Sulfonated poly(aryl ether ketone)s containing naphthalene moieties obtained by direct copolymerization as novel polymers for proton exchange membranes

A series of sulfonated poly(aryl ether ketone)s (SPAEKs) were prepared by aromatic nucleophilic polycondensation of 2,6‐dihydroxynaphthalene with 5,5′‐carbonyl‐bis(2‐fluorobenzenesulfonate) and 4,4′‐difluorobenzophenone. The structure and degree of sulfonation (DS) of the SPAEKs were characterized using ¹H NMR spectroscopy. The experimentally observed DS values were close to the expected values derived from the starting material ratios. The thermal stabilities of the SPAEKs were characterized by thermogravimetric analysis, which showed that in acid and sodium salt forms they were thermally stable in air up to about 240 and 380 °C, respectively. Transparent membranes cast from the directly polymerized SPAEKs exhibited good mechanical properties in both dry and hydrated states. The dependence of water uptake and of membrane swelling on the DS at different temperatures was studied. SPAEK membranes with a DS from 0.72 to 1.60 maintained adequate mechanical properties after immersion in water at 80 °C for 24 h. The proton conductivity of SPAEK membranes with different degrees of sulfonation was measured as a function of temperature. The proton conductivity of the SPAEK films increased with increased DS, and the highest room temperature conductivity (4.2 × 10^?2 S/cm) was recorded for a SPAEK membrane with a DS of 1.60, which further increased to 1.1 × 10^?1 S/cm at 80 °C. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 2866–2876, 2004     

Classification of Extremal Double Circulant Self-Dual Codes of Lengths 64 to 72

Recently extremal double circulant self-dual codes have been classified for lengths n ≤ 62. In this paper, a complete classification of extremal double circulant self-dual codes of lengths 64 to 72 is presented. Almost all of the extremal double circulant singly-even codes given have weight enumerators for which extremal codes were not previously known to exist.     

Mode beating in spot-size converter lasers

An anomalous modulation in the wavelength spectrum has been observed in lasers with spot-size converters. This intensity modulation is shown to be caused by beating between the fundamental lasing mode and radiation modes in the taper. This results in a periodic modulation in the net gain spectrum, which causes wavelength jumps between adjacent net gain maxima, and a drive current dependent spectral width that is expected to affect system performance. The amplitude of this spectral modulation is reduced significantly by either using an angled rear-facet which reflects the beating radiation modes away from the laser axis, or by using a nonlinear, adiabatic taper.     

Aryl pyrrolidinones via radical 1,4-aryl migration and 5-endo-trig cyclisation of N-(2-bromoallyl)arylcarboxamides

Radical reaction of a series of N-(2-bromoallyl)arylcarboxamides led to the production of 4-arylpyrrolidin-2-ones and directly reduced materials in comparable yields. A cascade process, involving sequential 5-exo-trig spirocyclisation, β-scission, and 5-endo-trig cyclisation of the resulting acyl radical, is proposed to explain the pyrrolidinone products.     

Improvements to air mass calculations for ground-based infrared measurements

High-resolution ground-based infrared solar spectra are routinely recorded at the Network for the Detection of Stratospheric Change (NDSC) stations. These data sets play a key role in providing a long-term record of atmospheric composition and their links to climate change. The analysis of observed infrared spectra involves comparison to a computer-modeled atmosphere where knowledge of the air mass distribution is an essential component. This note summarises improvements made to an existing and widely used computer code (FSCATM) to perform refractive ray-tracing and calculation of the air mass distribution. Changes were made towards higher vertical resolution in the troposphere and increased numerical precision. The revised FSCATM improves the analysis of infrared spectra mostly through the more accurate representation of the temperature profile. Air mass differences with respect to earlier versions are documented and are typically <0.7%, exceptions being extreme cases of inversion layers. The current version provides ray tracing and air mass calculations for any terrestrial observation site. The output files are reported in a format compatible with the SFIT and SFIT2 retrieval algorithms, which are widely used for NDSC infrared atmospheric studies. The improved computer code, documentation, reference profiles, and test cases are available electronically.     

A search for fractional electric charge in sea water

The magnetic levitation technique has been used to test for fractional electric charge in sea water, using steel balls coated with sea water residue by evaporation. The objective was to reach concentration levels below 1 g^?1 which might result from cosmic ray interactions. Four stages of increasing sensitivity are reported: (1) residue from direct evaporation of unprocessed sea water, (2) residue from sea water samples enriched by ion exchangen, (3) residue reduced by high temperature evaporation, and (4) hypothetical enrichment by dilution and separation of soluble residue. Stages 1–3 are based on the generally accepted preferential retention of fractional charge during evaporation, but stage 4 limits are subject to uncertainties in the enrichment process. No evidence for fractional charge was found in a total of about 130 samples tested in these four stages. Samples containing positive and negative ions were tested separately, and concentration limits are reported for each of the stages. Levels in the region 0.01–0.1g^?1 were reached in stage 3, and 0.001 g^?1 in stage 4.     

Full-Wave Analyses for a Multi-Layered Microstrip Patch Antenna

This paper describes numerical modelling of a dual band multi-layered microstrip patch antenna operating at 35GHz on an in-house semi-insulating GaAs substrate. The simulated and measured resonant frequencies at both lower and upper resonant frequencies will be compared to check the accuracy of the different numerical modelling techniques.