神光Ⅱ上柱形黑腔辐射驱动冲击波

利用神光Ⅱ的八路三倍频激光装置，驱动柱形黑腔产生的x 射线作辐射源驱动台阶铝样品产生冲击波，获得了清晰的冲击波图像，通过冲击波过台阶样 品的时间差获得冲击波速度和压力分别为31.2km/s和17.5×10⁵MPa.采用软x射线能谱 仪通过激光注入孔测量的辐射温度与采用冲击波法测量辐射温度的结果一致. 关键词： 冲击波 辐射驱动 辐射温度     

Expert systems for HPLC in biochemistry—The knowledge base for selection of HPLC column system in the separation of amino acids,peptides and proteins

The strategy of expert system for high performance liquid chromatography was discussed, the attentions are mainly placed on the knowledge base for selection of column system, separation modes and detection modes in the analysis of amino acids, peptides and proteins.     

A Facile Synthesis of Ethyl 2,4-Dimethoxy-6-perfluoroalkyl-benzoates via Acyclic Precursors

Introduction Polysubstituted arenes are important intermediates in synthetic medicines and dyestuffs, and the fluorinated analogues are more attractive as a result of their lipo-philicity and the increment of activity.1,2 Therefore, to study the convenient and efficient synthesis of polysub-stituted arenes is valuable in organic synthetic method-ology. We have designed a simple synthesis of fluori-nated polysubstituted arenes through the intramolecular Wittig reaction of a new phosphorous ylid…     

Phosphonium and arsonium ylides. XVII. A facile synthesis of methyl 2,6-bisperfluoroalkylbenzoates via acyclic precursors

The title compounds 6a—6f were prepared with high yield via intramolecular Wittig reaction of methyl 3-perfluoroalkyl-6-peifluoroacyl-2-triphenylphosphoranylidenchex-3,5-dienoates (5a—5i) which were obtained from the reaction of 3-perfluoroacylprop-2-enylidenetriphenylphosphoranes (3a—3c) with methyl perfluoroalkynoates (4a—4c).     

The physicochemical properties of aqueous mixtures of cationic-anionic surfactants: I. The effect of chain length symmetry

The solution behaviors of equimolar mixtures of cationic-anionic surfactants have been studied by means of the dynamic light scattering technique and surface tension measurements. The surface activity and the micellization properties are different for systems of different hydrophobic chain length symmetry. For systems of lower symmetry (e.g., C₆H₁₃NC₅H₅Br-C₁₂H₂₅SO₄Na mixture), the surface tension at cmc (γ_cmc) is rather high (above 30 mN m⁻¹) and the mixtures form genuinely homogeneous micellar solutions above the cmc. For the systems of high symmetry (e.g., C₈H₁₇NC₅H₅Br-C₈H₁₇SO₄Na mixture), γ_cmc is very low (about 24 mN m⁻¹, near the value of pure hydrocarbon) and in the apparently homogeneous and clear mixtures slightly above cmc, the aggregates grow slowly and eventually form small droplets; as the concentration is further increased, all these solutions become turbid. We have proposed a new concept of conformation energy of aggregates to account for all these phenomena. Mixtures of octyltriethylammonium bromide and sodium octylsulfate form clear homogeneous micellar solutions in keeping with predictions based upon this concept.     

Preparation and Characterization of a Sol-Gel Prepared Ferroelectric Sandwich Structure

A novel silicon-based PbTiO₃/Pb(Zr,Ti)O₃/PbTiO₃ (PT/PZT/PT) sandwich structure has been prepared using a sol-gel method. The annealing temperature is greatly reduced compared with those structures without PT layers. Capacitance-voltage (C-V), leakage current-voltage (I-V), polarization-field (P-E), dielectric-frequency response and polarization fatigue of the sandwich structure are examined. The relative dielectric constant, the coercive field and the remanent polarization of the PZT films are measured to be about 900, 18 kV/cm and 16 C/cm² respectively. The current density is less than 5 × 10^–9 A/cm² below 200 kV/cm. The dielectric constant of the structure remains constant at low frequency, and decreases to some degree at high frequency. The retained polarization does not change significantly after 8 × 10⁹ read/write cycles. The PZT films are proved to have very good dielectric and ferroelectric properties. The new PT/PZT/PT sandwich structure can be valuable for memory devices and other applications.     

铽-聚二甲基硅氧烷配合物的荧光特性

用多种谱学方法证明聚二甲基硅氧烷(PDMS)中的氧原子能与Tb3+键合生成Tb3+和PDMS的配合物(Tb3+-PDMS), 并发现生成配合物后, PDMS和Tb3+的荧光发射同时得到增强. 荧光强度的增强与配合物中Tb3+含量有关, 当配合物中Tb3+的含量为2.0%(w)时, 配合物的荧光强度最大, 可增强1547%左右.     

新型反相微乳液制备纳米结构甲烷催化燃烧催化剂La0.95Ba0.05MnAl11O19-α的研究

提出一种由水, 异丙醇, 正丁醇组成的新型微乳液, 并以其为反应介质制备了甲烷高温燃烧La_0.95Ba_0.05MnAl₁₁O_19-a催化剂. 采用¹H NMR, FT-IR, 电导法及激光粒度散射法研究了新型微乳液中水的结构及相特性. 新型微乳液中水的体积分数小于一定值时, 电导率与水含量成非线性关系, k～φ曲线上存在一临界值(φ^P＝0.15). 水质子的化学位移随水含量的降低移向高场. 加入4% D₂O测定的O—D键的伸缩振动随水含量增加而向高波数方向移动. 异丙醇铝在新型微乳液中水解形成的Al(OH)₃ 胶体粒子的粒径范围为226～329 nm. 采用新型微乳液作为反应介质制备的Ba_0.05La_0.95MnAl₁₁O_19-α催化剂的粒径在30 nm, 明显小于纯水制备的样品(100 nm). BET 比表面积为65 m²/g, 比纯水制备样品高出约一倍. XRD结果显示, 1200 ℃焙烧10 h即可获得含单一β-Al₂O₃相的催化剂. Ba_0.05La_0.95MnAl₁₁O_19-α催化剂甲烷催化燃烧的T₁₀为420 ℃, 比纯水制备样品下降了90 ℃. 甲烷催化燃烧活性提高是由于含有较多Mnⁿ+纳米结构六铝酸盐的形成.     

Ni的掺入对复合氧化物LaFeO3的结构及性质的影响

合成子Ｎｉ替代铁酸稀土复合氧化物ＬａＦ３１－ｘＮｉｘＯ３（ｘ＝０．１－０．６），对样品进行了ＸＲＤ、ＩＲ及Ｍｏｓｓｂａｕｅｒ谱测试，结果表明：ｘ＝０＼１，０＼２，０＼３的样品为正交相，ｘ＝０．５，０．６的样品为菱方相；伴随相结构从正交向菱方结构的转变，ＩＲ谱上Ｆｅ（Ｎｉ）－Ｏ键伸振动谱带向高频移动近２０ｃｍ＾－１，Ｍｏｓｓｂａｕｅｒ谱测试表明Ｆｅ均处于＋３自旋态，Ｎｉ离子以＋３价进入晶格。     

Highly Enantioselective Phenylacetylene Addition to Benzaldehyde Catalyzed by Chiral Tridentate Ligand

Development of new or improved methods for the asymmetric preparation of chiral propargylic alcohols has gained considerable significance during the past years because they are useful building blocks for the synthesis of many biologically active compounds and natural products.[1] A series of chiral tridentate ligands were conveniently synthesized from amino acids with good yields (Scheme 1).[2] A preliminary study of the enantioselective alkynylation of benzaldehyde catalyzed by this chiral tridentate ligand was carried out and up to 83% ee of chiral propargyl alcohols was obtained (Table 1 ). A further investigation of the tridentate ligand is currently underway.