Simulation of a mixed-conducting membrane-based gas turbine power plant for CO<Subscript>2</Subscript> capture: system level analysis of operation stability and individual process unit degradation

A gas turbine power plant for CO₂ capture, based on oxygen-permeable membranes with mixed ionic-electronic conductivity, was analysed with respect to long-term stability by means of numerical simulation. Due to the attractive transport and physicochemical properties of mixed-conducting La₂NiO_4+δ, this nickelate was selected as a prototype membrane material for this application. Experiments showed very slow degradation of La₂NiO_4+δ membranes at oxygen chemical potentials close to atmospheric conditions, which are associated with kinetic demixing and other microstructure-related factors. Interaction with CO₂ in the intermediate temperature range also leads to lower oxygen permeation, whilst increasing oxygen pressure may cause partial phase decomposition and microstructural changes, thus again limiting the range of possible operation conditions. The relevant operational constraints were included in a detailed membrane-based gas turbine power plant model. The membrane performance degradation with time was approximated by a linear function with average rate of 3.3% per 1,000 operation hours. Furthermore, performance deterioration of the gas turbine compressor and turbine were also considered. Simulations revealed that the power plant is substantially affected by degradation of the ceramic membranes and turbomachinery components. The already rather small operating window was further narrowed when compared with a conventional gas turbine power plant. Two different designs of the membrane-based power plant were analysed: (1) with and (2) without additional combustors (afterburners) between the membrane reactor and the gas turbine. Afterburners increase thermal efficiency as well as power output, but also lead to non-negligible CO₂ emissions. In order to have a frame of comparison, results for a conventional gas turbine power plant with degradation of turbomachinery components are also presented. Simulations representing changes in ambient temperature and fuel composition as well as failure incidents were executed to analyse the susceptibility of the gas turbine power plant to external and internal changes.     

Near-Enantiopure Trimerization of 9-Ethynylphenanthrene on a Chiral Metal Surface

Enantioselectivity in heterogeneous catalysis strongly depends on the chirality transfer between catalyst surface and all reactants, intermediates, and the product along the reaction pathway. Herein we report the first enantioselective on-surface synthesis of molecular structures from an initial racemic mixture and without the need of enantiopure modifier molecules. The reaction consists of a trimerization via an unidentified bonding motif of prochiral 9-ethynylphenanthrene (9-EP) upon annealing to 500 K on the chiral Pd₃-terminated PdGa{111} surfaces into essentially enantiopure, homochiral 9-EP propellers. The observed behavior strongly contrasts the reaction of 9-EP on the chiral Pd₁-terminated PdGa{111} surfaces, where 9-EP monomers that are in nearly enantiopure configuration, dimerize without enantiomeric excess. Our findings demonstrate strong chiral recognition and a significant ensemble effect in the PdGa system, hence highlighting the huge potential of chiral intermetallic compounds for enantioselective synthesis and underlining the importance to control the catalytically active sites at the atomic level.     

Advanced Bifunctional Oxygen Reduction and Evolution Electrocatalyst Derived from Surface‐Mounted Metal–Organic Frameworks

Metal–organic frameworks (MOFs) and their derivatives are considered as promising catalysts for the oxygen reduction reaction (ORR) and oxygen evolution reaction (OER), which are important for many energy provision technologies, such as electrolyzers, fuel cells and some types of advanced batteries. In this work, a “strain modulation” approach has been applied through the use of surface‐mounted NiFe‐MOFs in order to design an advanced bifunctional ORR/OER electrocatalyst. The material exhibits an excellent OER activity in alkaline media, reaching an industrially relevant current density of 200 mA cm^?2 at an overpotential of only ≈210 mV. It demonstrates operational long‐term stability even at a high current density of 500 mA cm^?2 and exhibits the so far narrowest “overpotential window” ΔE_ORR‐OER of 0.69 V in 0.1 m KOH with a mass loading being two orders of magnitude lower than that of benchmark electrocatalysts.     

Diffusion of Quinine with Ethanol as a Co-Solvent in Supercritical CO2

This study aims at contributing to quinine extraction using supercritical CO₂ and ethanol as a co-solvent. The diffusion coefficients of quinine in supercritical CO₂ are measured using the Taylor dispersion technique when quinine is pre-dissolved in ethanol. First, the diffusion coefficients of pure ethanol in the supercritical state of CO₂ were investigated in order to get a basis for seeing a relative change in the diffusion coefficient with the addition of quinine. We report measurements of the diffusion coefficients of ethanol in scCO₂ in the temperature range from 304.3 to 343 K and pressures of 9.5, 10 and 12 MPa. Next, the diffusion coefficients of different amounts of quinine dissolved in ethanol and injected into supercritical CO₂ were measured in the same range of temperatures at p = 12 Mpa. At the pressure p = 9.5 MPa, which is close to the critical pressure, the diffusion coefficients were measured at the temperature, T = 343 K, far from the critical value. It was found that the diffusion coefficients are significantly dependent on the amount of quinine in a small range of its content, less than 0.1%. It is quite likely that this behavior is associated with a change in the spatial structure, that is, the formation of clusters or compounds, and a subsequent increase in the molecular weight of the diffusive substance.     

Enhancing the Hydrogen Evolution Reaction Activity of Platinum Electrodes in Alkaline Media Using Nickel–Iron Clusters

Herein, we demonstrate an easy way to improve the hydrogen evolution reaction (HER) activity of Pt electrodes in alkaline media by introducing Ni–Fe clusters. As a result, the overpotential needed to achieve a current density of 10 mA cm^?2 in H₂‐saturated 0.1 m KOH is reduced for the model single‐crystal electrodes down to about 70 mV. To our knowledge, these modified electrodes outperform any other reported electrocatalysts tested under similar conditions. Moreover, the influence of 1) Ni to Fe ratio, 2) cluster coverage, and 3) the nature of the alkali‐metal cations present in the electrolyte on the HER activity has been investigated. The observed catalytic performance likely originates from both the improved water dissociation at the Ni–Fe clusters and the subsequent optimal hydrogen adsorption and recombination at Pt atoms present at the Ni–Fe/Pt boundary.     

Hydrogen-bonded layer-by-layer films of block copolymer micelles with pH-responsive cores

The structure of grafted adsorbing polymers on surfaces is described as a statistical ensemble of loops generated by an one-dimensional random walk perpendicular to the surface. The configuration of each chain is considered as a succession of closed loops ended by an open loop (a tail). The probability of formation of each individual loop is the product between the probability of first return to the surface and a Boltzmann factor containing the free energy of the Flory-Huggins kind, which is approximated by the minimum free energy of all possible configurations of that loop. At high grafting densities, the attractive interactions between monomers and surface control the fraction of polymer belonging to either closed loops or tails, hence the formation of a stretched grafted brush. At low grafting densities, the increase of that interaction above a critical value generates an abrupt collapse of the brush on the surface. Whereas for long polymers (with more than about 100 Kuhn segments), the structure of the brush can be determined, in general, only via Monte-Carlo sampling, it is argued that the two structural transitions indicated above can be well predicted by simple approximations.     

QM:QM embedding using electronic densities within an ONIOM framework: energies and analytic gradients

Accurate calculations of large systems remain a challenge in electronic structure theory. Hybrid energy techniques are a promising family of methods for treating such systems. Expanding on previous developments, we present a QM:QM electronic embedding model whereby the high-level region is polarized by the electron density of the low-level region within an ONIOM framework. A direct Coulomb embedding model as well a more computationally efficient model involving a density fitting expansion are considered. We also develop a generalized theory for the first derivatives of these classes of QM:QM electronic embedding schemes, which requires solution of a single set of self-consistent field response equations. Two initial test cases are presented and discussed.     

Optimizing the Size of Platinum Nanoparticles for Enhanced Mass Activity in the Electrochemical Oxygen Reduction Reaction

High oxygen reduction (ORR) activity has been for many years considered as the key to many energy applications. Herein, by combining theory and experiment we prepare Pt nanoparticles with optimal size for the efficient ORR in proton‐exchange‐membrane fuel cells. Optimal nanoparticle sizes are predicted near 1, 2, and 3 nm by computational screening. To corroborate our computational results, we have addressed the challenge of approximately 1 nm sized Pt nanoparticle synthesis with a metal–organic framework (MOF) template approach. The electrocatalyst was characterized by HR‐TEM, XPS, and its ORR activity was measured using a rotating disk electrode setup. The observed mass activities (0.87±0.14 A mg_Pt^?1) are close to the computational prediction (0.99 A mg_Pt^?1). We report the highest to date mass activity among pure Pt catalysts for the ORR within similar size range. The specific and mass activities are twice as high as the Tanaka commercial Pt/C catalysis.