Manifestation of biquadratic coupling in the smectic C* phase soft mode dielectric response

The soft mode dielectric response of three ferroelectric chiral smectic C* substances is studied in the vicinity of the smectic C*-smectic A* phase transition. For some substances the soft mode dielectric strength exhibits a pronounced anomaly in the C* phase just below the phase transition. We show how this anomaly can be systematically correlated with a corresponding anomaly in the experimentally determined ratio of spontaneous polarization over tilt. By comparing the experimental results with the theoretical predictions of an extended Landau model, we demonstrate how the crossover behaviour of the system can be interpreted as being the consequence of the presence of a biquadratic coupling between tilt and polarization in the Landau free-energy of the system.     

Hydrothermal Synthesis of Mo-Based Oxide Catalysts and Selective Oxidation of Alkanes

Mo-V-M(=Al, Ga, Bi, Sb and Te)–O mixed oxide catalysts were synthesized hydrothermally for the first time, characterized structurally, and tested for ethane and propane oxidation after activation by various ways. These catalysts were black solids of rod-shaped (fiber like) crystals, which had a layer structure in the direction of fiber axis and a high dimensional arrangement of metal octahedra in the cross-section plane. These fresh crystalline materials became active for catalytic oxidation of alkanes after heat-treatment at 600 °C and subsequent grinding in order to increase exposed plane of the cross-section. The resulting catalysts were very active for an oxidative dehydrogenation of ethane with 80% of the ethylene selectivity in the reaction temperature range of 300 to 400 °C and also showed about 50% selectivity to acrylic acid in the propane oxidation. Multi-functional character which derived from the high dimensional structure of the catalysts and mechanism of the selective alkane oxidation were discussed.     

Effect of surface covering of lactose carrier particles on dry powder inhalation properties of salbutamol sulfate

The effect of the surface covering of lactose carrier particles on the dry powder inhalation properties of salbutamol sulfate was investigated. Lactose carrier surfaces were covered with sucrose tristearate (J-1803F) by a high-speed elliptical-rotor-type powder mixer (Theta-Composer). In the present study, drug/carrier powder mixtures were prepared consisting of micronized salbutamol sulfate and lactose carriers with various particle surface conditions prepared by surface covering. These powder mixtures were aerosolized by a Jethaler), and the in vitro inhalation properties of salbutamol sulfate were evaluated by a twin impinger. Compared with the powder mixed with uncovered lactose carrier, the in vitro inhalation properties of the powder mixture prepared using the surface covering lactose carrier were significantly different, showing that the in vitro inhalation properties of salbutamol sulfate were improved. In vitro inhalation properties increased with the percentage of J-1803F added. Using this surface covering system would thus be valuable for increasing the inhalation properties of dry powder inhalation with lactose carrier particles.     

Influence of storage humidity on the in vitro inhalation properties of salbutamol sulfate dry powder with surface covered lactose carrier

The influence of storage humidity on the in vitro inhalation properties of salbutamol sulfate dry powder with surface covered lactose carrier was investigated. In the present study, drug/carrier powder mixtures were prepared consisting of micronized salbutamol sulfate and lactose carriers with different particle surface conditions prepared by surface covering. Lactose carrier surfaces were covered with vegetable magnesium stearate (Mg-St-V) by a high-speed elliptical-rotor-type powder mixer (Theta-Composer). These powder mixtures were aerosolized by a Jethaler), and the in vitro inhalation properties of salbutamol sulfate were evaluated by a twin impinger. Compared with the powder mixed with uncovered lactose carrier, the in vitro inhalation properties of the powder mixture prepared using the surface covered lactose carrier were little decreased with increased in relative humidity (RH), showing that the in vitro inhalation properties of salbutamol sulfate were improved at high RH. Using this surface covering technique would thus be valuable for storage humidity of dry powder inhalation (DPI) with lactose carrier particles.     

A hybrid density-functional study of the one-dimensional ferromagnetic ordering of (BDTA)[Ni(mnt)2]

The one-dimensional intermolecular ferromagnetic interaction of a charge-transfer (CT) complex, (BDTA)[Ni(mnt)₂] (BDTA: 1,3,2-benzodithiazolyl, mnt: maleonitriledithiolate), is studied by the Kohn–Sham hybrid density functional method, in order to understand the mechanism of the magnetism. All possible effective exchange integrals, J, between the spin pairs of the system indicate that a ferromagnetic interaction (J = 172 cm⁻¹) exists along the b-axis. Magnetic susceptibility, simulated with the ab initio determined J values by the quantum Monte Carlo (QMC) method, is qualitatively consistent with that measured experimentally.     

Small angle X-ray scattering from lamellar phase for β-3,7-dimethyloctylglucoside/water system: comparison with β-n-alkylglucosides

Small angle X-ray scattering (SAXS) is measured for the lamellar phase in aqueous systems of 1-o-β-3,7-dimethyoctyl-D-glucopyranoside (β-Glc(Ger)), which has recently been prepared by us, 1-o-β-decyl-D-glucopyranoside (β-GlcC₁₀), and 1-o-β-octyl-D-glucopyranoside (β-GlcC₈). The repeat distance d obtained from the position of the diffraction peak does not follow the swelling law d = 2δ_hc/_hc, where δ_hc and _hc are the thickness and the volume fraction of the hydrophobic layer, respectively. This may result from the fact that δ_hc increases and, equivalently, the surface area per surfactant molecule (a_s) decreases with increasing concentration. So we calculate δ_hc and a_s from the observed d value at each concentration using the above swelling law. The half-thickness δ_hc increases in the order β-GlcC₈ < β-Glc(Ger) < β-GlcC₁₀ at a fixed concentration. On the other hand, the data on a_s for β-GlcC₁₀ and β-GlcC₈ lie on the same line and the data for β-Glc(Ger) lies above this line. These results suggest that the cross-sectional area of the geranyl chain is larger than that of the glucose headgroup. Existence of water filled defects in bilayer sheets is also discussed based on the SAXS pattern and the concentration dependence of d.     

Ultrasound-Assisted Dispersive Microsolid-Phase Extraction for Preconcentration of Trace Cobalt and Nickel in Environmental Samples Prior to their Determination by Flame Atomic Absorption Spectrometry

Journal of Applied Spectroscopy - A new, green, simple, and validated ultrasound-assisted dispersive microsolid-phase extraction method applying unprecedented adsorbent-modified multiwalled carbon...     

Solid-phase extraction using multiwalled carbon nanotubes and quinalizarin for preconcentration and determination of trace amounts of some heavy metals in food,water and environmental samples

A solid phase extraction procedure has been developed using multiwalled carbon nanotubes (MWCNTs) as a solid sorbent and quinalizarin [1,2,5,8-tetrahydroxyanthracene-9,10-dione] as a chelating agent for separation and preconcentration of trace amounts of some heavy metal ions, Cd(II), Cu(II), Ni(II), Pb(II) and Zn(II) before their determination by flame atomic absorption spectroscopy (FAAS). The influences of the analytical parameters, including pH, amounts of quinalizarin and adsorbent, sample volume, elution conditions such as volume and concentration of eluent, flow rates of solution and matrix ions, were investigated for the optimum recoveries of the analyte ions. No interference effects were observed from the foreign metal ions. The preconcentration factor was 100. The detection limit (LOD) for the investigated metals at the optimal conditions were observed in the range of 0.30–0.65 μg L^?1. The relative standard deviation (RSDs), and the recoveries of standard addition for this method were lower than 5.0% and 96–102%, respectively. The new procedure was successfully applied to the determination of analytes in food, water and environmental samples with satisfactory results.     

7,7,8,8‐Tetraaryl‐o‐quinodimethane Stabilized by Dibenzo Annulation: A Helical π‐Electron System That Exhibits Electrochromic and Unique Chiroptical Properties

When two benzene rings are fused to a tetraaryl‐o‐quinodimethane skeleton, sterically hindered helical molecules 1 acquire a high thermodynamic stability. Because the tetraarylbutadiene subunit contains electron‐donating alkoxy groups, 1 undergo reversible two‐electron oxidation to 2 ²⁺, which can be isolated as deeply colored stable salts. Intramolecular transfer of the point chirality (e.g., sec‐butyl) on the aryl groups to helicity induces a diastereomeric preference in dications 2 b ²⁺ and 2 c ²⁺, which represents an efficient method for enhancing circular‐dichroism signals. Thus, those redox pairs can serve as new electrochiroptical response systems. X‐ray analysis of dication 2 ²⁺ revealed π–π stacking interaction of the diarylmethylium moieties, which is also present in solution. The stacking geometry is the key contributor to the chirosolvatochromic response.