9.03×10-21 cm2,并进一步计算了Tm3+在玻璃中各能级跃迁的振子强度、自发辐射跃迁概率、辐射寿命和荧光分支比等光谱参数. 在980 nm激光激发下测得强的蓝色三光子上转换和近红外双光子上转换荧光. 宽的红外透过窗口、高的折射率和强的蓝色上转换荧光表明,Tm3+/Yb3+共掺铋碲酸盐玻璃有希望成为高效的上转换发光和激光材料.     

Cyclisation of α,ω-dienes promoted by bis(indenyl)zirconium sandwich and ansa-titanocene dinitrogen complexes

Metallation of a variety of α,ω-dienes has been explored with an η(9),η(5)-bis(indenyl)zirconium sandwich compound and an ansa-titanocene dinitrogen complex. The η(9),η(5)-bis(indenyl)zirconium sandwich compound, (η(9)-C(9)H(5)-1,3-Pr(2))(η(5)-C(9)H(5)-1,3-(i)Pr(2))Zr, served as an isolable source of Negishi's reagent and readily formed a kinetic mixture of cis and trans diastereomers of the corresponding zirconacyclopentanes upon diene metallation. For pure hydrocarbon substrates such as 1,6-heptadiene and 1,7-octadiene, an equimolar amount of cis and trans diastereomers were the kinetic products; isomerization to the thermodynamically favoured trans isomers was observed over time at ambient temperature or upon heating to 105 °C, respectively. By contrast, substitution of the methylene or ethylene spacer in the α, ω-diene with a fluorenyl group (e.g. 9,9-diallylfluorene) resulted in exclusive kinetic formation of the trans diastereomer. Amino-substituted dienes were also readily cyclised and one example was characterised by single-crystal X-ray diffraction. Similar studies were also conducted with the ansa-titanocene dinitrogen complex, [Me(2)Si(η(5)-C(5)Me(4))(η(5)-C(5)H(3)-3-(t)Bu)Ti](2)(μ(2),η(1),η(1)-N(2)), and both kinetic and thermodynamic selectivities evaluated. The use of a C(1) symmetric ansa-metallocene increases the number of isomeric possibilities. For diallyl tert-butyl amine, diene metallation was more selective than for the bis(indenyl)zirconium sandwich compound and isomerization was also more rapid. Preliminary functionalisation reactivity for both the zircona- and titanocycles was also explored.     

Light-induced absorption instability in weakly reduced congruent Er:LiNbO3 crystal

Light-induced absorption (LIA) characteristics in weakly reduced (or strongly annealed) congruent and/or vapor transport equilibration (VTE)-treated Er-doped LiNbO₃ crystals have been investigated in comparison with their corresponding as-grown ones and undoped crystals by using a polarized 632.8-nm beam as probe light and another polarized 632.8- or 488-nm beam as pump light. Under He-Ne pump, the LIA was observed only in strongly reduced pure VTE LiNbO₃ crystal. Under 488-nm pump, LIA is still not observed in the doped or undoped as-grown crystals. The weakly reduced VTE-treated Er(0.2 mol %):LiNbO₃ crystal displays weak and stable LIA. On the other hand, the corresponding weakly reduced congruent crystal displays a rather unpredictable light-induced absorption instability phenomenon. The instability was shown by the random competition of the LIA and light-induced transparency (LIT). When both crystals were further reduced, the VTE sample still shows stable LIA but with increased LIA, while the LIA in the congruent sample also becomes stable enough. The instability was experimentally proved to be associated with the presence of the Er³⁺ ion that performs the role of an extrinsic defect instead of photoluminescence. A three-level model is suggested that consists of a deep level (the bipolaron) and two shallow levels: the small polaron level and the level with respect to the Er³⁺ ion. The model has been employed to qualitatively explain the LIA characteristics of the weakly reduced congruent Er:LiNbO₃ crystal, including the the instability, the effect of the state of reduction, the pump intensity and the pump–probe polarization dependences. The inhomogeneity of the defects caused by the weak reduction and the simultaneous participation of the two shallow levels in the light-induced electron-transport process result in the random competition between LIA and LIT, and consequently result in the LIA instability. PACS 42.70.Hj; 42.70.Ln; 42.70.Mp; 42.65.Hw; 81.05.-t     

COMPUTATIONAL MULTISCALE METHODS FOR LINEAR HETEROGENEOUS POROELASTICITY

We consider a strongly heterogeneous medium saturated by an incompressible viscous fluid as it appears in geomechanical modeling.This poroelasticity problem suffers from rapidly oscillating material parameters,which calls for a thorough numerical treatment.In this paper,we propose a method based on the local orthogonal decomposition technique and motivated by a similar approach used for linear thermoelasticity.Therein,local corrector problems are constructed in line with the static equations,whereas we propose to consider the full system.This allows to benefit from the given saddle point structure and results in two decoupled corrector problems for the displacement and the pressure.We prove the optimal first-order convergence of this method and verify the result by numerical experiments.     

A ray model for hard parallel noise barriers in high-rise cities

A ray model is developed and validated for prediction of the insertion loss of hard parallel noise barriers placed in an urban environment either in front of a row of tall buildings or in a street canyon. The model is based on the theory of geometrical acoustics for sound diffraction at the edge of a barrier and multiple reflections by the ground, barrier and fa?ade surfaces. It is crucial to include the diffraction and multiple reflection effects in the ray model as they play important roles in determining the overall sound pressure levels for receivers located between the fa?ade and the near-side barrier. Comparisons of the ray model with a wave-based boundary element formulation show reasonably good agreement over a broad frequency range. Results of scale model experimental studies are also presented. It is demonstrated that the ray model agrees tolerably well with the scale model experimental data.     

Effects of ion clusters on the performance of a heavily doped erbium-doped fiber laser

A cluster model is proposed for study of the effects of the number of ions per cluster on the performance of a heavily erbium-doped fiber laser. The results indicate that both the threshold pump power and the unstable-operation region of the fiber laser increase with increasing numbers of ions per cluster.     

Determination of silver using cyclic epithermal neutron activation analysis

A fast pneumatic transfer facility was installed in Nuclear Engineering Teaching Laboratory (NETL) of the University of Texas at Austin for the purpose of cyclic thermal and epithermal neutron activation analysis. In this study efforts were focused on the evaluation of cyclic epithermal neutron activation analysis (CENAA). Various NIST and CANMET certified materials were analyzed by the system. Experiment results showed ¹¹⁰Ag with its 25 s half-life as one of the isotopes favored by the system. Thus, the system was put into practical application in identifying silver in metallic ores. Comparison of sliver concentrations as determined by CENAA in CANMET certified reference materials gave very good results.     

Design of flat-field arrayed waveguide grating with three stigmatic points

A new-type flat-field arrayed waveguide grating (AWG), with the focal signals of all wavelengths of operation focusing along a straight line, has been designed. The work bases on the aberration theory of AWG, in which the restraints imposed on the conventional Rowland-type AWG have been released. In the design of flat-field AWG, three stigmatic points restrain three dominant geometry parameters: geometry of star couplers, ports distribution of phased-array, and length increment between adjacent paths. An eight-channel 200-GHz spacing flat-field AWG has been designed and simulated. As stigmatic points introduced, the aberration of this device is much lower than that of the Rowland-type AWG.