Miscibility of bisphenol-A polycarbonate with poly(methyl methacrylate)

The miscibility of bisphenol-A polycarbonate (PC) with poly(methyl methacrylate) (PMMA) has been reexamined using differential scanning calorimetry (DSC) and optical indications for phase separation on heating, i.e., lower critical solution temperature (LCST) behavior. Various methods have been used to prepare the blends including methylene chloride (CH₂Cl₂) and tetrahydrofuran (THF) solution casting, melt mixing, and precipitation of PC and PMMA simultaneously from THF solution by using the nonsolvents methanol and heptane. It is shown that the resulting phase behavior for PC/PMMA blends is strongly affected by the blend preparation method. However, these blends are miscible over the whole blend composition range (unambiguous single composition-dependent T_g's and LCST behavior) when prepared by precipitation from solution using heptane as the nonsolvent. To the contrary, solution-cast and melt-mixed PC/PMMA blends were all phase separated, which may be attributed to the “solvent” effect and LCST behavior, respectively, not discovered in previous reports. Methanol precipitation does not lead to fully mixed blends, which demonstrates the importance of the choice of nonsolvent when using the precipitation method.     

Symmetric Markov chains in ℤd: How fast can they move?

Summary Consider a reversible Markov chain X _n which takes values in a subset of ^d. If the steps of the chain are uniformly bounded and the invariant measure satisfies a mild regularity condition, Varopoulos, Carne and Kesten have obtained estimates on \lambda n^{1/2} )$$ " align="middle" border="0"> which exhibit a Gaussian tail in but blow up as n. Following Kesten's approach we derive bounds which are uniform in n in some special cases. Our main result, however, is an example which shows that in general the estimates of Varopoulos, Carne and Kesten are essentially best possible.Research partially supported by an S.E.R.C. (U.K.) visiting fellowship and an operating grant from N.S.E.R.C. of Canada     

Strong, low-energy two-photon absorption in extended amine-terminated cyano-substituted phenylenevinylene oligomers

Three quadrupolar oligophenylenevinylenes with five rings in the conjugated backbone, terminal donor groups, and various acceptors and/or donors along the backbone were synthesized and their two-photon spectroscopic properties investigated. These chromophores exhibit large two-photon absorption cross sections over a wide wavelength range and two distinct peaks, the strongest of which (deltamax > 3600 GM) is observed at 960-970 nm, a wavelength close to twice the value of the linear absorption maximum (2lambda(1)max). The findings on these chromophores are compared with those for analogous molecules with shorter conjugation length, for which the main two-photon band is at significantly shorter wavelength than 2lambda(1)max.     

Preparation of polymer colloids by chemical reactions in aerosols. I. Poly(p-tertiarybutylstyrene)

A procedure was developed by which polymer colloids can be prepared by polymerizing aerosol droplets of monomers with an initiator in the vapor state. This work describes the formation of poly(p-tertiarybutylstyrene) particles by exposing the corresponding monomer droplets to trifluoromethanesulfonic acid. It was found that the monomer-to-initiator mass ratio is the critical factor in determining the uniformity and morphology of the particles. Under ideal conditions spheres of narrow size distribution are obtained. Otherwise porous particles or soft particles with whiskers may develop. The aerosol was prepared in a falling film generator, but other procedures for producing monomer droplets may be used.