Synthesis, thermal treatment and characterization of cobalt ferrite-based nanocomposites

We have used time-differential perturbed angular correlation (PAC) spectroscopy with ¹⁸¹Ta-probes to study the electric field gradient at Zr-sites in synthetic zircon and hafnon between room temperature and 1,200°C. PAC spectra are similar to those obtained from naturally occurring zircons. In particular, a change in slope of the quadrupole coupling vs. temperature is observed in the synthetic zircon at the same temperature as seen in natural zircons from the Mud Tank carbonatite (Australia). The synthetic hafnon data also shows this feature but at somewhat higher temperature. Low-temperature PAC spectra of both synthetic zircon and hafnon have a clearly reduced anisotropy. We believe that the cause for this is a electronic defect, possibly created during the β-decay of the probe parent nucleus.     

Carrier diffusion in InGaAs/GaAs quantum wells grown on vicinal GaAs(0 0 1) substrates

We have investigated the influence of vicinal GaAs substrates on the optical and electronic properties of InGaAs/GaAs quantum wells (QWs). A single In_0.10Ga_0.90As QW was grown by molecular-beam epitaxy on a vicinal GaAs(0 0 1) substrate with a miscut angle of 0° (nominal), 2°, 4° and 6° towards [1 1 0]. The carrier diffusion was obtained by a micro-photoluminescence scan technique that permits to observe the effective diffusion length characterized by the lateral spread of carriers in the QW followed by radiative recombination. The carrier diffusion length was obtained parallel (L_||) and perpendicular (L) to the atomic steps. The diffusion length decreases as the temperature increases up to 100 K. Above this temperature we found different behaviours that depend on the sample miscut angle.     

Micro/nano-fibrillated cellulose (MFC/NFC) fibers as an additive to maximize eucalyptus fibers on tissue paper production

Tissue furnish optimization plays a key role in enhancing tissue properties, making the process cost-effective. Typically, this furnish is composed of a mixture of hardwood eucalyptus fibers (HW) and softwood (SW) fibers, which ensure strength and tissue machine runnability. However, the tissue paper production with the maximization of eucalyptus fibers achieves softer papers at less cost, since SW fibers are often more expensive than HW fibers. From this perspective, this study aims to investigate the effect of micro/nano-fibrillated cellulose (MFC/NFC) as an additive, on structural, softness, strength, and water absorption properties of tissue papers, promoting partial or total removal of SW fibers to produce 100% eucalyptus materials. MFC/NFC was characterized in terms of morphological, chemical, and water interaction properties. The results showed that MFC/NFC presents a high bonding surface area, high carboxyl group content and, when incorporated into tissue furnishes, it promotes strong inter-fiber bonds. This evidence was also supported by SEM image analysis methods and FTIR. Additionally, laboratory tissue handsheets with low basis weight were produced and used in the characterization assays. Overall, the results indicated that MFC/NFC improved strength, at the expense of bulk, porosity, softness, and absorption properties. Compared to typical industrial furnish mixtures (75%HW?+?25%SW), MFC/NFC enhanced the production of bulkier, porous, and softer structures, but with reduced strength and absorption. It was possible to optimize the furnish composition by using fiber modeling to obtain 3D structure computation simulations with predictive capability. The MFC/NFC proved to be a high-quality additive to improve softness and strength properties.

Graphic abstract

     

Nickel determination in osteoblast-like cell culture medium by adsorptive cathodic stripping voltammetry with a mercury microelectrode

The purpose of this study is to investigate the influence of nickel, which is an alloying element in commonly used metallic biomaterials, on the biomaterials mineralization process. An electrochemical method was developed to quantify this metal ion in osteoblast-like cell culture medium (OST) by performing adsorptive cathodic stripping voltammetry (CSV) with dimethylglyoxime (DMG) at a mercury film microelectrode (MFM). The optimized analytical conditions and the square-wave CSV parameters for the analysis are: DMG concentration: 5.00 × 10⁻⁴ mol L⁻¹; ammonium chloride buffer: 0.10 mol L⁻¹ (pH 9.2); frequency: 50 Hz, amplitude 20 mV; step: 2 mV; adsorption time: 10 s, deposition potential: −0.70 V and reduction potential: −1.20 V. The limit of detection was 7.70 × 10⁻⁹ mol L⁻¹ for an adsorption time of 10 s. The results achieved by CSV using the MFM were compared to those obtained by atomic absorption spectrometry (AAS) to ensure the reliability of the electrochemical method. The mineralization process was evaluated by biochemical and histochemical assays.     

Thermal and mechanical properties of PE/organoclay nanocomposites

Polyethylene/montmorillonite clay nanocomposites were obtained via direct melt intercalation. The clay was organically modified with four different types of quaternary ammonium salts. The objective of this work is to study the use of montmorillonite clay in the production of nanocomposites by means on rheological, mechanical and crystallization properties of nanocomposites and to compare to the properties of the matrix and PE/unmodified clay nanocomposites. In general, the tensile test showed that the yield strength and modulus of the nanocomposites are close to the pure PE. Apparently, the mixture with Dodigen salt seems to be more stable than the pure PE and PE/unmodified clay.     

Study of process parameters for starch,gluten, and glycerol mixtures

This work involved a study of the effect of processing variables (temperature, water content, rotor speed, and time) on the mechanical properties of starch:gluten:glycerol mixtures in the weight ratio of 40:40:20. The properties of the materials were affected by the processing variables. The torque decreased with water content, indicating that water facilitates the plasticization of mixtures, whereas the increase in temperature accelerated the evaporation of water, thus increasing the torque. Ultimate tensile strength was achieved at the lowest temperature (110°C) and the highest water content (20%), whereas maximum elongation was achieved for the material processed at the highest temperature, 150°C, and the fastest rotor speed, 70 rpm. Copyright © 2007 John Wiley & Sons, Ltd.     

A novel bioassay for screening and quantification of taxanes

We report a novel method for screening and quantifying tubulin-binding antimitotic agents that promote microtubule formation. The method is based on the shift in the peak of the fluorescence emission difference spectrum of tubulin complexed to metal free tetrakis(4-carboxyphenyl)porphyrin (TCPP) in the presence of antimitotic agents. Taxol (paclitaxel), an anti-tumor drug approved for the treatment of a variety of cancers, caused the appearance of a new fluorescence peak at 645 nm at concentrations as low as 125 nM, the intensity of which was a function of the paclitaxel concentration. Cephalomannine caused the induction of a new fluorescence peak at 651 nm only above 1 muM. Baccatin did not induce the appearance of any new peak within detectable operating measurement conditions. These observations are in accordance with the biological activities/cytotoxicities of these compounds. Accordingly, it is proposed that the new method can be used for high throughput screening of antimitotic compounds.     

Stability of anthocyanins extracted from grape skins

Summary The extractability and stability of anthocyanins from the skins ofVitis vinifera were determined at different pH values. Anthocyanins were extracted using acetone, partitioned with chloroform and pre-purified by solid-phase extraction (SPE). They were analysed by RP-HPLC, and the kinetic parameters of decomposition were calculated. The total monomeric anthocyanin content was determined by spectrophotometry. Anthocianins were well separated by RP-HPLC. The efficiency of extraction depended strongly on the pH of the extracting agent and on the character of the pigment to be extracted. The amount of anthocyanins decreased with increasing duration of storage, more so at elevated temperatures. Presented at Balaton Symposium '01 on High-Performance Separation Methods Siófok, Hungary, September 2–4, 2001.     

Diffusion layer titration of dipyrone in pharmaceuticals at a dual-band electrochemical cell

This paper describes the use of a thin-layered dual-band electrochemical cell operating at flow conditions to determine dipyrone (sodium salt of 1-phenil-2,3-dimethyl-4-methylaminomethanesulfonate-5-pyrazolone) by reaction with electrogenerated iodine. The electrolytic cell consisted of two closely spaced gold electrodes, the upper stream electrode serving as the generator electrode and the downstream electrode working as the collector electrode. A linear dynamic range from 2 to 15 μmol l⁻¹ dipyrone was obtained by using a sample volume of 100 μl, with a detection limit of 1.1 μmol l⁻¹. Standard deviation (S.D.) of 3.4% for 20 repetitive injections of a 40 μmol l⁻¹ dipyrone solution and sampling frequency of 90 h⁻¹ were achieved. The results obtained with the thin-layered dual-band electrochemical cell for dipyrone determination in three different pharmaceutical samples compared well with those found by iodimetry with coulometrically generated iodine.     

Separation and quantitation of colour pigments of chili powder (Capsicum frutescens) by high-performance liquid chromatography-diode array detection

The performance of reversed-phase thin-layer (RP-TLC) and reversed-phase high-performance liquid chromatography (RP-HPLC) was compared for the separation and determination of the colour pigments of chili (Capsicum frutescens) powder using a wide variety of eluent systems. No separation of pigments was achieved in RP-TLC, however, it was established that tetrahydrofuran shows an unusually high solvent strength. RP-HPLC using water-methanol-acetonitrile gradient elution separated the chili pigments in many fractions. Diode array detection (DAD) indicated that yellow pigments are eluted earlier than the red ones and chili powder contains more yellow pigments than common paprika powders. It was established that the very different absorption spectra of pigments make the use of DAD necessary.