An AFM, XPS and electrochemical study of molecular electroactive monolayers formed by wet chemistry functionalization of H-terminated Si(1 0 0) with vinylferrocene

Molecular electroactive monolayers have been produced from vinylferrocene (VFC) via light-assisted surface anchoring to H-terminated n- and p-Si(1 0 0) wafers prepared via wet chemistry, in a controlled atmosphere. The resulting Si-C bound hybrids have been characterized by means of XPS and AFM. Their performance as semiconductor functionalized electrodes and their surface composition have been followed by combining electrochemical and XPS measurements on the same samples, before and after use in an electrochemical cell. White-light photoactivated anchoring at short (1 h) exposure times has resulted in a mild route, with a very limited impact on the initial quality of the silicon substrate. In fact, the functionalized Si surface results negligibly oxidized, and the C/Fe atomic ratio is close to the value expected for the pure molecular species. The VFC/Si hybrids can be described as (η⁵-C₅H₅)Fe²⁺(η⁵-C₅H₄)-CH₂-CH₂-Si species, on the basis of XPS results. Electrochemical methods have been applied in order to investigate the role played by a robust, covalent Si-C anchoring mode towards substrate-molecule electronic communication, a crucial issue for a perspective development of molecular electronics devices. The response found from cyclic voltammograms for p-Si(1 0 0) functionalized electrodes, run in the dark and under illumination, has shown that the electron transfer is not limited by the number of charge carriers, confirming the occurrence of electron transfer via the Si valence band. The hybrids have shown a noticeable electrochemical stability and reversibility under cyclic voltammetry (cv), and the trend in peak current intensity vs. the scan rate was linear. The molecule-Si bond is preserved even after thousands of voltammetric cycles, although the surface coverage, evaluated from cv and XPS, decreases in the same sequence. An increasingly larger surface concentration of Fe³⁺ at the expenses of Fe²⁺ redox centers has been found at increasing number of cv’s, experimentally associated with the growth of silicon oxide. Surface SiO⁻ groups from deprotonated silanol termination, induced by the electrochemical treatments, are proposed as the associated counterions for the Fe³⁺ species. They could be responsible for the observed decrease in the electron transfer rate constant with electrode ageing.     

Nonlinear-optical and micro-Raman diagnostics of thin films and nanostructures of ABO3 ferroelectrics

Ferroelectric composite two-dimensional ferroelectric/aluminum oxide nanostructures were studied. A porous aluminum oxide matrix was used as a template into which a ferroelectric precursor was introduced, followed by annealing. The prepared nanostructures were studied using optical second harmonic generation and micro-Raman scattering.     

DRIFTS study of surface reactivity to NO2 by zinc nanoparticle aggregates and zinc hollow nanofibers

Zinc nanostructures synthesized with different morphologies from the same evaporation/condensation technique are studied with concern to surface reactivity to NO₂ by Diffuse Reflectance Infrared Fourier Transformed Spectroscopy (DRIFTS). Synthesis of nanopowders is obtained, according to previous work, by gas flow thermal evaporation at 540 °C of bulk Zn grains. Two types of Zn powders are obtained and studied in experiments. The first one is collected on the cold walls of the reactor as a deposit produced by thermophoretic effect. It is constituted by grains (∼10 μm) originated by the stratification of smaller aggregates (∼200 nm) and isolated primary particles (∼50 nm) born in the gas flow. The second type of powder is grown from the condensation of Zn chemical vapors within the expansion orifice of the quartz reactor after relatively long time (∼1 h) deposition process. It is constituted mainly by hollow Zn nanofibers with external and internal diameter about 100 and 60 nm. Preliminary characterization of the two types of powders is made by SEM, TEM, XRD. Thereafter, the two types of samples are studied by DRIFTS at variable temperature (VT). Comparison is made between the home-synthesized nanopowders with respect to commercial Zn standard dust. The Zn hollow nanofibers when exposed to NO₂ are found to exhibit dramatic reactivity, which is not observed at all either in the case of clustered aggregate zinc or of commercial Zn dust powders. Results indicate that, at increasing temperature from RT to 300 °C, the hollow nanofibers surface reacts distinctively with adsorbant gas NO₂, with contemporary formation of a progressively growing narrow absorption band at 2500 cm⁻¹ and contemporary depression of a doublet (∼1600-1628 cm⁻¹) band. In order to justify this striking spectral feature, we propose the occurring of a possible polymerization process at nanofibers surface where most probably as a consequence of pre-treatment and exposure to gas NO₂ a very thin film of ZnO is formed. The possible role of huge specific surface of hollow nanofibers as inferred by preliminary SEM, TEM, XRD studies is discussed.     

Influence of Cyclodextrin Complexation on the in vitro Human Skin Penetration and Retention of the Sunscreen Agent, Oxybenzone

The objective of this study was to investigate the influence of cyclodextrins on the cutaneous availability of the sunscreen oxybenzone. The interaction between oxybenzone and hydrophilic α-, β- and γ-cyclodextrin derivatives was studied in water by phase-solubility analysis. Among the available cyclodextrins, hydroxypropyl-β-cyclodextrin (HP-β-CD) and especially sulfobutylether-β-cyclodextrin (SBE-β-CD) had the greatest solubilizing activity. Ethanol–water solutions containing oxybenzone free or complexed with HP-β-CD or SBE-β-CD were applied to human skin in Franz diffusion cells and the amount of sunscreen permeated into the different cutaneous compartments was determined by HPLC. As much as 20.5% of the oxybenzone applied dose diffused within the skin tissue after 6 h application. Between 39.4% and 54.9% of the penetrated UV filter was localized in the stratum corneum, with no significant difference between uncomplexed oxybenzone or its complex with HP-β-CD. Conversely, the amount retained in the stratum corneum was markedly decreased (ca. 50%) by complexation with SBE-β-CD. Considerable quantities of oxybenzone accumulated into the viable epidermis (5.7% of the applied dose) and dermis (6.2% of the applied dose) from the preparation containing the free UV filter. The sunscreen penetration to the deeper living layers of the skin was remarkably lower (1.0% and 2.0% of applied dose for epidermis and dermis, respectively) upon application of the sunscreen complexed with SBE-β-CD, whereas HP-β-CD had no effect. In addition, photostability experiments demonstrated that SBE-β-CD complexation did not alter the sunscreen photochemical properties.     

Rejuvenating old computerized spectrometric instrumentation: discussion of two case histories

Computerized analytical instruments of late 70's and 80's are facing rapid technological obsolescence, although they are often retaining good analytical performances. Responsibility is to be attributed to the fast advance in computer technology, which is leaving little or no back-compatibility with old standards and data formats. Rejuvenation may be reached by simple hardware and software modifications, to allow data exchange with modern PC's and LIMS. Two typical case histories for spectrometric instrumentation of late 70's are then presented and discussed in a general fashion.     

Two-proton correlations in the target fragmentation region of nuclear collisions at 200A GeV

Correlations between protons are studied in the target fragmentation region of reactions of protons and¹⁶O with C, Cu, Ag, Au and of³²S with Al and Au at 200A GeV. The emitted protons were measured with the Plastic Ball detector in the WA80 experiment at the CERN SPS. The comparison of the correlation function with calculations, assuming a spherical, gaussian shaped source with a lifetime τ=0 fm/c, allows the extraction of radius parameters. The values are very close to those expected from the geometry of the target nuclei and increase with the target mass as αA _Target ^1/3 . Even in proton induced reactions the whole target nucleus is involved. The dependence of the radii on centrality, polar angleθ _lab, and energy, and their relation to measured proton yields are presented.     

(η3‐Allyl‐2κ3C)(chloro‐1κCl)(μ‐N,N′‐diethyldithioxamidato‐1:2κ4S,S′:N,N′)[diphenyl(2‐pyridyl)phosphine‐1κP]palladium(II)platinum(II) chloroform solvate

The title compound, [PdPtCl(C₃H₅)(C₆H₁₀N₂S₂)(C₁₇H₁₄NP)]·CHCl₃, was obtained by deprotonation of the initial platinum(II) complex of the di­thio­xamide and subsequent reaction with [Pd(η³‐C₃H₅)(μ‐Cl)]₂. Both metal atoms exhibit a square‐planar coordination geometry, with the two planes forming a dihedral angle of 21.7 (2)°. The di­thio­xamide bis‐chelating bridge is flat.     

Trinuclear heterobimetallic complexes with binucleating dithioxamides: stereoselective synthesis and solution behavior involving Pd-N bond rupture

Bischelate platinum(II) complexes of the type [Pt(H-R(2)-N(2)C(2)S(2))(2)] (H-R(2)-N(2)C(2)S(2)(-) = dialkyl-dithioxamidate) are ditopic receptors which, after coordination of the first Pd(eta(3)-allyl)(+) moiety, induce the orientation of the second palladium-allyl fragment. Thus, a series of trimetallic complexes of formula bis-[(eta(3)-allyl)-palladium(II)](mu-bis-dialkyl-dithioxamidate-platinum(II) kappa-S,S-kappa-S',S'-Pt-kappa-N,N-Pd-kappa-N',N'-Pd') has been prepared in which the allyl fragments are oriented toward the same side of the molecular plane. We have also prepared the trimetallic complex using a dithioxamide obtained from the racemic phenylethylamine. Only two isomers were produced in equimolar ratio: the racemate that has four homochiral alkyl substituents and the mesoform containing the meso-dithioxamide that has homochiral substituents on the same side of molecular plane. Under the effect of the temperature, the trimetallic Pd-Pt-Pd complexes undergo rapid allyl isomerization; the mechanism of the isomerization, which is similar to that found by us in an analogue Pt-Pd bimetallic complex, is discussed. The crystal and molecular structure of bis-[(eta(3)-allyl)-palladium(II)](mu-bis-[S]-phenylethyl-dithioxamidate-platinum(II) kappa-S,S-kappa-S',S'-Pt-kappa-N,N-Pd-kappa-N',N'-Pd') has been reported.     

Derivatives of 2,3‐dihydroimidazo[1,5,4‐ef][1,2,5]‐benzothiadiazepin‐6(4h,7h)‐thione 1,1‐dioxide,a new heterocyclic system related to tibo

The synthesis of derivatives of 2,3‐dihydroimidazo[1,5,4‐ef][1,2,5]benzothiadiazepin‐6(4H,7H)‐thione 1,1‐dioxide is reported starting from N‐substituted ethyl 2‐(5‐chloro‐2‐nitrobenzenesulfonamido)‐2‐alkyl‐acetates. Fundamental steps of the synthetic pathway were: i) intramolecular cyclization of N‐substituted 2‐(2‐amino‐5‐chlorobenzenesulfonamido)‐2‐alkylacetic acids in the presence of N‐(3‐dimethyl‐aminopropyl)‐N′‐ethyl carbodiimide hydrochloride‐N,N‐dimethylaminopyridine complex; ii) building of imidazole ring from 2‐alkyl‐8‐chloro‐2,3‐dihydro‐3‐methyl‐1,2,5‐benzothiadiazepin‐4(5H)‐one 1,1‐dioxide to achieve 2‐alkyl‐9‐chloro‐2,3‐dihydro‐3‐methylimidazo[1,5,4‐ef][1,2,5]benzothiadiazepin‐6(4H,7H)‐one 1,1‐dioxide; iii) preparation of thiocarbonyl derivative by treatment with Lawesson's reagent. Introduction of a 3‐methyl‐2‐butenyl chain at position 2 of above imidazobenzothiadiazepinone required protection at the 7 position with thermally removable tert‐butoxycarbonyl moiety, due to the fact that alkylation of unprotected structure proved to be regioselective for the 7 position.     

Upper limit for thermal direct photon production in heavy-ion collisions at 60 and 200A·GeV

The production of direct photons has been investigated in reactions ofp and¹⁶O projectiles at 60 and 200A·GeV with C and Au nuclei. Photon and ⁰ spectra have been measured in the pseudorapidity range 1.52.1 for the transverse momentum region 0.4 GeV/cp _T 2.8 GeV/c employing the lead-glass spectrometer SAPHIR. An upper limit of 15% at the 90% confidence level for the direct photon signal relative to the neutral pion production is obtained from the comparison of measured photon spectra with Monte Carlo simulations of the hadronic background based on the reconstructed yield of ⁰ and mesons. Consequences for a possible phase transition to a quark-gluon plasma are discussed.