The Discounted Limit Theorems

The large deviation theorems, exponential inequalities and a non-uniform estimate of the Berry–Esséen theorem in a discounted version are proved.Dedicated to Professor Vytautas Statulevičius on the occasion of his 75th birthday.     

Discrete limit theorems for general Dirichlet series. III

Here we prove a limit theorem in the sense of the weak convergence of probability measures in the space of meromorphic functions for a general Dirichlet series. The explicit form of the limit measure in this theorem is given. Partially supported by Lithuanian Foundation of Studies and Science     

Application of cosmogenic radionuclides in ozone tracer studies

Downward flux of stratospheric ozone contributes to the near ground level ozone concentrations. The intensity, amount of vertical ozone flow can be evaluated by the ratio of two cosmogenic radionuclides (³³P/³²P, ⁷Be/³²P). Some examples presented in this paper are demonstrating the possibilities of this method. The application of tracer method makes evident the seasonal variations (with maxima during the spring — summer months and minima during winter) of the amount of stratospheric ozone in the ground air. Average monthly contribution from stratospheric ozone in the lower level of the atmosphere ranged from 0 to 18% in 1998–99. During short term intervals (2–3 days) the amount of the stratospheric ozone can increase up to ∼90%.     

Pulse plating effect on microstructure and corrosion properties of Zn–Ni alloy coatings

The influence of pulse plating parameters on the surface morphology, grain size, lattice imperfection and corrosion properties of Zn–Ni alloy has been studied. The coatings were electrodeposited in an alkaline cyanide-free solution. AFM was applied for surface morphology examination, XRD measurements were carried out for phase composition and texture analysis, electron probe microanalysis was used for alloy chemical composition studies, while electrochemical techniques were applied for corrosion performance evaluation. The pulse plated Zn–Ni coatings appeared to consist of the γ-Zn₂₁Ni₅ phase and the composition of the alloy depended on the plating parameters. The grain size, lattice imperfection and homogeneity of grain distribution were established to be the main factors determining corrosion behaviour of the coating. Presented at the 4th Baltic Conference on Electrochemistry, Greifswald, March 13–16, 2005     

Estimation scheme for level-dependent uncertainty of analytical result: application for determination of 1-hydroxypyrene in urine

The estimation scheme of uncertainty of determination of 1-hydroxypyrene (1-OHP) in urine was developed analysing the main stages of the analytical procedure: (1) preparation of 1-OHP standards, (2) creation of the calibration curve for the high performance liquid chromatography (HPLC) analysis method with the evaluation of recovery, (3) measuring procedure of aliquot of urine, (4) adjusting the pH of aliquot and hydrolysis with enzyme, (5) solid phase extraction, (6) concentration of the extract, (7) injection of the extract to chromatograph and analysing by the HPLC method, (8) calculation of 1-OHP mass from the calibration curve, (9) calculation of 1-OHP concentration in urine. The evaluation of the uncertainty is based on quantification of individual components. Combined uncertainty was calculated using the law of propagation of uncertainties according to the EURACHEM/CITAC guidelines. Level dependence of the uncertainty arises from the calibration curve. The limits of detection and quantification were found to be equal to 0.03 and 0.1 ng/mL, respectively. The calculated expanded level-dependent uncertainty covers 47–27–25% within the concentration range 0.03–0.1–0.4 ng/mL with the materials and equipment used. These parameters could easily be recalculated according to the proposed scheme if there are some changes in the analysis procedure.     

Monte Carlo study of impact ionization in n-type InAs induced by intense ultrashort terahertz pulses

Electron impact ionization induced in n-type InAs by single-cycle pulses of picosecond and subpicosecond duration has been investigated by Monte Carlo method. It is established that the rate of generation of electron–hole pairs decreases with the decrease of the pulse duration. The impact ionization threshold field is found to depend linearly on frequency for the fields oscillating at frequencies much higher than reciprocal momentum relaxation time. Good agreement between calculations and available experimental data has been obtained.     

Photoelectrochemical properties of MoO2 thin films

Thin MoO₂ films were electrodeposited on a selenium pre-deposited SnO₂|glass plate. The photoelectrochemical properties of MoO₂ films were investigated in 0.1 M Na₂SO₄ solution by the ultraviolet–visible spectrophotometry, linear sweep voltammetry, and altering current impedance measurement techniques. It was found that under illumination with the incident light of λ?=?366 nm, the photo response of the MoO₂|SnO₂|glass electrode resulted from the MoO₂ layer, while the SnO₂ layer served as a sink for photogenerated charge carriers. The MoO₂ film exhibited n-type conductivity. A schematic band structure diagram of MoO₂ in 0.1 M Na₂SO₄ solution was constructed. The flat band potential (E _fb), the donor concentration (N _D), the photogeneration current efficiency depended on MoO₂ film thickness. The [Fe(CN)₆]^4?/3? redox PEC cell with MoO₂|SnO₂|glass plate as a photoanode was constructed. Power output characteristics such as the open circuit voltage (V _OC), short circuit current (I _SC), the fill factor (FF), and the light-to-electrical conversion efficiency (η) were determined. The maximum light-to-electrical conversion efficiency exhibited by the PEC cell was 0.94 %.     

Comparison characterization of copper selenide thin layers prepared on polyamide 6 films by sorption-diffusion method

Some earlier synthesized copper selenide (Cu _x Se) layers formed on the surface of polyamide 6 by sorption-diffusion method using potassium selenotrithionate (K₂SeS₂O₆) as precursor of selenium were characterized by the XRD, XPS and SEM methods. According to the results of the SEM studies, the most uniform Cu _x Se layers form at the 2.5 h polyamide seleniumized duration at the temperature of 60°C. The thickness of layers, which dependeds on the duration of seleniumization, changed in the range of 0.8–3.2 µm. The XRD patterns of not previously studied Cu _x Se layers showed their phase composition of six copper selenides: Cu₂Se, two phases of CuSe₂, Cu₃Se₂, berzellianite, Cu_2-x Se, and bellidoite Cu₂Se. Analysis of the XRD and XPS data shows that the macrostructure and composition of the Cu_xSe layers depend on the conditions of formation of these layers.