Synthetic, structural and spectroscopic studies of (pseudo)halo(1,3-di-tert-butylimidazol-2-ylidine)gold complexes

A series of (pseudo)halo(1,3-di-tert-butylimidazol-2-ylidine)gold complexes [(But2Im)AuX](X = Cl, Br, I, CN, N3, NCO, SCN, SeCN, ONO2, OCOCH3, CH3) have been synthesized and characterised spectroscopically and structurally. 13C NMR chemical shifts for the carbene carbon vary widely with differing ancillary anion, correlating well with the sigma-donor ability of the latter and with the M-C(carbene) bond distance. These results reinforce the notion that N-heterocyclic carbene ligands are primarily sigma-donor ligands with little pi-acceptor ability.     

Polarographic reduction of pyridinium ion in pyridine tetraethylammonium perchlorate as background electrolyte

Tetraethylammonium perchlorate, compared to lithium perchlorate as background electrolyte for the reduction of pyridinium ion in pyridine, is effective over a wider potential range, but is more difficult to obtain in a pure state; slight amounts of impurities do not, however, affect the pyridinium wave. The pyridinium wave produced in 0.1 M Et₄NClO₄ may occur at a more negative potential than the main pyridinium wave in 0.1 M LiClO₄, depending on the source of the pyridinium ion, but still appears to be due to a diffusion-controlled reduction, whose limiting current is linearly proportional to concentration; the prewave observed in LiCl0₄ background generally does not appear in Et₄NClO₄ background. Specific differences in the effect of Li(I), Na(I) and Et₄N(I) background cation appear to be due to electrocapillary phenomena and perhaps to the extent of solvation of the ions. The constancy of current for solutions containing acetic acid with added acetate, pyridinium nitrate with added nitrate, and benzoic acid with added benzoate indicate that the pyridinium reduction is independent of anion concentration.     

A comparison of crystalline- and graft polymer-based chemosensors

Herein, we report a highly sensitive luminescent thin film chemosensor constructed out of a small-molecule donor/acceptor system. Two types of films were compared: one using a small-molecule crystalline donor/acceptor pair and the other using a donor-graft polymer/small-molecule acceptor pair. The acceptor selected for this proof of concept responds to acid, causing its absorption and emission bands to red-shift, which increases spectral overlap with the donor. This increase in overlap greatly enhances energy transfer from the acceptor to the donor. Signal amplification was ascertained by measuring the ratio of acceptor fluorescence when the donor was excited versus direct excitation of the acceptor. Both types of films exhibited large amplification. For the polymeric system, the mechanism of energy migration was investigated by the use of steady-state fluorescence spectroscopy. The mechanism was determined to be dominated by an exciton-hopping process.     

Single-frequency, single-mode, plane-polarized ytterbium-doped fiber master oscillator power amplifier source with 264 W of output power

We present a single-frequency, single-mode, plane-polarized ytterbium-doped all-fiber master oscillator power amplifier source at 1060 nm generating 264 W of continuous-wave output power. The final-stage amplifier operated with a high gain of 19 dB and a high conversion efficiency of 68%. There was no evidence of rollover from stimulated Brillouin scattering even at the highest output power, and the maximum output was limited only by the available pump power.     

Hazard Evaluation of Ten Organophosphorus Insecticides Against the Midge,Chironomus riparius via QSAR

Abstract

Toxicities of ten organophosphorus (OP) insecticides were measured against midge larvae (Chironomus riparius) under varying temperature (11, 18, and 25°C) and pH (6, 7, and 8) conditions and with and without sediment. Toxicity usually increased with increasing temperature and was greater in the absence of sediment. No trend was found with varying pH. A series of unidimensional parameters and multidimensional models were used to describe the changes in toxicity. Log K _ow was able to explain about 40–60% of the variability in response data for aqueous exposures while molecular volume and aqueous solubility were less predictive. Likewise, the linear solvation energy relationship (LSER) model only explained 40–70% of the response variability, suggesting that factors other than solubility were most important for producing the observed response. Molecular connectivity was the most useful for describing the variability in the response. In the absence of sediment, ¹χ ^v and ³κ were best able to describe the variation in response among all compounds at each pH (70–90%). In the presence of sediment, even molecular connectivity could not describe the variability until the partitioning potential to sediment was accounted for by assuming equilibrium partitioning. After correcting for partitioning, the same molecular connectivity terms as in the aqueous exposures described most of the variability, 61–87%, except for the 11°C data where correlations were not significant. Molecular connectivity was a better tool than LSER or the unidimensional variables to explain the steric fitness of OP insecticides which was crucial to the toxicity.