在粗糙表面上用液晶空间光调制器进行振动测量

为实现在一段时间内连续实时观测振动物体的全息干涉图形,采用覆盖铝箔的喇叭作为振动物体,利用铝箔原有未经特殊处理表面反射的漫反射光成像,并用光寻址液晶空间光调制器(Liquid crystal-sparial lightmodulator,LC-SLM)作为全息记录载体,来实现振动测量。实验中采用时间平均干涉测量法,得到了不同振动频率下物体的干涉图形。同时在连续改变振动物体的振动频率时,可以清晰地观察到物体振动全息干涉图形的变化过程,即近实时的全息干涉图形。     

Effect of annealing on structure and permeability of poly [(l-trimethylsilyl)-l-propyne]

The permeability of annealed poly (l-(trimethylsilyl)-l-propyne) was studied from the viewpoint of structural information obtained from x-ray diffraction and density. The sample cast from benzene solution had low density (0.82 g/cm³) and high permeability, whereas the annealed sample had a higher density (0.88 g/cm³) and permeability lower by two orders of magnitude. The smaller-angle x-ray diffraction peak for each sample, which was likely to reflect the distance between intermolecular chains, increased in intensity and shifted toward higher angle, corresponding to the change of the density with annealing. The logarithmic oxygen permeability was proportional to the density, namely the free volume fraction correlated with the diffusion coefficient and controlled by annealing and swelling by alcohols.     

Secondary hypervalent I(III)...O interactions: synthesis and structure of hypervalent complexes of diphenyl-lambda3-iodanes with 18-crown-6

Reported here for the first time are the synthesis and characterization of supramolecular complexes between diaryl-lambda(3)-iodanes and 18-crown-6 (18C6). Slow evaporation of solvents afforded 1:1 and 2:1 complexes between Ph(2)IBF(4) and 18C6 as stable crystals, depending on the conditions. X-ray crystal structures of these complexes indicated that each iodine atom contacts with the three adjacent oxygen atoms of 18C6 through two hypervalent secondary bonding and a weak interaction. (1)H NMR analyses and CSI-MS spectra showed that, in dichloromethane solution, Ph(2)IBF(4) exclusively forms the 1:1 complex with 18C6 (binding constant K(a), 1.02 x 10(3) M(-)(1)). The binding constants decrease with the increased solvent donor ability (Gutmann's DN). Changing the heteroatom ligand from BF(4) to the less nucleophilic PF(6) and AsF(6) increased the binding constant by about six times. Substitution of an electron-withdrawing group onto the para position of Ph(2)IBF(4) tends to increase in the complex stability. A linear Hammett relationship (rho = 0.59) between log K(a) and sigma(p)(+) values of substituents indicates that the diaryl-lambda(3)-iodanes with electropositive iodine(III) interact more efficiently with 18C6. Decreased binding magnitude was measured with 15C5, dibenzo-18C6, dibenzo-21C7, and dibenzo-30C10.     

Molecular vibrations in a gradient extremal path

Summary The calculation of vibrational states using a gradient extremal path is discussed. Gradient extremal paths are defined by local criteria, which lead to stable solutions. This has certain advantages in comparison with a steepest-descent path, which is often difficult to determine accurately. For cases where a reaction path formalism is applicable, a path based on the gradient extremal concept gives results in close agreement with those obtained using traditional steepest-descent methods. We present algorithms for carrying out such calculations and also give some numerical results.     

Microporous, fast response cellulose ether hydrogel prepared by freeze-drying

A simple and effective method of preparing fast-response gels is developed. The freeze-drying and subsequent rehydration of thermosensitive gels alters the microstructural properties of the gels in a way that leads to rapid shrinking rates. Microporous hydroxypropyl cellulose (HPC) gels were created by this method to investigate the influence of the process on the swelling and shrinking kinetics of the gels in response to temperature changes. Micropores of different size ranges were produced by freezing gels with different amounts of water at −20 °C. Water content was the key factor to control the microporosity and the shrinking rates of gels. After the freezing treatment, an effective diffusion coefficient for shrinking could be determined by fitting Fick's law to the data (5.2 × 10⁻⁴ cm²/s). This was an increase of two orders of magnitude over that of the untreated, non-porous gel (6.0 × 10⁻⁶ cm²/s). The magnitude of the shrinking coefficient indicates that the shrinking rate of the microporous gel is probably limited by the convective flow, as unsteady flow through porous media follows the same differential equation as Fick's law, but with much greater transport coefficients, as observed here. Physically, the shrinking rate may be determined by the level of interconnected-cells in a microporous structure present at the beginning of shrinking process because the convection through the interconnected-cells is estimated to be much slower than the polymer network diffusion rate of the struts of micropores (0.1–3.0 μm) as well as heat transfer.     

Novel Knöevenagel-type reaction via titanium enolate derived from Ti(O-i-Pr)4 and diketene

Knöevenagel-type reaction between diketene and aldehydes proceeded in the presence of Ti(O-i-Pr)₄. This reaction proceeded via titanium enolate derived from Ti(O-i-Pr)₄ and diketene. As for the stereoselectivity of the products, E-isomers were produced predominantly in the case of aromatic aldehydes.     

Stereospecific synthesis of eight- and nine-membered cyclic ethers by Eu(fod)3-mediated cyclization of hydroxy epoxides

An efficient and versatile method for the stereospecific construction of α,ω-cis- and α,ω-trans-disubstituted eight- and nine-membered cyclic ethers was developed. Cyclization of the hydroxy epoxides promoted by Eu(fod)₃ proceeded via an S_N2 process and exo mode to provide the corresponding cyclic ethers in excellent yields.     

Imaging of enzyme activity by scanning electrochemical microscope equipped with a feedback control for substrate-probe distance

The enzymatic activity of diaphorase (Dp) immobilized on a solid substrate was characterized using a scanning electrochemical microscope (SECM) with shear force feedback to control the substrate-probe distance. The shear force between the substrate and the probe was monitored with a tuning fork-type quartz crystal and used as the feedback control to set the microelectrode probe close to the substrate surface. The sensitivity and the contrast of the SECM image were improved in the constant distance mode (distance, 50 nm) with the shear force feedback compared to the image in the constant height mode without the feedback. By using this system, the SECM and topographic images of the immobilized diaphorase were simultaneously measured. The microelectrode tip used in this study was ground aslant like a syringe needle in order to obtain the shaper topographic images. This shape was also effective for avoiding the interference during the diffusion of the enzyme substrates.