Controlling quantum coherence of atom laser by light with strong strength

A new method for controlling the quantum coherence of atom laser by applying input light with strong strength is presented within the framework of quantum dynamical theory. Unlike the case of rotating wave approximation(RWA), we show that the non-classical properties, such as sub-Poisson distribution and quadrature squeezed effect, can appear in the output atom laser beam with time. By choosing suitable initial RF phase, a steady and brighter output of squeezed coherent atom laser is also available.     

Statistical Analysis of the Effect of Mineral Admixtures on the Strength of the Interfacial Transition Zone

Microscopic evidence indicates that the thickness of the interfacial transition zone (ITZ) between the aggregate and the cement paste is modified when mineral admixtures partially replace portland cement. Unfortunately, there is limited information on the significance of these microscopic modifications to the mechanical properties of the ITZ. This research reports experimental results on the shear and tensile strength of the ITZ as affected by the addition of the following mineral admixtures: silica fume, fly ash, and natural pozzolan. Statistical analysis was used to identify the significant parameters affecting the tensile and shear strength of the ITZ. Experimental results indicate that not only does the incorporation of silica fume and fly ash increase the strength of the ITZ, these mineral admixtures have a greater influence on the strength increase of the ITZ than in the strength increase of the cement paste.     

Cems characterization of SnO2 films obtained by sputtering and sol-gel route

Conversion electron Mössbauer spectroscopy (CEMS) has been used to study tin oxide films prepared by sol-gel dipping and sputtering. The spectra of films prepared by sol-gel route result close to that of crystalline SnO₂ after heat treatment at a temperature as low as 150°C. The Mössbauer parameters of as sputter deposited films indicate that the structure of the deposited stannic oxide has an amorphous character more pronounced for thinner samples. The structure becomes predominantly that of crystalline SnO₂ by heating at 550°C for 30 min provided the film thickness is higher than 10 nm.     

Non-local approximation of the Mumford-Shah functional

The Mumford-Shah functional, introduced to study image segmentation problems, is approximated in the sense of -convergence by a sequence of non-local integral functionals. Received June 6, 1996 / Accepted July 11, 1996     

Specific MARY spectrum from radical anion of pentafluorobenzene

The paper presents the first resolved experimental magnetically affected reaction yield (MARY) spectrum for a system with nonequivalent nuclei, radical anion of pentafluorobenzene. This observation dispels the common apprehension that because of a rather involved energy level layout a system with not all nuclei magnetically equivalent cannot produce resolved MARY lines in nonzero fields, and greatly, increases the practical scope of level-crossing techniques for studies of spin-correlated radical pairs. The experimental finding is supported by schemes of energy levels calculated for this system.     

DRIFTS study of surface reactivity to NO2 by zinc nanoparticle aggregates and zinc hollow nanofibers

Zinc nanostructures synthesized with different morphologies from the same evaporation/condensation technique are studied with concern to surface reactivity to NO₂ by Diffuse Reflectance Infrared Fourier Transformed Spectroscopy (DRIFTS). Synthesis of nanopowders is obtained, according to previous work, by gas flow thermal evaporation at 540 °C of bulk Zn grains. Two types of Zn powders are obtained and studied in experiments. The first one is collected on the cold walls of the reactor as a deposit produced by thermophoretic effect. It is constituted by grains (∼10 μm) originated by the stratification of smaller aggregates (∼200 nm) and isolated primary particles (∼50 nm) born in the gas flow. The second type of powder is grown from the condensation of Zn chemical vapors within the expansion orifice of the quartz reactor after relatively long time (∼1 h) deposition process. It is constituted mainly by hollow Zn nanofibers with external and internal diameter about 100 and 60 nm. Preliminary characterization of the two types of powders is made by SEM, TEM, XRD. Thereafter, the two types of samples are studied by DRIFTS at variable temperature (VT). Comparison is made between the home-synthesized nanopowders with respect to commercial Zn standard dust. The Zn hollow nanofibers when exposed to NO₂ are found to exhibit dramatic reactivity, which is not observed at all either in the case of clustered aggregate zinc or of commercial Zn dust powders. Results indicate that, at increasing temperature from RT to 300 °C, the hollow nanofibers surface reacts distinctively with adsorbant gas NO₂, with contemporary formation of a progressively growing narrow absorption band at 2500 cm⁻¹ and contemporary depression of a doublet (∼1600-1628 cm⁻¹) band. In order to justify this striking spectral feature, we propose the occurring of a possible polymerization process at nanofibers surface where most probably as a consequence of pre-treatment and exposure to gas NO₂ a very thin film of ZnO is formed. The possible role of huge specific surface of hollow nanofibers as inferred by preliminary SEM, TEM, XRD studies is discussed.