烷氧基取代聚对苯乙炔三阶非线性光学性能

通过双醚化反应、氯甲基化反应以及在强碱性条件下进行的脱氯化氢反应制备聚（2-甲氧基-5-丁氧基）对苯乙炔（PMOBOPV）、聚（2-甲氧基-5-己氧基）对苯乙炔（PMOHOPV）、聚（2,5-二丁氧基）对苯乙炔（PDBOPV）和聚（2,5-二己氧基）对苯乙炔（PDHOPV）等四种可溶性聚对苯乙炔（PPV）衍生物，通过紫外-可见吸收光谱对产物分子结构进行表征.结果显示，PMOBOPV、PMOHOPV、PDBOPV和PDHOPV的共轭π电子发生π → π* 跃迁的吸收峰分别位于491 nm、495nm、504nm和510nm处，相应的光学禁带宽度分别为2.23eV、2.18eV、2.12eV和2.07eV.利用简并四波混频技术测量PPV衍生物的三阶非线性光学性能，探讨了分子结构对PPV衍生物三阶非线性极化率（χ(3)）的影响.研究发现，激发波长为532 nm时，PMOBOPV、PMOHOPV、PDBOPV和PDHOPV的共振χ(3)值分别为3.45×10－10、5.13×10－10、7.15×10－10和9.61×10－10 esu；激发波长为1064 nm时，它们的非共振χ(3)值分别为1.09×10－11、1.42×10－11、1.62×10－11和2.14×10－11 esu.     

类锂硅离子软X射线激光研究

在激光等离子体典型参数条件下，利用碰撞－辐模型计算了类锂硅离子５ｆ－３ｄ和４ｆ－３ｄ跃的粒子数反转比率和激光增益系数。讨论了不同热带条件和不同冷却速度下，激光增益系统数的变化。计算结果表明，高功率，短脉冲激光生产的高温等离子体在快速冷却条件下能产生软Ｘ射的线激光增益。     

Sr1-xLaxTiO3的高温高压合成及XPS研究

 利用高温高压方法合成了有稀土元素La掺杂的钙钛矿氧化物Sr_1-xLa_xTiO₃。XRD测试表明，在x≤0.5时，样品基本为单相，呈立方相；晶胞体积随x的增加而增加，在x=0.4时开始减小。XPS测量发现，样品中存在Ti离子的变价。讨论了Ti离子价态的变化对晶格参数的影响。     

介绍一种改进内压力盐效应公式的计算方法

式中k_s为盐析常数,c_s为盐的浓度,分别为非电解质和盐在无限稀释溶液中的偏摩尔体积,V_s为盐在液体状态下的摩尔体积,β_o为水的压缩系数,p_e为盐溶于水而产生的有效压力。此式推导过程中所用的极限条件为V_n→0,因此(1)式仅能用在极小的非电解质分子上,对于苯及苯的衍生物讲,K_s计算值约为实验值的2～3倍。当非电解质体积较大时,Mc-     

三磷酸胞苷在Duolite A-30树脂上的交换过程研究

根据CTP在离子交换树脂上的吸附容量和分离因数的大小,确定Duolite A-30树脂适合CTP与CDP,CMP之间的分离.对CTP在Duolite A-30树脂上的吸附动力学和热力学研究表明,在283.15K~303.15K之间,CTP的质量浓度在7.5g/L以上时,Duolite A-30树脂对CTP的吸附主要受颗粒扩散的控制,其有效扩散系数为D=3.47×10-7cm2/s,溶液的质量浓度≤1.0g/L时,CTP与Duolite A-30树脂之间的交换速率主要受液膜控制,其液膜扩散系数为Kf =4.112×10-4/s.同时测定了不同条件下三磷酸胞苷溶液在Duolite A-30树脂固定床离子交换柱中的穿透曲线,研究了进口浓度、进口流速、原料液温度、原料液的pH值及柱高对穿透曲线的影响.用二阶动力学推动力模型描述固定床动态过程,考察了轴向返混对穿透曲线的影响,并从穿透曲线回归得到总传质系数,模型计算值与实验数据符合良好.     

3‐Deoxy‐β‐d‐ribo‐hexopyranose (3‐deoxy‐β‐d‐glucopyranose)

The β‐pyranose form, (III), of 3‐deoxy‐d ‐ribo‐hexose (3‐deoxy‐d ‐glucose), C₆H₁₂O₅, crystallizes from water at 298 K in a slightly distorted ⁴C₁ chair conformation. Structural analyses of (III), β‐d ‐glucopyranose, (IV), and 2‐deoxy‐β‐d ‐arabino‐hexopyranose (2‐deoxy‐β‐d ‐glucopyranose), (V), show significantly different C—O bond torsions involving the anomeric carbon, with the H—C—O—H torsion angle approaching an eclipsed conformation in (III) (−10.9°) compared with 32.8 and 32.5° in (IV) and (V), respectively. Ring carbon deoxygenation significantly affects the endo‐ and exocyclic C—C and C—O bond lengths throughout the pyranose ring, with longer bonds generally observed in the monodeoxygenated species (III) and (V) compared with (IV). These structural changes are attributed to differences in exocyclic C—O bond conformations and/or hydrogen‐bonding patterns superimposed on the direct (intrinsic) effect of monodeoxygenation. The exocyclic hydroxymethyl conformation in (III) (gt) differs from that observed in (IV) and (V) (gg).     

相分离聚合法:(Ⅰ)羧酸型共聚功能微球的合成

粒径在微米级、粒度分布窄的高分子微球具有十分广泛的应用。但是由于这样规格的微球正是在一般的悬浮聚合和乳液聚合的合成范围之外,而采用二步聚合法和种子聚合法则不是需要使用特殊的反应装置,就是合成步聚十分繁复,因此至今对于这样规格高分子微球的报道不多。     

Solid-state synthesis and properties of SmCoO3

In this paper, perovskite oxide SmCoO₃ was prepared by the solid-state reaction method using Co₂O₃ and Sm₂O₃ as raw materials. The structure and properties of the samples were investigated by XRD, Raman spectral techniques, and DC measurements and so on. The results of XRD and Raman spectra showed that the mixtures of Co₂O₃ and Sm₂O₃ can react to produce a single phase perovskite oxide SmCoO₃ around 1353 K. The single-phase SmCoO₃ changes from an insulator to a semi-conductor and transition occurs around 470 K. The thermal expansion coefficient (2.17 × 10⁻⁵ K⁻¹) of the single-phase SmCoO₃ is approximately equal to that of doped LaGaO₃, but much bigger than that of SDC(Ce_0.85Sm_0.15O₂) above 873 K.     

CeO2-ZrO2固相溶液的制备和贮氧能力的研究

二氧化铈(CeO2)是优良的催化剂和催化剂促进剂,通过引入二氧化锆(ZrO2)可以提高其热稳定性及贮氧能力.研究以硝酸铈(Ⅳ)和氯氧锆为原料,用均相沉淀法制备CeO2-ZrO2固相溶液.用X光衍射(XRD)、差热-热重分析(DSC-TGA)、BET测定法和贮氧能力测定法对制备的CeO2-ZrO2进行了表征.BET测定制备的样品比表面积可达114m2/g;XRD结果表明,均相沉淀法制备样品具有萤石结构,Ce/Zr为3∶1,450℃时即可制备出Ce0.75Zr0.25O2,800℃时,相结构稳定,TGA-DSC热分析没有出现热峰,说明样品热稳定性优良;通过100℃、200℃、400℃和800℃的氧贮存能力测定,实验结果表明,CeO2-ZrO2固体溶液的氧贮存能力随温度的升高而降低,在高温下的氧贮存能力随Zr含量的增加而增大,ZrO2的引入不但改进了CeO2的热稳定性,而且提高Ceo2样品高温下的氧贮存能力.     

Single electron emission from the closed-tips of single-walled carbon nanotubes

The single electron emission behaviors and characteristics from the well-defined quantized energy levels, corresponding to localized electronic states at the dome-structure tips, in single-walled carbon nanotubes (SWNTs) are investigated and illuminated by use of the energy level emission model in combination with the first-principles calculations on the electronic structures. Under the external electric field, the confined electrons are emitted simultaneously from each quantized energy level by virtue of the resonant tunneling effects. With increasing applied voltage, the emission current increases monotonically and exponentially up to the first peak value, and then steps into the increasing and decreasing "sawtoothlike" variations in sequence. The negative differential resistance or conductivity and the maximum current for SWNTs are simulated. The influences of localized electronic states and curvatures of the different closed tips on the single electron emission behaviors of SWNTs are evaluated and discussed. Also a few issues and applications relevant to electron emission of carbon nanotubes are addressed.