Non-destructive rapid analysis of brominated flame retardants in electrical and electronic equipment using Raman spectroscopy.

Using Raman spectroscopy without any preparation, we analyzed the brominated flame retardant, polybromodiphenyl ethers (PBDEs), which has been prohibited by the European Union. The typical Raman bands of PBDEs, which are clearly different from those of other brominated flame retardants, are from 100 to 300 cm(-1). In our analysis, the detection limit was about 100 ppm, and the analysis took about 1 min, whereas the usual method of solvent extraction using gas chromatography/mass spectroscopy takes 50 h.     

Psychological evaluation of sound environment in a compartment of a high-speed train

Sound environment in a compartment of high-speed trains (Shinkansen) was examined in relation to speech communication and annoyance. Three experiments were conducted. In Experiment 1, the annoyance caused by the compartment noise was judged. In Experiment 2, both the compartment noise and the conversation were presented together and the annoyance of the combined sounds was judged. In Experiment 3, both sounds were presented and only the disturbance of conversation was judged. The results showed that: The annoyance of compartment noise showed good correlation with L_Aeq. The annoyance of the combination of the compartment noise (N) and the conversation (C) increased as C/N decreased. There was, however, a tendency that annoyance increased as C/N increased in some conditions. This suggests that there exists an optimum level of compartment noise at 50-60 dBA taking the level of conversation into consideration. The disturbance of the conversation increased as C/N increased. However, when the level of conversation became high, it was judged as being disturbing regardless of the level of compartment noise.     

Evaluation of fine structure of tubular zeolite NaA membrane by FTIR-ATR and FIB-TEM.

A zeolite NaA (LTA) membrane supported by an alumina porous support tube for pervaporation (PV) dehydration of ethanol was characterized by transmission electron microscopy (TEM) using a focused ion beam (FIB) thin-layer specimen preparation technique and by Fourier transform infrared attenuated total reflectance method (FTIR-ATR) using a diamond prism as the waveguide. FIB-TEM clearly presented cross-section images up to about 15 microm depth from the membrane surface. FTIR-ATR monitored the Si-O asymmetric stretching vibration spectrum. The Si-O spectrum was compared with the TEM image and their relationships were discussed. By combining the two methods, we could study the thickness of surface LTA crystals, the grain boundary, the LTA/alumina interface structure and the crystallinity and density of materials inside of the alumina porous support. Consequently, fine structure changes of the LTA membrane corresponding to the hydrothermal synthesis condition could be sensitively detected.     

Synthesis, stereochemistry, and circular dichroism of optically active o-substituted diphenyl sulphilimines and related compounds

Optically active o-substituted diphenyl N-substituted sulphilimines are readily synthesised by the reaction of the corresponding sulphides and t-butyl hypochlorite in the presence of l-menthol and amide anions. (−)-N-p-Tolylsulphonylsulphilimines (1, 2) obtained were converted to the corresponding (−)-N-unsubstituted sulphilimines (8, 9) by treating them with concentrated sulphuric acid. When (−)-S-o-anisyl S-phenyl N-(unsubstituted) sulphilimine (8) was treated with acylating agents or acrylonitrile, the corresponding optically active (−)-N-substituted sulphilimines were prepared with complete retention at sulphur. The absolute configuration of (−)-S-o-anisyl S-phenyl N-p-tolylsulphonylsulphilimine (1) was determined by converting it to (+)-S-o-anisyl sulphoxide (17). CD curves of (−)-o-substituted diarylsulphilimines exhibited a negative Cotton effect at around 270–285 nm, which was assigned to (S)-configuration at sulphur by comparing with the analogous sulphoxides. The substituent on the imino group of the sulphilimine gave no appreciable effect on the CD behavior and the lack of substituent effect was considered to be due to the semi-polar character of the S(IV)-N bond. Unusual effect of o-methoxy group on the CD curves was discussed in connection with solvent effect. Mechanism of this asymmetric synthesis has been investigated, and it has become apparent that the diastereomeric menthoxysulphonium chloride was an excess of (RR)-configuration was formed initially and the amide anion attacks the S atom of the salt with net inversion.     

Polyiodide composition in poly(vinyl acetate)-iodine-iodide complex

Polyiodide formed by complexation of poly(vinyl acetate) (PVAc) with iodine in the presence of iodide has been investigated by chemical analysis and resonance Raman spectrophotometry. When PVAc films were immersed in iodide-iodine aqueous solutions which had different ratios of iodide to iodine concentration [I^?]/[I₂], the complex films exhibited tremendous variations of swelling degree, despite the relatively small change in the amount of bound iodine. From a quantitative chemical analysis, the composition of polyiodide bound to PVAc was found to be 1.01 ± 0.035 in the molar ratio of iodide to iodine irrespective of the composition of the iodide-iodine aqueous solution ([I^?]/[I₂] = 2–500). The polyiodide formed in PVAc-iodine-iodide complex was therefore inferred to be (I₃^?)_n. Resonance Raman spectra obtained on PVAc-iodine-iodide complexes were also identical to those of the benzamide-iodine complex, in which the polyiodide consists of (I₃^?)_n, consistent with the result from chemical analysis.     

Protective effects of small amounts of bis(2-ethylhexyl)sulfosuccinate on the helical structures of human and bovine serum albumins in their thermal denaturations

The protective effect of an anionic double-tailed surfactant, sodium bis(2-ethylhexyl)sulfosuccinate (AOT), on the structures of human serum albumin (HSA) and bovine serum albumin (BSA) in their thermal denaturations was examined by means of circular dichroism measurements. The structural changes of these albumins were reversible in the thermal denaturation below 50 degrees C, but became partially irreversible above this temperature. The effect was observed in the thermal denaturation above 50 degrees C. Although the helicity of HSA decreased from 66% to 44% at 65 degrees C in the absence of the surfactant, the decrement of it was restrained in the coexistence of AOT of extremely low concentrations. When the HSA concentration was 10 muM, the maximal protective effect appeared at 0.15 mM AOT. In the coexistence of the surfactant of this concentration, the helicity was maintained at 58% at 65 degrees C, increasing to the original value upon cooling to 25 degrees C. Beyond 0.15 mM AOT, the helicity sharply decreased until 3 mM AOT. A particular AOT concentration required to induce the maximal protective effect ([AOT]REQ) was examined at different HSA concentrations. [AOT]REQ shifted to higher values with an increase of the protein concentration. From the protein concentration dependences of [AOT]REQ, the maximal protection was estimated to require 8.0 and 5.0 AOT ions per a molecule of HSA and BSA, respectively. The AOT concentration, where the protective effect was observed, was too low to form its micelle-like aggregate. Then the protein structures might be stabilized by a cross-linking of surfactant monomers bound to specific sites. These specific sites might exist between a group of nonpolar residues and a positively charged residue located on several sets of amphiphilic helical rods in the proteins. Such a unique function of the double-tailed ionic surfactant is first presented by its characteristic nature as an amphiphilic material.     

Homoleptic cyclometalated iridium complexes with highly efficient red phosphorescence and application to organic light-emitting diode

Phosphorescence studies of a series of facial homoleptic cyclometalated iridium(III) complexes have been carried out. The complexes studied have the general structure Ir(III)(C-N)(3), where (C-N) is a monoanionic cyclometalating ligand: 2-(5-methylthiophen-2-yl)pyridinato, 2-(thiophen-2-yl)-5-trifluoromethylpyridinato, 2,5-di(thiophen-2-yl)pyridinato, 2,5-di(5-methylthiophen-2-yl)pyridinato, 2-(benzo[b]thiophen-2-yl)pyridinato, 2-(9,9-dimethyl-9H-fluoren-2-yl)pyridinato, 1-phenylisoquinolinato, 1-(thiophen-2-yl)isoquinolinato, or 1-(9,9-dimethyl-9H-fluoren-2-yl)isoquinolinato. Luminescence properties of all the complexes at 298 K in toluene are as follows: quantum yields of phosphorescence Phi(p) = 0.08-0.29, emission peaks lambda(max) = 558-652 nm, and emission lifetimes tau = 0.74-4.7 micros. Bathochromic shifts of the Ir(thpy)(3) family [the complexes with 2-(thiophen-2-yl)pyridine derivatives] are observed by introducing appropriate substituents, e.g., methyl, trifluoromethyl, or thiophen-2-yl. However, Phi(p) of the red emissive complexes (lambda(max) > 600 nm) becomes small, caused by a significant decrease of the radiative rate constant, k(r). In contrast, the complexes with the 1-arylisoquinoline ligands are found to have marked red shifts of lambda(max) and very high Phi(p) (0.19-0.26). These complexes are found to possess dominantly (3)MLCT (metal-to-ligand charge transfer) excited states and have k(r) values approximately 1 order of magnitude larger than those of the Ir(thpy)(3) family. An organic light-emitting diode (OLED) device that uses Ir(1-phenylisoquinolinato)(3) as a phosphorescent dopant produces very high efficiency (external quantum efficiency eta(ex) = 10.3% and power efficiency 8.0 lm/W at 100 cd/m(2)) and pure-red emission with 1931 CIE (Commission Internationale de L'Eclairage) chromaticity coordinates (x = 0.68, y = 0.32).     

Preparation and Crystal Structures of 4-(4′-Pyridylthio)-1-methylpyridinium Salts: Assembly of a Donor-Acceptor-Type Molecule Containing a Sulfide Bridge

A series of ionic 4-(4′-pyridylthio)-1-methylpyridinium salts with different counteranions (1, I⁻; 2, BF⁻₄; 3, PF⁻₆; and 4, OTf⁻, where OTf=trifluoromethanesulfonate) have been prepared. Structural analysis reveals that the cation exhibits a variety of stacking structures dependent on the anion. Compound 1 crystallizes in space group P2_1/n (#14), with a=10.764(3) Å, b=9.601(5) Å, c=13.105(3) Å, β=108.35(2), V=1285.4(8) ų, and Z=4. In this compound, each cation moiety is stacked in a helical arrangement along the c-axis. Compound 2, which is isomorphous to 1, has space group P2_1/n (#14), with a=11.647(2) Å, b=9.203(3) Å, c=13.232(2) Å, β=108.42(2), V=1345.6(5) ų, and Z=4. Compound 3 crystallizes in space group P2_1/n (#14), with a=8.06(1) Å, b=17.43(1) Å, c=10.30(1) Å, β=103.0(1), V=1410(3) ų, and Z=4. In this salt, the cation molecules assume a head-to-tail stacking arrangement, forming a polar pseudo 1-D chain. Compound 4 crystallizes in space group Pb? (#2), with a=7.585(4) Å, b=15.443(7) Å, c=6.775(4) Å, α=99.33(4), β=108.35(2)^o, γ=98.37(4), V=756.6(7) ų, and Z=2. The structure of 4 consists of a columnar stacking of pyridine moieties, with the cation moieties surrounded by the counteranions. Calculations show that the 4-(4′-pyridylthio)-1-methylpyridinium cation may be a good building block for second harmonic generation (SHG) materials, even though salts 1-4 crystallized in centrosymmetric structures and were SHG inactive.     

Adsorption of fission products on a metal surface in nitric acid solutions: Radiochemical study using a multitracer

Adsorption behavior of fission products in nitric acid solution on various alloys and metals was studied by using a multitracer produced by neutron irradiation of UO₂. The adsorption behavior of the fission products ⁹⁹Mo, ¹³¹I, ¹³²Te, ¹⁴⁰La, and ¹⁴³Ce, and ²³⁹Np was simultaneously studied. Some chemical decontamination tests were also examined. Clear adsorption of ⁹⁹Mo, ¹³¹I, and ¹³²Te was observed, whereas adsorption of ¹⁴⁰La, ¹⁴³Ce, and ²³⁹Np was not. The adsorption characteristics were discussed by considering anion-exchange reaction and surface complexation.