Combined supercritical-fluid chromatography/mass spectrometry in the analysis of diuron in plasma using on-line phase-system switching

On-line sample pretreatment by means of the phase-system switching approach is an interesting technique for the analysis of aqueous samples, e.g., plasma, by means of supercritical-fluid chromatography. In order to analyse plasma samples the following analytical procedure is used. The plasma sample is injected on to a short precolumn, which is washed with water and subsequently dried with nitrogen. Next, the solutes are desorbed with the supercritical mobile phase, analysed with packed-column supercritical-fluid chromatography and detected with either a UV detector or a mass spectrometer, equipped with a moving-belt interface. The herbicide diuron is selected as a test compound to study the feasibility of this approach. Using a selective detector the procedure is sufficiently sensitive to detect diuron in plasma, but not appropriate to detect the diuron metabolites in a post-mortem plasma sample. These have been identified with liquid chromatography/mass spectrometry. The detection limit of diuron in plasma using the procedure described is about 30 ng/mL.     

Chip-based capillary electrophoresis with an electrodeless nanospray interface

A sheathless and electrodeless nanospray interface has been used to interface a polycarbonate capillary electrophoresis (CE) chip to a mass spectrometer (MS). The chip was made of two flat polycarbonate plates which were bolted together. Channels were imprinted in one of the plates with metal wires, using a hydraulic press. A short tapered capillary connected to the chip was used as the nanospray emitter. The advantage of this electrodeless interface is that it was not necessary to apply a electrospray voltage to the chip or the nanospray emitter. Instead, the CE voltage already applied to the buffer compartment on the chip, to drive the electrophoresis, was used to generate the spray also. A low conductivity buffer of 1.25 mmol/L ammonium acetate in 80% methanol was used to obtain a large electric field across the buffer channel. The performance of the device was evaluated by analyzing a mixture of three beta-agonists Relative standard deviation (RSD) values obtained were between 4.8 and 5.0%. A sample concentration of 40 nmol/L resulted in a signal-to-noise ratio of 2 to 5 for the different components. Compared to a conventional CE analysis in a fused silica capillary with UV detection, only a minor loss of resolution was observed, which can be attributed to the design of the chip.     

Capillary isoelectric focusing-mass spectrometry for shotgun approach in proteomics

We report on capillary isoelectric focusing-mass spectrometry (CIEF-MS) of complex peptide mixtures in the absence of carrier ampholytes. Furthermore, the use of low concentrations of carrier ampholytes as mere spacers is investigated. Carrier ampholytes are complex mixtures of amphoteric compounds with high buffering capacity. Since all peptides are amphoteric compounds by themselves, the use of carrier ampholytes may be superfluous to establish a stable pH gradient in CIEF analysis of protein digests. Our research showed that when carrier ampholytes are omitted, the analyte ions are not focused at their isoelectric point. The analytes are charged, leading to electrophoretic mobility uncharacteristic for CIEF. The method was tested for a five-protein-mixture at 0.02 mg/mL per protein and 0.05 mg/mL per protein. At the lower concentration, the analytes were stacked during the focusing process in only a limited length of the capillary. Therefore, the higher concentration led to better separation efficiency. It was found that at low concentration (0.20%) the carrier ampholytes could work as spacers. Though it led to sensitivity losses of 15-45%, this was compensated by the higher separation efficiencies seen. The method was evaluated with an eight-protein-mixture, of which all could be identified after performing MS/MS.     

Determination of mitomycin C in plasma, serum and urine by high-performance liquid chromatography with ultra-violet and electrochemical detection

The performance of a number of normal phase and reversed-phase systems, with ultraviolet detection at 360 nm, has been investigated with respect to their applicability to pharmacokinetic studies of mitomycin C (MMC). The reversed-phase system developed was also combined with a polarographic detector in order to compare the sensitivity and selectivity of ultraviolet and electrochemical detection. A simple isolation procedure, based on the adsorption of MMC on a non-ionogenic resin, has been developed. The developed assay is applied to a pharmacokinetic study from which some examples are given.     

Bioanalysis of (E)-5-(2-bromovinyl)-2'-deoxyuridine

(E)-5-(2-Bromovinyl)-2'-deoxyuridine is an antiviral drug that is experimentally used for modulation of the antitumour effect of fluoropyrimidines, such as ftorafur and 5-fluorouracil. The isolation of the analyte, in the presence of 5-fluorouracil, from the matrix is performed either by means of a simple protein precipitation (plasma) or by means of a liquid-liquid extraction with ethyl acetate (urine). Following pretreatment, the analyte is analysed by reversed-phase chromatography and quantified by absorbance detection at 307 nm. The minimum detectable concentration in plasma and urine samples is ca. 6 ng/ml. The recovery after deproteination of plasma samples is 75%, while after liquid-liquid extraction of urine the recovery amounts 92%. The degree of protein binding of the analyte, measured by ultrafiltration, is found to be 97%. These data allow the bioanalysis of (E)-5-(2-bromovinyl)-2'-deoxyuridine for pharmacokinetic studies.     

High-performance liquid chromatography with on-line coupled UV, mass spectrometric and biochemical detection for identification of acetylcholinesterase inhibitors from natural products

A high-performance liquid chromatography (HPLC) method with on-line coupled ultraviolet (UV), mass spectrometry (MS) and biochemical detection for acetylcholinesterase (AChE) inhibitory activity has been developed. By combining the separation power of HPLC, the high selectivity of biochemical detection, and the ability to provide molecular mass and structural information of MS, AChE inhibitors can be rapidly identified. The biochemical detection was based on a colorimetric method using Ellman's reagent. The detection limit of galanthamine, an AChE inhibitor, in the HPLC-biochemical detection is 0.3 nmol. The three detector lines used, i.e., UV, MS and Vis for the biochemical detection were recorded simultaneously and the delay times of the peaks obtained were found to be consistent. This on-line post-column detection technique can be used for the identification of AChE inhibitors in plant extracts and other complex mixtures such as combinatorial libraries.     

On-target fraction collection for the off-line coupling of capillary isoelectric focusing with matrix-assisted laser desorption/ionization mass spectrometry.

In the present work, we describe a collection system for the off-line coupling of capillary isoelectric focusing (CIEF) with matrix-assisted laser desorption/ionization time-of-flight (MALDI-TOF) mass spectrometry. In this system, the capillary effluent is directly deposited in fractions onto the MALDI target via the use of a sheath liquid. The collected fractions are subsequently supplemented with matrix and further analysed by MALDI-TOF mass spectrometry for mass assignment. The experimental set-up includes a fiber optic based UV detector operating at 280 nm, which allows the study of the influence of the sheath liquid composition on the CIEF separation. The influence of the carrier ampholyte concentration on the protein MALDI spectra was also evaluated and the feasibility of the collection method was finally demonstrated with a mixture of four standard proteins.     

New cationic group 4 metal alkyl complexes

Cationic group 4 metal alkyl complexes containing tetradentate Schiff base ligands, (acen) Zr(R)⁺ and (F6-acen) Zr(R)⁺, are prepared by protonolysis of suitable neutral dialkyl precursors. These complexes display electrophilic behavior and are moderately active ethylene polymerization catalysts in the presence of 1 molar equivalent of AlR₃.     

On-line isotachophoretic sample focusing for loadability enhancement in capillary electrochromatography-mass spectrometry

The use of isotachophoretic (ITP) sample focusing to improve the detection limits for the analysis of charged compounds in capillary electrochromatography (CEC) is described. A coupled-column set-up was used with a 220-microm inner diameter capillary, in which counterflow ITP focusing was performed, connected via a T-junction to a 75-microm inner diameter CEC capillary. As is illustrated, the use of ITP focusing resulted in a dramatic reduction of the sample concentration detection limits. To demonstrate the performance of the ITP-CEC combination, several cationic low-molecular mass compounds in a plasma and urine matrix are analysed using UV-absorbance and mass spectrometric detection. A linear calibration curve was constructed over three decades and detection limits in the low nmol/l range were found for academic samples, using UV-absorbance detection.     

In-line coupling of low-pressure short capillary electrochromatography columns to electrospray ionisation mass spectrometry

A new in-house designed and constructed injection valve for capillary electrochromatography (CEC) based on a rotating injection part with compartments for the eluent as well as for the sample has been coupled to a mass spectrometer via a sheath flow electrospray ionisation (ESI) interface, using short capillary columns of 15 cm length. The CEC columns were packed with 3 microm C(18) bonded silica particles, and a mixture of peptides was analysed using an ammonium acetate/acetonitrile eluent. A significant increase in the signal-to-noise ratio was obtained when the peptides were dissolved in water with the same content of organic modifier as in the eluent with an addition of 0.5% (v/v) acetic acid. When the CEC analysis was performed without any additional pressure, the separation current sometimes dropped tremendously due to bubble formation, caused by different permeability in the first and packed part of the column causing an extremely low electroosmotic flow. The separation current was restored to its original value by applying only 7 bar at the inlet of the CEC column, and the separation performance for the test peptides was recovered. A comparison of the CEC performance of peptides in pure CEC mode and in low-pressure CEC mode is reported.