Decay and regularity for dispersive equations with constant coefficients

This article discusses some smoothing estimates of the initial value problem for dispersive equations with constant coefficients. In particular, it is shown that a certain condition for the principal part of the symbol (see the assumption (1.3) below, which is equivalent to the one “of principal type” in the paper by Ben-Artzi and Devinatz [2]) is necessary and sufficient for the maximal smoothing in space-time. Dedicated to Professor Norio Shimakura The author was supported in part by Grant-in-Aid for Scientific Research, Ministry of Education, Culture, Sports, Science and Technology, Japan (No. 13640187).     

Effect of Ru crystal orientation on the adhesion characteristics of Cu for ultra-large scale integration interconnects

The adhesion of Cu on Ru substrates with different crystal orientations was evaluated. The crystal orientation of sputter deposited Ru could be changed from (1 0 0) to (0 0 1) by annealing at 650 °C for 20 min. The adhesion of Cu was evaluated by the degree of Cu agglomeration on Ru. Cu films on annealed Ru films with the (0 0 1) crystal orientation showed 28% lower RMS values and 50% lower Ru surface coverage than Cu as-deposited on Ru having the (1 0 0) crystal orientation after annealing at 550 °C for 30 min, which suggest that Cu wettability on the Ru(0 0 1) was better than that on the Ru(1 0 0) plane. The low lattice misfit of 4% between Cu(1 1 1) and Ru(0 0 1) may be the reason for this good adhesion property.     

Viscoelasticity and birefringence of polyisoprene

The complex Young's modulus, E^*(ω), and the complex strain-optical coefficient, O^*(ω), which is the ratio of the birefringence to the strain, were measured for polyisoprene (PIP) over a frequency range of 1 ～ 130 Hz and a temperature range of 22 ～ ?100°C. The imaginary part of O^*, O″, was positive at low frequencies and negative at high frequencies. The real part, O′, was always positive and showed a maximum. The complicated behavior of O^* could be understood by the assumption that E^* = E_R^* + E_G^* and O^* = C_RE_R^* + C_GE_G^*, where E_R^* and E_G^* were complex quantities and C_R and C_G were constants. The C_R value, equal to the ordinary stress-optical coefficient measured in the rubbery plateau zone, was 2.0 × 10^?9 Pa^?1. The C_G value, defined as the ratio O″/E″ in the glassy zone, was ?1.1 × 10^?11 Pa^?1. The E_G^*, which was the major component of E^* in the glassy zone, showed almost the same frequency dependence as that of polystyrene and polycarbonate. The E_R^*, which was dominant in the rubbery zone, was described well by the bead-spring theory. The temperature dependence of the E_G^* was stronger than that of the E_R^*. This difference caused the breakdown of the thermorheological simplicity for E^* and O^* around the glass-to-rubber transition zone. © 1995 John Wiley & Sons, Inc.     

Gelation with N-lauroyl-L-glutamic-α,γ-dibutylamide for liquid scintillation counting of low specific activities of35S and32P

A gelling agent, N-lauroyl-L-glutamic-,-dibutylamide, was applied for liquid scintillation counting of inorganic³²P and³⁵S. The gel with toluene cocktail is transparent and rigid for a long time. Several grams of ammonium magnesium phosphate or barium sulfate can easily be measured without complicating procedures.     

Isotachophoretic determination of mobility and pKa by means of computer simulation : V. Evaluation of mo and pKa of twenty-eight dipeptides and assessment of separability

Isotachophoretic qualitative indices, R_E, for twenty-eight dipeptides were measured in the range pH 7.4–9.6. The absolute mobility, m_o, and pK_a values were evaluated by the use of the least-squares method, utilizing a simulation of the isotachophoretic steady state. The m_o values were newly evaluated and the pK_a values were in good agreement with literature values. By comparison of the evaluated m_o and pK_a values of the dipeptides with those of the constituent amino acids, simple relationships were found which may be used to estimate the m_o and pK_a values of other dipeptides. The separability of the dipeptides was also evaluated by considering the differences between their simulated effective mobilities. It is concluded that isotachophoresis is very convenient for the separation of dipeptides and their constituent amino acids.     

Rheology of polystyrene solutions around the coil overlapping concentration: A phenomenological description of stresses in simple shear flow

Linear viscoelasticity behavior is described with the sum of two terms for polystyrene solutions in tricresyl phosphate around the coil overlapping concentration (K. Osaki, T. Inoue, & T. Uematsu, J Polym Sci Part B: Polym Phys 2001, 39, 211). One is a Rouse–Zimm (RZ) term represented by the Zimm theory with arbitrarily chosen values of the hydrodynamic interaction parameter and the longest relaxation time (τ_RZ). The other (the L term) consists of a relaxation mode with a single relaxation time (τ_L > τ_RZ) and a high‐frequency limiting modulus proportional to the square of the concentration. In this study, we describe the viscosity (η) and first normal stress coefficient (Ψ₁) in steady shear with simple formulas. The stress due to the L term is assumed to be given by a Kaye, Bernstein, Kearsley, and Zapas (K‐BKZ) equation with the damping function h(γ) = (1 + 0.2γ²)^?1/2, where γ is the magnitude of shear. Contributions to η and Ψ₁ from the RZ term are derived from the RZ model, in which the relaxation time in steady flow is given by τ_st = τ + (τ_RZ ? τ)/(1 + 0.35τ_RZ γ˙) instead of τ_RZ. Here, γ˙ is the rate of shear, and τ is the τ_RZ value at the infinite dilution limit. η and Ψ₁ at various concentrations for two polystyrene samples (with molecular weights of 2890 and 8420 kg mol^?1) are well described with parameters derived from dynamic viscoelasticity. © 2002 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 40: 1038–1045, 2002     

Novel method to control release of lipophilic drugs with high potency from silicone

Silicone has been utilized as a carrier material for sustained release system of lipophilic drugs. Extensive studies revealed that drug release rate is influenced by factors such as physicochemical properties of the drug and additives.(1-5)) When a lipophilic drug is highly potent at low concentrations, the drug release rate should be strictly controlled so as to avoid side effects. In this study, using vitamin D(3) (VD(3)) as an example of such drugs, we investigated novel method to suppress initial burst and to modify drug release rate from silicone matrix. As a result, it was found that (a). addition of human serum albumin (HSA) suppressed initial burst and enhanced release rate in the later stage, resulting constant release of VD(3), (b). covering a matrix formulation with a membrane of low diffusivity (core-rod formulation) suppressed initial burst and released drug in a constant rate, and (3) using materials for which the drug has high affinity as dissolution solvent (reservoir formulation), the drug release rate was reduced.     

Singlet Oxygen–mediated Hydroxyl Radical Production in the Presence of Phenols: Whether DMPO–·OH Formation Really Indicates Production of ·OH?¶

The reaction of singlet oxygen (1O2) generated by ultraviolet-A (UVA)-visible light (lambda > 330 nm) irradiation of air-saturated solutions of hematoporphyrin with phenolic compounds in the presence of a spin trap, 5,5-dimethyl-1-pyrroline-N-oxide (DMPO), gave an electron spin resonance (ESR) spectrum characteristic of the DMPO-hydroxyl radical spin adduct (DMPO-*OH). In contrast, the ESR signal of 5,5-dimethyl-2-pyrrolidone-N-oxyl, an oxidative product of DMPO, was observed in the absence of phenolic compounds. The ESR signal of DMPO-*OH decreased in the presence of either a *OH scavenger or a quencher of *O2 and under anaerobic conditions, whereas it increased depending on the concentration of DMPO. These results indicate both 1O2- and DMPO-mediated formation of free *OH during the reaction. When DMPO was replaced with 5-(diethoxyphosphoryl)-5-methyl-1-pyrroline-N-oxide (DEPMPO), no DEPMPO adduct of oxygen radical species was obtained. This suggests that 1O2, as an oxidizing agent, reacts little with DEPMPO, in which a strong electron-withdrawing phosphoryl group increases the oxidation potential of DEPMPO compared with DMPO. A linear correlation between the amounts of DMPO-*OH generated and the oxidation potentials of phenolic compounds was observed, suggesting that the electron-donating properties of phenolic compounds contribute to the appearance of *OH. These observations indicate that 1O2 reacts first with DMPO, and the resulting DMPO-1O2 intermediate is immediately decomposed/reduced to give *OH. Phenolic compounds would participate in this reaction as electron donors but would not contribute to the direct conversion of 1O2 to *OH. Furthermore, DEPMPO did not cause the spin-trapping agent-mediated generation of *OH like DMPO did.     

NMR and MO Studies on the Molecular Structure of a Fluoranthene-Benzene Complex

Summary. Fluoranthene (FA) forms a 1:1 van der Waals complex with benzene in cyclohexane. The ¹H NMR spectrum of this complex shows that the FA moiety in the complex state has five kinds of hydrogen atoms and that the ¹H NMR peaks assigned to the protons attached to the naphthalene skeleton are largely shifted to higher magnetic field on complex formation with benzene. These observations indicate that the complex takes the structure of C_S symmetry, in which the benzene molecule mainly interacts with the electronic system localized on the naphthalene moiety of FA. The present ab initio calculations reproduce well the ¹H NMR spectral shifts mentioned above and the experimentally predicted C_S structure of the complex. According to the PPP calculations for the electronic absorption spectral changes on the complex formation, the FA-benzene complex is considered to take a sandwich type structure.