Zwitterionic titanoxanes {Cp[η-C5H4B(C6F5)3]Ti}2O and {(η-PrC5H4)[η-1,3-PrC5H3B(C6F5)3]Ti}2O as catalysts for cationic ring-opening polymerization

Zwitterionic titanoxanes {Cp[η⁵-C₅H₄B(C₆F₅)₃]Ti}₂O (I) and {(η⁵-ⁱPrC₅H₄)[η⁵-1,3-ⁱPrC₅H₃B(C₆F₅)₃]Ti}₂O (II), which contain two positively charged Ti(IV) centres in the molecule, are able to catalyse the ring-opening polymerization of -caprolactone (-CL) in toluene solution and in bulk. The process proceeds with a noticeable rate even at room temperature and accelerates strongly on raising the temperature to 60 °C. The best results have been obtained on carrying out the reaction in bulk. Under these conditions, the use of I as a catalyst (-CL:I = 1000:1) gives at 60 °C close to quantitative yield of poly--CL with the molecular mass of 197 000. An increase in the -CL:I ratio to 6000:1 increases the molecular mass of poly--CL to 530 000. Tetrahydrofuran (THF) is also polymerized under the action of I albeit with a lesser rate. However, the molecular mass of the resulting poly-THF can reach rather big values under optimal conditions (up to 217 000 at 20 °C and the THF:I ratio of 770:1). A rise in the reaction temperature from 20 to 60 °C results here to a decrease in the efficiency of the process. Titanoxane II is close to I in its catalytic activity in the -CL polymerization but it is much less active in the polymerization of THF. Propylene oxide (PO), in contrast to -CL and THF, gives with I only liquid oligomers in wide temperature and PO:I molar ratio ranges (−30 to +20 °C, PO:I = 500–2000:1). γ-Butyrolactone and 1-methyl-2-pyrrolidone are not polymerized under the action of I at room temperature. The reactions found are the first examples of catalysis of the cationic ring-opening polymerization by zwitterionic metallocenes of the group IVB metals.     

Reduction of 1,4-dichlorobut-2-yne by titanocene to a 1,2,3-butatriene. Formation of a 1-titanacyclopent-3-yne and a 2,5-dititanabicyclo[2.2.0]hex-1(4)-ene

The 2,5-dititanabicyclo[2.2.0]hex-1(4)-ene (bis-titanocene-mu-(Z)-1,2,3-butatriene complex)3 is formed starting from [Cp2Ti(eta2-Me3SiC2SiMe3)] by in situ generated titanocene and 1,4-dichlorobut-2-yne via the 1-titanacyclobut-3-yne (2).     

Three‐Component Reactions with (S)‐Methyl Pyroglutamate: An Efficient Way to Diversely Substituted Asymmetric Amidocyclohexenes

Chiral N‐dienyl lactams are crucial building blocks for the synthesis of complex organic compounds. However, their generation is rather challenging. This paper reports the novel one‐pot reaction of (S)‐methyl pyroglutamate as the a mide component with different a ldehydes and d ienophiles (AAD reaction) to give novel chiral 1‐amido‐2‐cyclohexenes. The corresponding N‐dienyl lactams generated in situ undergo subsequent Diels–Alder reactions in good yield and diastereoselectivity. The scope and limitations of the three‐component protocol were investigated. X‐ray and NMR spectroscopic analysis of the products as well as DFT calculations of the intermediates were also performed to explain the observed stereoselectivity and structural features.     

Regioselective Synthesis of Trichloromethyl‐Substituted Salicylates and Cyclohexenones by One‐Pot Cyclizations of 1,3‐Bis(trimethylsilyloxy)buta‐1,3‐dienes

A variety of 6‐(trichloromethyl)salicylates (=2‐hydroxy‐6‐(trichloromethyl)benzoates) were prepared by TiCl₄‐mediated cyclization of 1,3‐bis(trimethylsilyloxy)buta‐1,3‐dienes with 1,1,1‐trichloro‐4,4‐dimethoxybut‐3‐en‐2‐one. The employment of trimethylsilyl trifluoromethanesulfonate (Me₃SiOTf) as Lewis acid resulted in the formation of trichloromethyl‐substituted cyclohexenones. The cyclizations proceeded with good‐to‐very‐good regioselectivities.