Synthesis and X-ray analysis of 1-((1S)-phenylethyl)-azetidine-(2R)-piperidinamide

The crystal and molecular structure of a new azetidine-2-carboxylic amide derivative is described. The structure was solved by direct methods and refined by least squares methods toR1=0.0393 for 4264 reflections (withI>2(I)) The structure consists of two independent molecules which are chemically the same with slight differences in geometry. Crystal data: C₁₇H₂₄N₂O, monoclinic, space groupP2₁,a=8.3782(4),b=20.0342(13),c=9.7769(8) Å, =109.687(6)°,V=1545.1(2)ų,Z=4.     

Cyclopropanation reactions with α, β-epoxy diazomethyl ketones and rearrangement of α, β-epoxy cyclopropyl ketones

The cyclopropanation reactions of α, β-epoxy diazomethyl ketones 1 with olefins using Pd(OAc)₂ as catalyst is described. Differently substituted epoxy diazo ketones 1a-1f give with cyclohexene exo-norcarane derivatives. 3, 3-Diphenyloxiranyl-2 diazomethyl ketone 1a reacts with olefins like isobutene, E- and Z- butene-2 to give epoxy cyclopropyl ketones. 3, 3-Diphenyloxiranyl-2 cyclopropyl ketones 2a and 9 undergo two consecutive rearrangement reactions with BF₃ as catalyst. In the first step an epoxide rearrangement of 9 takes place to give β-ketoaldehyde 10, which in a second step rearranges to enolester 12. The latter reaction is most likely restricted to β-ketoaldehydes which have a quaternary α-C atom. A rationale for this unusual reaction has been proposed.     

The way to measure quantitatively full dissolution and crystallization of polyamides in water up to 200 °C and above by DSC

The way to measure quantitatively full dissolution and crystallization of polyamides in water up to 200 °C and above by DSC is described. Stainless-steel high-pressure pans enable research on fully dissolving polyamides in water under vapor pressure. The results show clearly that polyamide 6 (PA6) is soluble in water under vapor pressure in the whole concentration range and that water acts as a crystallization and melting point suppressor. The maximum temperature depression is approximately 60 °C. This depression of the transitions is independent of concentration over a large range (10-70 mass% PA6 in water). When PA6 dissolves in water during heating, the polymer often sets to the sides of the DSC sample pan. Because of this the contact between the sample and the bottom of the pan reduces during measurement and therefore DSC heating curves are frequently curved. Adding steel wool to these stainless-steel high-pressure pans improves the measurements by increasing the thermal conductivity between the sample and pan bottom, and as a result the DSC curves become less curved. The interpretation of the measurements improves and the possibility of reproducible peak area calculations also in heating comes in sight.     

Materials,Furnaces, and Texts: How to Write About Making Glass Colours in the Seventeenth Century

Johann Kunckel's Ars Vitraria Experimentalis (1679) is arguably the most important text on seventeenth-century glassmaking. As an augmented German translation of Italian (1612) and English (1662) editions, Kunckel presented a complex and layered text that contained a plethora of recipes, elaborate commentaries and annotations, and various appendices dealing with glass-related technologies and arts. We reworked four recipes for rosichiero glass (a transparent red glass) in Kunckel's book to discover what strategies Kunckel employed to help readers engage with the recipes and to make the recipes work in the specificity of their own workshop. We learned that Kunckel regularly neglected to test the Italian recipes, and that not all of his corrections are improvements, thereby specifying our understanding of the “codification of error” as a strategy to write down colour-making knowledge. Instead, Kunckel made the choice to educate his readers on the very mechanisms of glass colouring to allow them to intervene to influence the colour of the glass and to gain further control over the making process. He argued that the colour of glass is sensitive to the manner in which ingredients are sourced and processed, and emphasised the importance of furnace management in optimising the colour of glass.     

Solubility behavior of amphiphilic block and random copolymers based on 2‐ethyl‐2‐oxazoline and 2‐nonyl‐2‐oxazoline in binary water–ethanol mixtures

The solution properties of random and block copolymers based on 2‐ethyl‐2‐oxazoline (EtOx) and 2‐nonyl‐2‐oxazoline (NonOx) were investigated in binary solvent mixtures ranging from pure water to pure ethanol. The solubility phase diagrams for the random and block copolymers revealed solubility (after heating), insolubility, dispersions, micellization as well as lower critical solution temperature (LCST) and upper critical solution temperature behavior. The random and block copolymers containing over 60 mol % pNonOx were found to be solubilized in ethanol upon heating, whereas the dissolution temperature of the block copolymers was found to be much higher than for the random copolymers due to the higher extent of crystallinity. Furthermore, the block copolymer containing 10 mol % pNonOx exhibited a LCST in aqueous solution at 68.7 °C, whereas the LCST for the random copolymer was found to be only 20.8 °C based on the formation of hydrophobic microdomains in the block copolymer. The random copolymer displayed a small increase in LCST up to a solvent mixture of 9 wt % EtOH, whereas further increase of ethanol led to a decrease in LCST, which is probably due to the “water‐breaking” effect causing an increased attraction between ethanol and the hydrophobic part of the copolymer. In addition, the EtOx‐NonOx block copolymers revealed the formation of micelles and dynamic light scattering demonstrated that the micellar size is increasing with increasing the ethanol content due to the enhanced solubility of EtOx. © 2008 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 47: 515–522, 2009     

Ultrafast and bias-free all-optical wavelength conversion using III-V-on-silicon technology

Using a 7.5 μm diameter disk fabricated with III-V-on-silicon fabrication technology, we demonstrate bias-free all-optical wavelength conversion for non-return-to-zero on-off keyed pseudorandom bit sequence (PRBS) data at the speed of 10 Gbits/s with an extinction ratio of more than 12 dB. The working principle of such a wavelength converter is based on free-carrier-induced refractive index modulation in a pump-probe configuration. We believe it to be the first bias-free on-chip demonstration of all-optical wavelength conversion using PRBS data. All-optical gating measurements in the pump-probe configuration with the same device have revealed that it is possible to achieve wavelength conversion beyond 20 Gbits/s.     

Liquid-crystal phase equilibria of Lennard-Jones chains

Liquid-crystal phase equilibria of Lennard-Jones chain fluids and the solubility of a Lennard-Jones gas in the coexisting phases are calculated from Monte Carlo simulations. Direct phase equilibria calculations are performed using an expanded formulation of the Gibbs ensemble. Monomer densities, order parameters, and equilibrium pressures are reported for the coexisting isotropic and nematic phases of: (1) linear Lennard-Jones chains, (2) a partially-flexible Lennard-Jones chain, and (3) a binary mixture of linear Lennard-Jones chains. The effect of chain length is determined by calculating the isotropic-nematic coexistence of linear Lennard-Jones chain fluids made of 8, 10, and 12 segments (8-, 10-, 12-mer). The effect of molecular flexibility on the isotropic-nematic equilibrium is studied for a Lennard-Jones 10-mer chain fluid with one freely-jointed segment at the end of the chain. An isotropic-nematic phase split and fractionation are reported for a binary mixture of linear 7-mer and 12-mer chains. Simulation results are compared with theoretical results as obtained from a recently developed analytical equation of state based on perturbation theory. Excellent agreement between theory and simulations is observed. The solubility of a monomer Lennard-Jones gas in the coexisting isotropic and nematic phases is estimated using the Widom test-particle insertion method. A linear relationship between solubility difference and density difference at isotropic-nematic coexistence is observed. It is shown that gas solubility is independent of the nematic ordering of the fluid, at constant temperature and density conditions.     

Use of engineered unique cysteine residues to facilitate oriented coupling of proteins directly to a gold substrate

A prerequisite for any "lab on a chip" device that utilizes an electrical signal from the sensor protein is the ability to attach the protein in a specific orientation onto a conducting substrate. Here, we demonstrate the covalent attachment to a gold surface of light-harvesting membrane proteins, from Rhodobacter sphaeroides, via cysteine (Cys) residues engineered on either the cytoplasmic or periplasmic face. This simple directed attachment is superior in its ability to retain light-harvesting complex (LHC) function, when compared to a similar attachment procedure utilizing a self-assembled monolayer on gold. LH 1 has previously been observed to have superior photostability over LH 2 (Magis et al. [2010] Biochim. Biophys. Acta, 1798, 637-645); this characteristic is maintained even with the introduction of Cys residues.