Temperature dependence of the exafs spectrum in YBa2Cu3O7−δ compounds

The temperature dependence of the extended X-ray absorption fine structure (EXAFS) is studied in the high T_c superconductors, YBa₂Cu₃O_7−δ. The measurements were done at the Cu K-edge for samples of two orthorhombic phases (T_c≈90 K and ≈58 K, respectively) and a nonsuperconducting tetragonal phase. Interatomic distances and mean square relative displacements σ² for Cu-O bonds are determined by the least squares refinement. The results indicate that values of σ² increase near T_c for both the orthorhombic samples. It is concluded that this anomalous behavior related to T_c is caused by an anomalous vibration of oxygen atoms in the Ba-O layer. Changes in the Cu-O distances from 300 to 20 K are not found.     

Application of novel SIMS technique for imaging the active sites of oxygen reduction at the SOFC cathode/electrolyte interfaces

The oxygen reduction active sites were visualized around the O₂/SOFC cathode/electrolyte triple phase boundaries (TPB) by the¹⁶O/¹⁸O exchange techniques and secondary ion mass spectrometry (SIMS) analysis. The higher¹⁸O concentration is observed on the cathode top surfaces (La_0.9Sr_0.1MnO₃-mesh, Au-mesh, and Ag-porous), which suggested the promotion of oxygen adsorption and oxygen surface exchange at the cathode. The oxygen diffusion through the bulk of cathode occurred at the La_0.9Sr_0.1MnO₃-mesh and the Ag-porous cathodes, not at the Au-mesh cathode. On the YSZ surfaces after removing the cathode, the active sites for oxygen incorporation were analyzed by SIMS. The active sites for oxygen incorporation were at the La_0.9Sr_0.1MnO₃/YSZ interface as well as the TPB. On the other hand, the active sites for oxygen incorporation are limited to the TPB in the case of the Au-mesh removed YSZ surface. From the SIMS analysis, the expansion of the active sites for oxygen incorporation is less than a few μm from the TPB lines. Paper presented at the 8th EuroConference on Ionics, Carvoeiro, Algarve, Portugal, Sept. 16–22, 2001.     

Design of a widely tunable laser with a chirped ladder filter

We theoretically investigated a digitally tunable laser with a chirped ladder filter and a ring resonator to obtain a wide wavelength tuning range covering the whole C- or L- band. The clear relation between the tuning range and laser structure, especially the ladder filter, is described analytically. The introduction of a chirped structure into a ladder filter is effective in achieving both wide tunability and a stable lasing mode. A numerical simulation based on multimode rate equations shows that a tuning range of over 40 nm and a mode suppression ratio over 40 dB can be achieved by introducing a chirped ladder filter.     

Stein's idea and minimax admissible estimation of a multivariate normal mean

We consider estimation of a multivariate normal mean vector under sum of squared error loss.We propose a new class of minimax admissible estimator which are generalized Bayes with respect to a prior distribution which is a mixture of a point prior at the origin and a continuous hierarchical type prior. We also study conditions under which these generalized Bayes minimax estimators improve on the James–Stein estimator and on the positive-part James–Stein estimator.     

17O NMR chemical shifts versus structure relationships in oxiranes

Natural-abundance ¹⁷O NMR spectra have been measured for twenty one oxiranes. Their chemical shifts covering a 100 ppm range were interpreted in terms of the paramagnetic β- and diamagnetic γ-effects. In addition, through-space orbital interaction between the ethylenic π and the Walsh orbitals of the oxirane ring was suggested by a lowfield shift in norbornadiene $\text{exo}$-oxide.     

Interaction between peroxide ion and phenol group which are coordinated to the same iron(III) ion

We have prepared several new iron(III) complexes with ligands which contain a phenol group; these are tetradentate [(X-phpy)H, X and H(phpy) represent the substituents on the phenol ring and N,N-bis(2-pyridylmethyl)-N-(2-hydroxybenzyl)amine, respectively] and pentadentate ligands [(R-enph-X)H; R=ethyl(Et) or methyl(Me) derivative and H(Me-enph) denotes N,N-bis(2-pyridylmethyl)-N″-methyl-N″-(2″-hydroxyl-benzylamine)ethylenediamine] and have determined the crystal structures of Fe(phpy)Cl₂, Fe(5-NO₂-phpy)Cl₂, and Fe(Me-enph)ClPF₆, which are of a mononuclear six-coordinate iron(III) complex with coordination of one or two chloride ion(s). These compounds are highly colored (dark violet) due to the coordination of phenol group to an iron(III) atom. When hydrogen peroxide was added to the solution of the iron(III) complex, a color change occurs with bleaching of the violet color, indicating that oxidative degradation of the phenol moiety occurred in the ligand system. The bleaching of the violet color was also observed by the addition of t-butylhydroperoxide. The rate of the disappearance of the violet color is highly dependent on the substituent on the phenol ring; introduction of an electron-withdrawing group in the phenol ring decreases the rate of bleaching, suggesting that disappearance of the violet band should be due to a chemical reaction between the phenol group and a peroxide adduct of the iron(III) species with an η¹-coordination mode and that in this reaction the peroxide adduct acts as an electrophile towards phenol ring. The intramolecular interaction between the phenol moiety and an iron(III)-peroxide adduct may induce activation of the peroxide ion, and this was supported by several facts that the solution containing an iron(III) complex and hydrogen peroxide exhibits high activities for degradation of nucleosides and albumin.     

Radiation-induced solid-state polymerization of trioxane under high pressure

The in-source polymerization of trioxane in the solid state was investigated over a wide range of temperature and pressure, i.e., from 30 to 140°C and up to 7000 kg/cm², respectively. In the polymerization that was carried out slightly below the melting point under pressure, the higher the pressure, the higher the rate of polymerization. It was confirmed that the maximum rate of solid-state polymerization of trioxane occurs near the melting points, even under elevated pressure. The rate of polymerization decreased with increasing pressure at constant temperature. The shape of the time–conversion curves may be classified into two types, i.e., one which is typical of high pressure and low temperature, and the other which is typical of low pressure and high temperature. Changes in the shape of the conversion—intrinsic viscosity curves occurred coincidentally. Thus, three regions for the different “polymerization characteristic” were determined as functions of polymerization temperature and pressure. Explanations are given for the above-mentioned polymerization characteristic.     

Crystal structures of V3S4 and V5S8

Crystal structures of the ordered phases of V₃S₄ and V₅S₈ were refined with single crystal data. Both are monoclinic. Chemical compositions, space groups and lattice constants are as follows: VS_1.47, $\text{I2}\text{m}$ (No. 12), a = 5.831(1), b = 3.267(1), c = 11.317(2)Å, β = 91.78(1)° and VS_1.64, $\text{F}\text{2}\text{m}$ (No. 12), a = 11.396(11), b = 6.645(7), c = 11.293(4), Å, β = 91.45(6)°. In both structures, short metal-metal bonds were found between the layers as well as within them. In comparison with the structure of Fe₇S₈, the stability of NiAs-type structure was discussed based on the detailed metal-sulfur distances.