Thermal conductivity of crystalline chrysotile asbestos

The thermal conductivity of crystalline chrysotile asbestos made up of hollow tubular Mg₃Si₂O₅(OH)₄ filaments is measured in the range 5–300 K. The paper discusses the possibility of using this material in studies of the thermal conductivity of thin filaments of metals and semiconductors incorporated into the channels of crystalline chrysotile asbestos tubes.     

Phonon scattering from the boundaries of small crystals embedded in a dielectric porous-glass matrix

The thermal conductivity of porous glass with randomly distributed connecting pores ～70 Å in size (glass porosity ～25%), as well as of a porous glass + NaCl composite, was measured in the temperature range 5–300 K. NaCl filled one fourth of the pores in the composite. The experimental results on the composite thermal conductivity can be accounted for only by assuming that phonons scatter from the boundaries of NaCl nanocrystals embedded in channels of the porous glass.     

Effect of mobile phase composition on the SMB processes efficiency. Stochastic optimization of isocratic and gradient operation

The solvent composition was adjusted in a theoretical study in order to maximize the efficiency of a simulated moving bed (SMB) process. The isocratic realization of the process as well as the solvent gradient mode were considered. The solvent composition and the flow rates were used as decision variables in a random search optimization algorithm known to be a reliable tool for nonlinear programming problems. The results of the optimization indicate that the optimal composition of the mobile phase depends strongly on the feed concentration. The asymmetry of the internal concentration profiles, which has a negative effect on the separation efficiency, can be partly damped by an increase of the solvent strength. In the cases studied the optimal solvent strength determined for concentrated feed streams is higher than that for diluted ones. Moreover, the optimum is strongly influenced by the value of the selectivity factor and its dependency on the mobile phase composition. Different results were obtained for cases, in which the separation factor increases with increasing the modifier concentration, than for cases, in which the separation factor decreases with increasing the modifier concentration. A similar analysis was performed for a solvent gradient SMB process, in which different solvents are used at the two inlet ports: a weak solvent in the feed stream and a strong solvent in the desorbent stream. Again the optimal mobile phase composition was strongly affected by the type of the isotherms and their non-linearity. The potential of a gradient SMB process in terms of increasing the productivity and reducing the eluent consumption is exemplified.     

Green and red fluorescent proteins: photo- and thermally induced dynamics probed by site-selective spectroscopy and hole burning.

The cloning and expression of autofluorescent proteins in living matter, combined with modern imaging techniques, have thoroughly changed the world of bioscience. In particular, such proteins are widely used as genetically encoded labels to track the movement of proteins as reporters of cellular signals and to study protein-protein interactions by fluorescence resonance energy transfer (FRET). Their optical properties, however, are complex and it is important to understand these for the correct interpretation of imaging data and for the design of new fluorescent mutants. In this Minireview we start with a short survey of the field and then focus on the photo- and thermally induced dynamics of green and red fluorescent proteins. In particular, we show how fluorescence line narrowing and high-resolution spectral hole burning at low temperatures can be used to unravel the photophysics and photochemistry and shed light on the intricate electronic structure of these proteins.     

Heat capacity of the white pine biocarbon preform and the related biocarbon/copper composite

This paper reports on measurements in the 80–300-K temperature interval of the heat capacity at constant pressure C _p (T) of high-porosity amorphous white pine carbon preforms (biocarbon) prepared by pyrolysis (carbonization) at T _carb = 1000 and 2400°C in an argon flow. The dependences C _p (T) for biocarbon/copper composites based on the carbon preforms obtained have also been determined. It is shown that the mixture rule holds for the composites, i.e., that C _p (T) of the composite is a sum of the heat capacities of the constituent materials taken in the corresponding ratios. Phonon mean free paths for the white pine carbon preforms prepared at T _carb = 1000 and 2400°C have been calculated and used to estimate the size of the nanocrystallites contributing to formation of the carbon frameworks of these preforms.     

The power of line-narrowing techniques: Applications to photosynthetic chromoprotein complexes and autofluorescent proteins

Laser spectroscopic techniques at low temperature, such as fluorescence line-narrowing and hole burning, enable an increase of spectral resolution by a factor of 10³–10⁵ compared to conventional spectroscopy at room temperature. With these methods, it is possible to retrieve a fingerprint of the species involved and to measure the rates of dynamic processes that normally remain hidden in the broad absorption bands. A few applications carried out in our laboratory will be discussed: (1) the determination of energy transfer rates in the peripheral LH2 complex of purple bacteria; (2) the study of spectral diffusion and its implications in three types of systems: (a) the B820 and B777 subunits of the LH1 complex of purple bacteria, (b) the photosystem II reaction center (PSII RC) and CP47 antenna complex of green plants, and (c) an organic glass doped with bacteriochlorophyll a; (3) the unraveling of 0-0 transitions and the pathways of photoconversion between a number of conformations of the green fluorescent protein mutant S65T; (4) the measuring of electron-phonon coupling strengths in PSII RC and the red fluorescent protein DsRed; and (5) the determination and comparison of the homogeneous linewidths and optical dephasing in photosynthetic chromoprotein complexes and autofluorescent proteins.     

Specific heat and velocity of sound in a moderate heavy-fermion compound YbZnCu4

The specific heat at a constant pressure (C _p) and the velocity of sound (v) are measured for a moderate heavy-fermion compound YbZnCu₄ in the temperature range 3.5–250 K and at 77 K, respectively. The experimental values of C _p and v obtained in this study and the phonon thermal conductivity previously measured in the temperature range 5–300 K are used to calculate the phonon mean free path l for this compound. The temperature dependence of the phonon mean free path l thus determined is characteristic of classical amorphous materials.     

Heat conductivity of LuAgCu4

The electrical resistivity and heat conductivity of LuAgCu₄ have been studied within the 4.2–300-K range. An additional contribution to heat conductivity, most probably due to the bipolar component, has been revealed at T≥100 K. The conclusion is drawn that LuAgCu₄ is apparently a semimetal.     

Specific features in the behavior of electrical resistivity of the pine biocarbon preform/copper composite

The electrical resistivity ρ(T) of the novel type of composites prepared by infiltrating melted copper in vacuum in empty sap channels of white pine high-porosity biocarbon preforms has been measured in the temperature range 5–300 K. Biocarbon preforms have been prepared by pyrolysis of tree wood in an argon flow at two carbonization temperatures, 1000 and 2400°C. The electrical resistivity of the composites has been found to vary relatively weakly with temperature and to pass through a characteristic minimum near 40–50 K, which can be ascribed to iron and manganese impurities penetrating into copper from the carbon preform when liquid copper is infiltrated into it. It has been shown that the electrical resistivity ρ(T) of the composites is governed primarily by the specific microstructure of the preform, which is made up of parallel channels with an average diameter of about 50 μm interrupted by systems of thin capillaries. The small cross section of the copper-filled capillaries accounts for these regions providing the major contribution to the electrical resistivity of the composites. An increase in the wood carbonization temperature brings about a noticeable increase in the effective capillary cross section and a decrease in the electrical resistivity ρ(T) of the composite.     

Coherent effects in regular three-dimensional lattices of insulator nanocrystals in an opal matrix

Samples of the nanocomposite opal + NaCl with 100% filling of first-order voids in the opal by NaCl have been obtained. The thermal conductivity of the nanocomposite has been measured in the temperature interval 4.2–300 K. It is shown that NaCl, introduced into opal, forms a regular “matrix quasilattice” of microcrystals, which leads to suppression of coherent effects and, as a consequence, of properties characteristic of massive crystals. Fiz. Tverd. Tela (St. Petersburg) 41, 348–353 (February 1999)