Nitrostyrene Derivatives of Adenosine 5′-Glutarates Modified with an Alkyl Spacer and their inhibitory activity on epidermal growth factor receptor protein tyrosine kinase

β-Nitrostyrene derivatives of adenosine 5′-glutarates are potent and selective bisubstrate-type inhibitors of the epidermal growth factor receptor protein tyrosine kinase (EGF-R PTK). In an attempt to improve the inhibitory activity, this type of compounds was modified with alkyl spacers of varying length between the nitrostyrene and the glutaryl units. The spacers consisted of 1, 3, 4, and 5 atoms to give compounds of the benzyl, oxyethyl, oxypropyl, and oxybutyl series, respectively (Schemes 1 and 2). Adenosine 5′-esters were prepared in the benzyl and oxypropyl series only. Compared to the compounds in the parent series without spacer (IC₅₀ = 0.7–12 μM ), most of the modified compounds inhibited the EGF-R PTK only marginally or were inactive (IC₅₀ ≥ 100 μM ). The only exceptions were the free acids 19 and 20 with IC₅₀ values of ca. 5 μM . It is noteworthy that esterification of these two hydrogen glutarates with either MeOH or adenosine yielded inactive compounds, which is in contrast to the corresponding substances without spacers.     

Ground-state properties of LiV2O4 and Li1-xZnx(V1-yTiy)2O4

We present susceptibility, microwave resistivity, NMR and heat-capacity results for Li_1-xZn_x(V_1-yTi_y)₂O₄ with 0 ? x ? 0.3 and 0 ? y ? 0.3. For all doping levels the susceptibility curves can be fitted with a Curie-Weiss law. The paramagnetic Curie-Weiss temperatures remain negative with an average value close to that of the pure compound Θ≈ - 36 K. Spin-glass anomalies are observed in the susceptibility, heat-capacity and NMR measurements for both type of dopants. From the temperature dependence of the spin-lattice relaxation rate we found critical-dynamic behavior in the Zn doped compounds at the freezing temperatures. For the Ti-doped samples two successive freezing transitions into disordered low-temperature states can be detected. The temperature dependence of the heat capacity for Zn-doped compounds does not resemble that of canonical spin glasses and only a small fraction of the total vanadium entropy is frozen at the spin-glass transitions. For pure LiV₂O₄ the spin-glass transition is completely suppressed. The temperature dependence of the heat capacity for LiV₂O₄ can be described using a nuclear Schottky contribution and the non-Fermi liquid model, appropriate for a system close to a spin-glass quantum critical point. Finally an ( x / y , T )-phase diagram for the low-doping regime is presented. Received 16 March 2001 and Received in final form 30 October 2001     

Synthesis and characterization of alt‐bipyridinylene‐phenylene copolymers containing ruthenium(II) complexes

Poly{bis(4,4′‐tert‐butyl‐2,2′‐bipyridine)–(2,2′‐bipyridine‐5,5′‐diyl‐[1,4‐phenylene])–ruthenium(II)bishexafluorophosphate} ( 3a ), poly{bis(4,4′‐tert‐butyl‐2,2′‐bipyridine)–(2,2′‐bipyridine‐4,4′‐diyl‐[1,4‐phenylene])–ruthenium(II)bishexafluorophosphate} ( 3b ), and poly{bis(2,2′‐bipyridine)–(2,2′‐bipyridine‐5,5′‐diyl‐[1,4‐phenylene])–ruthenium(II)bishexafluorophosphate} ( 3c ) were synthesized by the Suzuki coupling reaction. The alternating structure of the copolymers was confirmed by ¹H and ¹³C NMR and elemental analysis. The polymers showed, by ultraviolet–visible, the π–π* absorption of the polymer backbone (320–380 nm) and at a lower energy attributed to the d–π* metal‐to‐ligand charge‐transfer absorption (450 nm for linear 3a and 480 nm for angular 3b ). The polymers were characterized by a monomodal molecular weight distribution. The degree of polymerization was approximately 8 for polymer 3b and 28 for polymer 3d . © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 2911–2919, 2004     

Controlling the water content of never dried and reswollen bacterial cellulose by the addition of water-soluble polymers to the culture medium

For the modification of medically useful biomaterials from bacterially synthesized cellulose, fleeces of Acetobacter xylinum have been produced in the presence of 0.5, 1.0, and 2.0% (m/v) carboxymethylcellulose (CMC), methylcellulose (MC), and poly(vinyl alcohol) (PVA), respectively, in the Hestrin-Schramm culture medium. The incorporation of the water-soluble polymers into cellulose and their influence on the structure, crystal modifications, and material properties are described. With IR and solid-state ¹³C NMR spectroscopy of the fleeces, the presence of the cellulose ethers and an increase in the amorphous parts of the cellulose modifications (NMR results) have been detected. The incorporation is represented by a higher product yield, too. As demonstrated by scanning electron microscopy, a porelike cellulose network structure forms in the presence of CMC and MC. This modified structure increases the water retention ability (expressed as the water content), the ion absorption capacity, and the remaining nitrogen-containing residues from the culture medium or bacteria cells. The water content of bacterial cellulose (BC) in the never dried state and the freeze-dried, reswollen state can be controlled by the CMC concentration in the culture solution. The freeze-dried, reswollen BC-CMC (2.0%) contains 96% water after centrifugation, whereas standard BC has only 73%. About 98% water is included in a BC-MC composite in the wet state, and about 93% is included in the reswollen state synthesized in the presence of 0.5, 1.0, or 2.0% MC. These biomaterial composites can be stored in the dried state and reswollen before use, reaching a higher water absorption than pure, never dried BC. The copper ion capacity of BC-CMC composites increases proportionally with the added amount of CMC. BC-CMC (0.5%) can absorb 3 times more copper ions than original BC. In the case of 0.5 and 1.0% PVA additions to the culture solution, this polymer cannot be detected in the cellulose fleeces after they are washed. Nevertheless the presence of PVA in the culture medium effects a decreased product yield, a retention of nitrogen-containing residues in the material during purification, a reduced water absorption ability, and a slightly higher copper ion capacity in comparison with original BC. The water content of freeze-dried, reswollen BC-PVA (0.5%) is only 62%. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 463–470, 2004     

Design and synthesis of Ru(II-bipyridyl-containing conjugated polymers

A series of novel π-conjugated polymers containing ruthenium bipyridine complexes was synthesized by a cross-coupling reaction and characterized. These polymers exhibit absorption maxima around 330–350 nm (π-π*) and 460–500 nm metal-to-ligand charge transfer (MLCT), respectively. They are soluble in common organic solvents, and all polymers can be converted into transparent films. We investigated the influence of different donating and acceptor diethynylarenes of the ultraviolet-visible spectra. The oxidation potential, which was measured by cyclic- and square-wave voltametry, showed a typical Ru^2+/3+ exhibited at 1.25 V versus the saturated calomel electrode. The polymers were further characterized with photoluminescence measurements. When excited at 442 nm ( 11a ), the polymer exhibited an emission peak at 690 nm. This peak was attributed to the MLCT states. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 722–732, 2004     

Fluctuation conductivity in superconducting MgB2

According to the crystal structure of MgB₂ and band structure calculations, quasi-two-dimensional (2D) boron planes are responsible for the superconductivity. We report on critical-field and resistance measurements of 5.6-μm-thick MgB₂ films grown on a sapphire single-crystal substrate. Resistivity measurements yield a temperature dependence of the fluctuation conductivity above the critical temperature, which agrees with the Aslamazov-Larkin and Maki-Thompson theory of fluctuations in layered superconductors, indicating a quasi-two-dimensional nucleation of superconductivity in MgB₂.     

Literatur

Ohne Zusammenfassung     

Catalytic desulfurization of condensed thiophenes by means of methanol

Desulfurization of dibenzothiophene, two methyldibenzothiophenes, and phenanthro[4,5-bcd]-thiophene to give 60-80% yields of hydrocarbon products was effected by means of a sulfided molydena catalyst plus methanol at 450° and a pressure of ca. one atmosphere. The methanol functions both as an in situ hydrogen donor and as a methylating agent.