Simultaneous determination of metal ion concentrations in binary mixtures with a multi-LED photometer

 A compact photometer is based on up to seven different light-emitting diodes whose light is guided into a photometric cell by means of a fibre-optic coupler. The wavelength is selected by switching on the appropriate light source. The application of this multi-wavelength photometer to the determination of binary metal ion samples is demonstrated using model mixtures. Solutions of Fe, Co, Cu, Ni, Cr and Mn were used in combination with several photometric reagents. It was found that the instrument yielded concentration measurements which were usually within a few percent of the correct concentration. These results are comparable to reported data obtained with conventional instruments for similar measurements. The application of the instrument for simultaneous determination in flow-injection analysis employing rapid computer controlled switching of the light-emitting diodes is also demonstrated. A limitation in the use of light-emitting diodes for the simultaneous determination was found to arise from the fact that in some instances non-linear calibration curves are obtained when employing light-emitting diodes as light sources. This occurs when the absorptivity of the measured compound changes over the emission band of the diodes. Multiple regression analysis is then not easily possible. Received: 16 September 1996/Revised: 14 October 1996/Accepted: 16 October 1996     

A multi-wavelength photometer based on light-emitting diodes

The light originating from seven light-emitting diodes of different colours is guided, one at a time, into a measuring cell by means of a fibre optic coupler. Detection is carried out with photodiodes which are connected to a log-ratio amplifier yielding direct absorbance readings. Optical filters are used to narrow the emission band from blue light emitting diodes as these bands are relatively wide compared to those of the emitters of other colours. An inexpensive and compact multi-wavelength photometer covering the visible range is thus obtained, which in many cases can replace a conventional spectrophotometer for absorbance measurements. The performance for a range of commonly used photometric analytical procedures is described and compared to conventional measurements with a spectrophotometer.     

Electronic excitations during grazing scattering of hydrogen atoms on KI(001) and LiF(001) surfaces

The energy loss of hydrogen atoms with energies of 400 eV and 1 keV is studied in coincidence with the number of emitted electrons during grazing scattering from atomically clean and flat KI(001) and LiF(001) surfaces. The energy loss spectra for specific numbers of emitted electrons are analyzed in terms of a binary interaction model based on the formation of transient negative ions via local capture of valence band electrons from anion sites. Based on computer simulations we derive for this interaction scenario probabilities for the production of surface excitons, for electron loss to the conduction band of KI, for emission of electrons, and for formation of negative hydrogen ions. The pronounced differences of data obtained for the two surfaces are attributed to the different electronic structures of KI and LiF.     

14.5GHz紧凑型、低成本、全永磁ECR离子源

A compact 14.5GHz electron cyclotron resonance (ECR) ion source for the production of slow, multiply charged ions has been constructed,with the plasma-confining magnetic field produced exclusively by permanent magnets.Microwave power of up to 175W in the frequency range from 12.75 to 14.SGHz is transmitted from ground potential via a PTFE window into the water-cooled plasma chamber which can be equipped with an aluminum liner.The waveguide coupling system serves also as biased electrode,and two remotely-controlled gas inlet valves connected via an insulating break permit plasma operation in the gas- mixing mode.A triode extraction system sustains ion acceleration voltages between 1kV and 10kV.The ECR ion source is fully computer-controlled and can be remotely operated from any desired location via Ethernet.     

Aggregation and dissolution of 4 nm ZnO nanoparticles in aqueous environments: influence of pH, ionic strength, size, and adsorption of humic acid

Metal oxide nanoparticles are used in a wide range of commercial products, leading to an increased interest in the behavior of these materials in the aquatic environment. The current study focuses on the stability of some of the smallest ZnO nanomaterials, 4 ± 1 nm in diameter nanoparticles, in aqueous solutions as a function of pH and ionic strength as well as upon the adsorption of humic acid. Measurements of nanoparticle aggregation due to attractive particle-particle interactions show that ionic strength, pH, and adsorption of humic acid affect the aggregation of ZnO nanoparticles in aqueous solutions, which are consistent with the trends expected from Derjaguin-Landau-Verwey-Overbeek (DLVO) theory. Measurements of nanoparticle dissolution at both low and high pH show that zinc ions can be released into the aqueous phase and that humic acid under certain, but not all, conditions can increase Zn(2+)(aq) concentrations. Comparison of the dissolution of ZnO nanoparticles of different nanoparticle diameters, including those near 15 and 240 nm, shows that the smallest nanoparticles dissolve more readily. Although qualitatively this enhancement in dissolution can be predicted by classical thermodynamics, quantitatively it does not describe the dissolution behavior very well.     

Simultaneous determination of metal ion concentrations in binary mixtures with a multi-LED photometer

 A compact photometer is based on up to seven different light-emitting diodes whose light is guided into a photometric cell by means of a fibre-optic coupler. The wavelength is selected by switching on the appropriate light source. The application of this multi-wavelength photometer to the determination of binary metal ion samples is demonstrated using model mixtures. Solutions of Fe, Co, Cu, Ni, Cr and Mn were used in combination with several photometric reagents. It was found that the instrument yielded concentration measurements which were usually within a few percent of the correct concentration. These results are comparable to reported data obtained with conventional instruments for similar measurements. The application of the instrument for simultaneous determination in flow-injection analysis employing rapid computer controlled switching of the light-emitting diodes is also demonstrated. A limitation in the use of light-emitting diodes for the simultaneous determination was found to arise from the fact that in some instances non-linear calibration curves are obtained when employing light-emitting diodes as light sources. This occurs when the absorptivity of the measured compound changes over the emission band of the diodes. Multiple regression analysis is then not easily possible. Received: 16 September 1996/Revised: 14 October 1996/Accepted: 16 October 1996     

Determination of arsenic by pervaporation-flow injection hydride generation and permanganate spectrophotometric detection

A novel pervaporation-flow injection (PFI) system for the determination of As(III) in aqueous samples at μg l⁻¹ level is described. The analytical procedure involved stopping the acceptor stream and injecting acidified As(III) samples into a 0.3 M HCl stream which was mixed with a 0.14 M sodium borohydride in 0.025 M NaOH stream. The arsine generated was transported in the pervaporation unit across a semi-permeable membrane (1.5 mm thickness) into the static acceptor solution containing 1.0×10⁻⁴ M KMnO₄ in 0.1 M H₂SO₄ where it was oxidised. The acceptor stream was restarted after 6.5 min, and the decrease in permanganate absorbance at 528 nm was monitored to determine the initial concentration of As(III) in the samples. The method is characterised by a linear calibration range from 0.25 to 2000 μg l⁻¹, a detection limit of 0.18 μg l⁻¹ and a sampling frequency of 7 h⁻¹. Samples containing As(V) were pre-treated with KI and HCl prior to injection to reduce As(V) to As(III). The effects of common anionic and cationic interferences, and the elimination of some metallic interferences using -cysteine are discussed. The method was applied to the analysis of environmental waters and the results were in good agreement with hydride generation atomic absorption spectrometric data.     

Ultra-sonication-assisted solvent extraction of quercetin glycosides from 'Idared' apple peels

Quercetin and quercetin glycosides are physiologically active flavonol molecules that have been attributed numerous health benefits. Recovery of such molecules from plant matrices depends on a variety of factors including polarity of the extraction solvent. Among the solvents of a wide range of dielectric constants, methanol recovered the most quercetin and its glycosides from dehydrated 'Idared' apple peels. When ultra-sonication was employed to facilitate the extraction, exposure of 15 min of ultrasound wavelengths of dehydrated apple peel powder in 80% to 100% (v/v) methanol in 1:50 (w:v) solid to solvent ratio provided the optimum extraction conditions for quercetin and its glycosides. Acidification of extraction solvent with 0.1% (v/v) or higher concentrations of HCl led to hydrolysis of naturally occurring quercetin glycosides into the aglycone as an extraction artifact.