(Ni0.8Zn0.2Fe2O4)epoxy-PZT双层膜中的磁电效应

讨论了Ni_0.8Zn_0.2Fe₂O₄ (NZFO)与锆钛酸铅(PZT)的双层膜结构样品的磁电(ME)效应.NZFO粉料由溶胶-凝胶法制成，再经900℃热压，并高温烧结.在该双层膜中测量到了很强的磁电相互作用.发现横向的磁电效应比纵向效应大一个数量级，并且随NZFO烧结温度的提高而增加.当烧结温度从950℃上升到1380℃时，横向ME电压系数(α_E)的最大值变化范围为25.6 mV Am^-2≤α_E≤199.6 mV Am^-2.理论分析显示NZFO-PZT双层膜样品中ME效应源于NZFO与PZT之间相对良好的磁电耦合. 关键词： 镍铁氧体 PZT 热压法 ME效应     

Spectral features of laser induced plasma from YBa2Cu3O7 and GdBa2Cu3O7 highT c superconductors

Laser induced plasma emission spectra from highT _c superconducting samples of YBa₂Cu₃O₇ and GdBa₂Cu₃O₇ obtained with 1.06μm radiation from a Q switched Nd:YAG laser beam has been analysed. The results clearly show the presence of diatomic oxides in addition to ionized species of the constituent metals in the plasma thus produced.     

Thermoplastic poly(ester‐imide)s derived from anhydride‐terminated polyester prepolymer and diisocyanate

The phase‐separation behavior of thermoplastic poly(ester‐imide) [P(E‐I)] multiblock copolymers, (A‐B)_n, was investigated by a stepwise variation of the imide content. All the multiblock copolymers were synthesized by solution polycondensation with dimethylformamide as a solvent. P(E‐I)s were prepared with anhydride‐terminated polyester prepolymer and diisocyanates. Polyester prepolymers were prepared by the reaction of pyromellitic dianhydride and two different polyols [poly(tetramethylene oxide glycol) (PTMG) and polycaprolactone diol (PCL)]. Structural determination was done with Fourier transform infrared spectroscopy and Fourier transform NMR, and the molecular weight was determined by gel permeation chromatography. The effect of the imide content on the thermal properties of the synthesized P(E‐I)s was investigated by thermogravimetric analysis and differential scanning calorimetry. The polymers were also characterized for static and dynamic mechanical properties. Thermal analysis data indicated that the polymers based on PTMG were stable up to 330 °C in nitrogen atmosphere and exhibited phase‐separated morphology. Polymers based on PCL showed multistage decomposition, and the films derived from them were too fragile to be characterized for static and dynamic mechanical properties. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 341–350, 2004     

Membrane introduction mass spectrometry

An overview of membrane introduction mass spectrometry (MIMS) is presented and comparisons are made with other direct sample introduction techniques. Special attention is given to the unique advantages and the limitations of newer variants on the MIMS technique, including affinity MIMS, reverse-phase and trap MIMS. The salient features of the interfaces used in MIMS are summarized and the various membrane materials commonly used are delineated. The applicability of MIMS is illustrated via discussion of

1. (i) bioreactor monitoring (represented by yeast fermentation),

2. (ii) environmental monitoring (illustrated by analysis of contaminated ground water samples) and

3. (iii) on-line chemical reaction monitoring (exemplified by the photolysis of aryl esters).

The applicability of MIMS to the analysis of environmental samples, including complex mixtures in water, air and soil, is noted.     

Fractional diffusion and reflective boundary condition

Scaling analysis of the magnitude series (volatile series) has been proposed recently to identify possible non-linear/multifractal signatures in the given data [Y. Ashkenazy, et al. Phys. Rev. Lett. 86 (2001) 1900; Y. Ashkenazy, et al. Physica A 323 (2003) 19; T. Kalisky, Y. Ashkenazy, S. Havlin. Phys. Rev. E 72 (2005) 011913]. In this article, correlations of volatile series generated from stationary first-order linear feedback process with Gaussian and non-Gaussian innovations are investigated. While volatile correlations corresponding to Gaussian innovations exhibited uncorrelated behavior across all time scales, those of non-Gaussian innovations showed significant deviation from uncorrelated behavior even at large time scales. The results presented raise the intriguing question whether non-Gaussian innovations can be sufficient to realize long-range volatile correlations.     

Vortices in Bose-Einstein condensates: A review of the experimental results

Rotating dilute Bose-Einstein condensates (BEC) of alkali atoms offer a testing ground for theories of vortices in weakly interacting superfluids. In a rotating super-fluid, quantised vortices, with a vorticity h/m, form above a critical velocity. Such vortices have been generated in BEC of alkali atoms by different techniques such as (a) wave function engineering of a two-component BEC, (b) decay of solitons, (c) rotation of a thermal cloud before cooling it below the condensation temperature, (d) stirring with an ‘optical’ spoon, (e) rotating a deformation in the anisotropic trap in which the condensate is trapped and (f) by creating Berry phase by adiabatically reversing the axial magnetic field. Since the core of a vortex is a fraction of a micrometer in diameter, it cannot be directly imaged optically. The condensate with vortices is allowed to ballistically expand till the size increases by one order before the vortices are imaged. Surface wave spectroscopy and the change in aspect ratio of a rotating cloud are the other techniques used. Studies have been made on the creation and dynamics of single vortex and on systems with more than a hundred vortices. Results have been obtained on vortex nucleation, stability of vortex structures, nature of the vortex lattice and defects in such a lattice. Important results are: (a) evidence exists that vortex nucleation takes place by a surface mode instability; but this is not the only mechanism; (b) the vortex lattice is perfectly triangular right up to the edge; (c) in the initial stages of rotation of the cloud a tangled web of vortices is seen; it takes a few hundred milliseconds before the vortices arrange themselves in a lattice; this time appears to be independent of temperature; (d) the decay of vortices appears to arise from the transfer of energy to the rotating thermal component and is dependent on temperature; (e) defects in the lattices such as dislocations and grain boundaries are seen; (f) transverse oscillations (Tkachenko modes) of the vortex lattice have been observed; and (g) giant vortices have been produced. These will be discussed.