The origin of electrochemical activity in Li2MnO3

The electrochemical activity of Li2MnO3 in non-aqueous media has been investigated and found to involve neither Mn(4+)-Mn5+ oxidation nor simultaneous O2- removal but exchange of Li+ by H+, the latter being generated in the electrolyte.     

On-line LC-GC-AED and LC-GC-MS – multidimensional methods for the analysis of PAC in fuels,combustion emissions and atmospheric samples

The composition and concentration of polycyclic aromatic compounds (PAC) in fuels. Theier combustion products and in the atmosphere remains a topic of considerable interest. Despite the wealth of literature on the identification of PAC, speciation at low concentrations remains difficult due to instrument limitation and the complexity of fuel and environmental samples. Consequently on line sample preparation procedures (SPE, SFE, LC, etc.) are becomeing an increasingly important step in the analysis procedure particularly where sample clean-up and fractionation are essential for improving analytical resolution. In this study a normal phase high pressure analytical resolution. In this study a normal phase high pressure liquid chromatography-gas chromatography (LC-GC) system has been developed to provide quantitative analysis of samples, as diverse as coal liquids, petroleum fuels, diesel exhaust particulates, and urban air particulates. Separation and identification of parent and alkylated PAH, hetercycline nitro-and oxy-PAC can be achieved by direct coupling to an atomic emission detector and a bech top mass spectrometer. For both systems the primary LC separation combined with the large sample volume transferred to GC vastly improves detection limits. Furthermore the complimentary nature of the two detectors used enables the positive indentification of many unknowns.     

Second-order nonlinear optical properties of side-chain liquid crystalline polymers studied by second harmonic generation from thin films

The two independent elements of the second-order nonlinear optical susceptibility tensor of a range of contact poled, donor–acceptor substitued side-chain polymers are reported. The susceptibilities were measured by second harmonic generation from thin films, typically less than 0.5 μm thick, at a fundamental wavelength of 1064 nm. The largest value was χ = 2.64 pm/V which is three times greater than the χ value of KDP and was measured in a nitrobenzylidene side chain, polyhydroxystyrene polymer with an eleven unit alkyl chain spacer attaching the side group to the backbone. Typical susceptibility values obtained were χ～0.3 pm/V and X⁽²⁾₃₃～1 pm/V. The coherence lengths of the materials, which lay in the range 4–12 μm, were measured at 1064 nm by the maker fringe technique using thick, wedge-shaped samples.     

New routes to beta-cycloalkylalanine derivatives using serine-derived organozinc reagents

Two distinct routes to beta-cycloalkylalanine derivatives have been developed. The first route employs the reaction of the iodoalanine-derived zinc-copper reagent 2 with cycloalk-1-en-3-yl phosphates, and the second uses the palladium-catalysed coupling of the iodoalanine-derived zinc reagent 1 with cycloalkenyl triflates; in each case, catalytic hydrogenation of the unsaturated product leads to the protected beta-cycloalkylalanine. The latter route allows access to a range of cycloalkyl derivatives, with ring sizes of 5-8. beta-(1-Methyl-1-cyclohexyl)alanine may be prepared using reaction of the zinc-copper reagent 2 with 3-methyl-2-cyclohexenyl chloride, followed by hydrogenation. The corresponding cyclopentyl derivative may be prepared by reaction of the same zinc-copper reagent 2 with diethyl geranylphosphate, followed by ring-closing metathesis and hydrogenation.     

Application of comprehensive multidimensional gas chromatography combined with time-of-flight mass spectrometry (GC x GC-TOFMS) for high resolution analysis of hop essential oil

The selection and quality of hops is a major determinant in beer flavour. Brewers acknowledge that distinctive characteristics of different hop varieties can be traced to the composition of their essential oils. The difficulty in characterising complex mixtures such as hop oil using 1-D chromatography is that many compounds co-elute. With the introduction of comprehensive multidimensional capillary gas chromatography (GC x GC), there is a tremendous improvement in the separation power or peak capacity. Recent work using GC x GC with flame ionisation detection has suggested that there may be over 1,000 compounds in hop oil. This work describes the use of GC x GC combined with TOFMS detection (Leco Pegasus 4D instrument) to analyse Target hop oil. The TOFMS spectral acquisition rate of 60 Hz provided sufficient spectra per peak (2-D peak base width of 0.1-0.2 s) for identification (119 components were identified with 45 previously unreported compounds). When analysing results, an advantage of GC x GC coupled to TOFMS is that 2-D chromatograms can be viewed for individual masses that are characteristic of particular functional groups. This allows the analyst to view the various homologous series of compounds although in certain cases coelution may still be present as shown by the esters with mass 75.     

Viscoelastic properties of single poly(ethylene glycol) molecules.

The viscoelastic properties of single poly(ethylene glycol) (PEG) molecules were measured by analysis of thermally and magnetically driven oscillations of an atomic force microscope (AFM) cantilever/molecule system. The molecular and monomer stiffness and friction of the PEG polymer were derived using a simple harmonic oscillator (SHO) model. Excellent agreement between the values of these two parameters obtained by the two approaches indicates the validity of the SHO model under the experimental regimes and the excellent reproducibility of the techniques. A sharp minimum in the monomeric friction is seen at around 180 pN applied force which we propose is due to a force induced change in the shape of the energy landscape describing the conformational transition of PEG from a helical to a planar state, which in turn affects the timescale of the transition and therefore modifies the measured internal friction. A knowledge of the viscoelastic response of PEG monomers is particularly important since PEG is widely used as a linker molecule for tethering groups of interest to the AFM tip in force spectroscopy experiments, and we show here that care must be exercised because of the force-dependent viscoelastic properties of these linkers.     

Electrochemical Vicinal Difluorination of Alkenes: Scalable and Amenable to Electron-Rich Substrates

Fluorinated alkyl groups are important motifs in bioactive compounds, positively influencing pharmacokinetics, potency and conformation. The oxidative difluorination of alkenes represents an important strategy for their preparation, yet current methods are limited in their alkene-types and tolerance of electron-rich, readily oxidized functionalities, as well as in their safety and scalability. Herein, we report a method for the difluorination of a number of unactivated alkene-types that is tolerant of electron-rich functionality, giving products that are otherwise unattainable. Key to success is the electrochemical generation of a hypervalent iodine mediator using an “ex-cell” approach, which avoids oxidative substrate decomposition. The more sustainable conditions give good to excellent yields in up to decagram scales.     

Transmetalation in the Suzuki–Miyaura Coupling: The Fork in the Trail

The Suzuki–Miyaura coupling is one of the few transition‐metal‐catalyzed C? C bond‐forming reactions that have been used in applications ranging from discovery chemistry to manufacturing processes. Although coupling proceeds through the generic three‐stage ‘oxidative addition, transmetalation, reductive elimination’ sequence, there are a number of features that differentiate the Suzuki–Miyaura process from other transition‐metal‐catalyzed cross‐couplings. Most of these features are centered around, or are a consequence of, activation of the boron reagent for transmetalation through one or both of two distinct pathways. This review focuses on the evidence that has been presented for this ‘fork in the trail′, and the potential to apply such mechanistic insight to the design of reaction conditions.