全密度功能性复杂金属零件的激光直接快速制造

 针对具有复杂结构的全密度功能性金属零件快速制造难题,探讨了该类零件的选区激光熔化直接快速制造方法,并结合实验,重点对同步保证选区激光熔化快速制造金属零件成型密度及精度的工艺进行了研究。结果表明：同步消除球化、飞溅及气孔对成型件致密性及精度的影响是实现选区激光熔化快速制造全密度功能性复杂金属零件的难点及关键;在维持良好的抗氧化气氛条件下,可采用尽可能薄的铺粉厚度及恰当调节其它成型参数的方法,以保证对上一层有足够的重熔量来消除球化及气孔现象;同时,采用合适的扫描策略,可弱化飞溅对成型质量的影响来解决工艺难题。采用该工艺方案可快速制造全密度功能性复杂金属零件,所成型的316L不锈钢叶轮零件相对密度为99.8%,硬度为HB192,表面粗糙度约为40 μm,尺寸精度在±0.1 mm以内,稍经打磨后即可投入使用。     

316L不锈钢粉末光纤激光选区熔化特性

采用自行研制的光纤激光选区熔化快速成型设备,研究了选区激光熔化316L不锈钢粉末工艺参数、能量输入与样件致密度、表面形貌之间的关系以及微观组织特征。结果表明:扫描速度对成型效果影响最为显著;样件致密度随着激光能量密度提高有逐渐增大的趋势;能量密度作为选区激光熔化工艺的技术指标具有可操作性;表面形貌由激光功率与扫描速度比值所决定。深入探讨了能量输入、熔化凝固行为、激光功率与扫描速度比值与样件致密度、表面形貌的关系。结果表明:选区激光熔化凝固组织层内、层间熔合处为弧形,且为冶金结合,金相组织主要由柱状晶与等轴晶组成,层内靠近熔合线周围是柱状晶,而层间靠近熔合线附近主要是细小等轴晶,晶粒直径为1μm左右。     

Direct manufacturing of Cu-based alloy parts by selective laser melting

The frequent defects of the metal parts, such as non-fully melting, thermal strain, and balling, which are produced by selective laser melting (SLM) that is a novel method of one-step manufacturing, are analyzed theoretically and experimentally. The processing parameters significantly affect the quality of the final parts, and simultaneously, the appropriate laser mode and the special scanning strategy assure a satisfying quality of the final parts. The SLM experiment is carried out using Cu-based powder. The metal part is divided into several scanned regions, each of which is scanned twice at the cross direction with different scanning speeds. The microstructure is analyzed on microscope. The results show that the part is metallurgically bonded entity with a relative density of 95%, and the microstructure is composed of equiaxial crystal and dendritic crystal whose distributions are mainly decided by the scanning strategy.