Lie-group method solution for two-dimensional viscous flow between slowly expanding or contracting walls with weak permeability

The non-linear equations of motion describing the laminar, isothermal and incompressible flow in a rectangular domain bounded by two weakly permeable, moving porous walls, which enable the fluid to enter or exit during successive expansions or contractions, are considered. We apply Lie-group method for determining symmetry reductions of partial differential equations. Lie-group method starts out with a general infinitesimal group of transformations under which given partial differential equations are invariant, then, the determining equations are derived. The determining equations are a set of linear differential equations, the solution of which gives the infinitesimals of the dependent and independent variables. After the group has been determined, a solution to the given partial differential equation may be found from the invariant surface condition such that its solution leads to similarity variables that reduce the number of independent variables in the system. Effect of the permeation Reynolds number R_e and the dimensionless wall dilation rate α on self-axial velocity have been studied both analytically and numerically and the results are plotted.     

A facile synthesis of novel triazoloquinoxahnones and triazinoquinoxalinones

A series of 1-aryl-s-triazolo[4,3-a]quinoxalin-4-ones, 3 , were synthesized via the pyrolysis of the corresponding hydrazones, 6 . Thus, the cyclodehydrogenation occurred by refluxing them in an inert solvent (e.g. ethylene glycol) to give the triazoloquinoxalin-4-ones in a satisfactory yield. Using DMSO as a solvent for the above transformation afforded as a minor by-product an S-ylid. In contrast to earlier findings, annelation of a six-membered ring was successful and achieved through the pyrolysis of the pyruvate hydrazones derived of the quinoxalin-4-ones at ?230° to give the as-triazino[4,3-a]quinoxalin-5-ones, 4 . The reaction of 5 with acetylacetone afforded 3-(3′,5′-dimethylpyrazol-1-yl)-2(1H)-quinoxalinone, 10 . The structural assignments for the new compounds were based on their elemental analysis and spectroscopic data as well as an independent synthesis.     

Experimental and theoretical approaches to the study of the reactivity and mechanism of the substitution of phenyl 1-(2,4-dinitronaphthyl) ether with anilines derivatives

Reactions of aniline derivatives in dimethyl sulfoxide with phenyl 1-(2,4-dinitronaphthyl) ether yield aryl 1-(2,4-dinitronaphthyl) amine, which results in substitution of the phenoxy groups at the naphthyl ipso carbon atom. Rate constants were measured spectrophotometrically, and reaction proton transfer was rate limiting. The values of the rate coefficients indicate a rate-limiting proton transfer mechanism with significant substituent effects. The calculated activation parameters were of regular variation with substituents in 4- and 3-position in the aniline nucleophile, and the reaction proceeded through a common mechanism. Hammett's reaction constant showed that the reaction rate constants depend on the electron density of the nitrogen atom of aniline derivative, whereas the coefficient value obtained from the Brönsted relation indicated that the reaction was significantly associative and quite zwitterion like. Computational studies of the substitution were carried out based on density functional theory, and theoretical to the experimental agreement was achieved.     

Anchored Synthesis for Some Novel Mono and Disarylazo 1,2,4-Benzothiadiazine-Based Dyestuffs as Alternatives for Benzidine-Based Dyes

A one mono and two disarylazo series of 1,2,4-benzothiadiazine-based dyestuffs has been synthesized with a view that these products, with their new all-round tinctorial properties, might find an application as new categories of direct dyes that satisfactorily replace prohibited benzidine-based dyes.

The assigned structures for the hitherto prepared dyes were confirmed on the basis of elemental analysis as well as spectral data and, whenever possible, by alternative synthetic routes. Moreover, the predominant tautomeric structures for these highly colored products were tested and discussed on the basis of their spectral behavior.     

Retention profile of Fe,Mn and Cu onto chemically treated polyurethane with carbon disulfide

Dithiocarbamate modified polyurethane foam (DTC-PUF) was synthesized as a new solid-phase extraction sorbent for the preconcentration and determination of Fe(II), Mn(II) and Cu(II) in environmental samples using flame atomic absorption spectrometry. Maximum extraction of the elements was achieved at pH 5–7 and flow rate 3 mL min^?1. Quantitative desorption was achieved by 10 mL from 1.0 mol L^?1 HCl solution. The capacity of the sorbent was 149.2 ± 0.5, 237.5 ± 0.2, 200.2 ± 0.1 μg g^?1 and the limit of detection was of 0.015, 0.015 and 0.012 μg mL^?1for Fe(II), Mn(II) and Cu(II), respectively. A preconcentration factor of 100 was obtained for all elements. The developed method was successfully applied to the determination of the tested elements in water (tap and lake) and plant (spinach and parsley leaves) samples and showed good recovery values from 98 to 111% with corresponding RSD values ranged from 0.6 to 8.6%.     

Effect of moisture content on the 222Rn mass exhalation rates for different grain-size samples of red brick and cement mortar used in Qena city,Egypt

Journal of Radioanalytical and Nuclear Chemistry - Four different grain size fractions (0.2–0.5, 0.5–1, 1–1.8, 1.8–2 mm) of red brick and cement mortar samples at...     

Bioactive Components of Salvia and Their Potential Antidiabetic Properties: A Review

The utilization of therapeutic plants is expanding around the globe, coupled with the tremendous expansion of alternative medicine and growing demand in health treatment. Plants are applied in pharmaceuticals to preserve and expand health—physically, mentally and as well as to treat particular health conditions and afflictions. There are more than 600 families of plants identified so far. Among the plants that are often studied for their health benefit include the genus of Salvia in the mint family, Lamiaceae. This review aims to determine the bioactive components of Salvia and their potential as antidiabetic agents. The search was conducted using three databases (PubMed, EMBASE and Scopus), and all relevant articles that are freely available in the English language were extracted within 10 years (2011–2021). Salvia spp. comprises many biologically active components that can be divided into monoterpenes, diterpenes, triterpenes, and phenolic components, but only a few of these have been studied in-depth for their health benefit claims. The most commonly studied bioactive component was salvianolic acids. Interestingly, S. miltiorrhiza is undoubtedly the most widely studied Salvia species in terms of its effectiveness as an antidiabetic agent. In conclusion, we hope that this review stimulates more studies on bioactive components from medicinal plants, not only on their potential as antidiabetic agents but also for other possible health benefits.     

Synthesis of some furochromonesulfonamide derivatives with potential pharmacological activity

A number of visnagin-9-sulfonamides 1-3 have been prepared. In two instances side-products have been isolated in which the γ-pyrone ring is opened. All compounds were characterized by high-field ¹H and ¹³C nmr and mass spectra.     

Efficient way for detection of alcohols using hollow core photonic crystal fiber sensor

Optical Review - In this study, a simple hollow core hexagonal structured photonic crystal fiber is offered and analyzed to discern commonly used different type of alcohols in our daily life. The...